Developing Tank for developing 120, 135, black/white and color films. Heat-resistant, watertight and opaque to light..
Two Multi-format self-feed Spiral Reels. Simultaneous rotating and undulating movements of the spirals ensure that the chemical runs uniformly inside the tank, which can be accommodated the 2 rolls of 135/35mm films at a time or 1 roll of 120 film..
Equipped with one Large Graduated Cylinder (21oz) and one Small Graduated Cylinder (2oz).
Includes three Trays that measures 12x10''.
Kit also includes 3 x Tongs (White/Tan/Red), 1 x Stirrer, 2 x clips, 1 x Thermometer, 1 x Squeegee.
Rear Mag wheel 26 inch only with rear width 135mm.
Axle included to the mag wheel;inner diameter of rim:17.5mm/0.689inch;NOTE: It's inevitable that there will be SCRATCHES or PAINT PEELING during transportation, buy carefully if you are concerned..
Compatible with Rotary Single Speed Flywheel.
the hole spacing for front disc brakes of mag wheel to be added is 44mm.
26'' Rear Wheel, aluminum alloy, for normal 26inch bikes and 66/80cc/yd100 26inch motorized bicycle.
the hole spacing for front and rear wheel both 44mm, please see the last picture.
Genuine Honda sealed beam 6V headlight for several small Honda 100-175cc models from the 70's. This high quality part is ready to plug into the stock....
Outer Diameter: Approximately 5.3" (135mm) - Connectors: Dual White Female Bullet / Green Male Bullet / Blue Dual Female Bullet - 6 Volt - 35/25W.
Made in Japan by Stanley - HM-9M-S / FC11H - DOT Approved.
Honda part number: 33120-243-672. Note: Check the photo against your current headlight to make sure the brackets are in the same position. It is not....