Reviews5v Breadboard Power Supply

Dorhea ESP8266 ESP-12 NodeMcu D1 Module WeMos Lua 4M Bytes WLAN WiFi Internet Development Board + Relay Shield + 2.54mm 40Pin Single Row Male Pin Header - 3Set

  • The esp8266 module is 11 digital input / output pins, all pins with interrupt / PWM / I2C / support 1 line (except D0).
  • 1 analog input(3.2V max input). Micro USB connection.
  • WiFi internet development board 5V 1A switching power supply (switching power supply）onboard..
  • 5V relay shield is a digital switch to control much higher voltages and currents than esp8266 mini microcontroller, controlled by the D1 , the relay will switch to allow current to flow or turn off, depending on wiring..
  • 40 pin 0.1inch (2.54mm) male pin header connector PCB board pin strip electronic component, they are easy to be cut to any length if needed, you can cut or score with some electronic tool..
  • The pin header is an ideal connector for the PCB board and intergrated circuit, used widely in the computer and breadboard, compatible with raspberry pi or other electronic project..
Check Stock

HUAREW Breadboard Kit with Power Supply Module， Jumper Wires，Battery Clip，830 & 400 tie-Points Breadboard

  • Input voltage: 6.5-12 V (DC) or USB power supply.
  • Breadboard Material: ABS Plastic Panel, Tin Plated Phosphor Bronze Contact Sheet.
  • Jumper Wires length: 12cm/16cm/20cm/25cm (4.72in/6.30in/7.87in/9.84in).
  • Application: Can be used for various DIY projects.
Check Stock

10Pcs USB 2.0 Breakout Board, MELIFE USB to DIP Adapter 2.54mm Breakout Board 4 Pins Pinboard USB Type A Breakout Board

  • PREMIUM QUALITY MATERIAL ENSURES LONG TERM SERVICE--This USB Breakout Board is made of 100% brand new and high quality material ensures longer use.
  • USB TYPE A FEMALE BREAKOUT BOARD--Standard USB type A female socket.
  • 4 PINS USB A BREAKBOARD BOARD--With 4 pins including VBUS, D+, D- and GND.
  • IDEAL TOOL FOR USB POWER SUPPLY AND BREADBOARD DESIGN--Great for DIY USB power supply, breadboard design, etc.
Check Stock

ACEIRMC for Arduino Nano V3.0, Nano Board CH340/ATmega328P Without USB Cable, Compatible with Arduino Nano V3.0 (6 Pack)

  • download the driver of Nano V3.0 at: http://bit.ly/2jKlJMO.
  • Nano's got the breadboard-ability of the compatible for Board and the Mini+USB with smaller footprint than either, so users have more breadboard space. It's got a pin layout that works well with the Mini or the Basic Stamp (TX, RX, ATN, GND on one top, power and ground on the other)..
  • The Nano is using the chips ATmega328P and CH340, not FT232 as official compatible for Arduino, so pls. use the driver from above link..
  • It is a smallest, complete, and breadboard friendly board. It has everything that Diecimila/Duemilanove has (electrically) with more analog input pins and onboard +5V AREF jumper..
Check Stock

Development Board Module Kit Fit for 850/900/1800/1900 MHz GPRS/GSM Antenna, 5~26V

  • Computer debugging USB--TTL. This module is powered by: 5V-26V, 5V 2A power supply is recommended. After plugging in the motherboard, the power supply must be able to supply 2A. The reason is that the GPRS Shield startup current and the maximum top current required to work up to 2A, but the USB port can not provide such a large current, so the external power supply equipment must be provided..
  • The other power supply port leads to the 3.7--4.5V power supply for lithium battery power supply. The serial port is perfectly compatible. The TTL serial port is compatible with 3.3 and 5V microcontrollers..
  • Make sure your SIM card is not locked. The best baud rate for GPRS Shield communication is 19200 BPS 8-n-1 (GPRS Shield automatically matches baud rate by default). Quad-Band 850 / 900/ 1800 / 1900 MHz - would work on GSM networks in all countries across the world..
Check Stock

WayinTop Electronics Component Fun Kit w/E-Book Upgraded Electronic Starter Kit with Breadboard Jumper Wires Kit PCB Soldering Kit LEDs & Resisitor Kit for Arduino/for Raspberry pi/ESP32/ESP8266

  • 【The Most Complete Electronic Starter Kit】The chosen components are the most complete mix to support a huge variety of projects. Including....
  • 【Breadboard Power Supply】The core module of the starter kit, which power through USB power cable or power by 9V 1A DC adapter. Lamp/digital....
  • 【Breadboard Jumper Wires Kit】Our kit comes with breaboard, power supply, pin header and also each type of jumper wires - ribbon cables / U-shape....
  • 【PCB Soldering Kit】Our kit also add single-sided PCB board, double-sided PCB board, solder wire, you can also learn how to solder running LEDs and....
  • 【Relaiable Technical Support】Detailed tutorials and datasets can be provided for free, please contact us at any time by email to get the eletronic....
Check Stock

HiLetgo BTS7960 43A High Power Motor Driver Module/Smart Car Driver Module for Arduino Current Limit

  • 5V isolate with MCU, and effectively protect MCU.
  • Voltage indication of motor driver output end.
  • Just need four lines from MCU to driver module (GND. 5V. PWM1. PWM2).
  • isolation chip 5 V power supply (can share with MCU 5 V)..
  • Able to reverse the motor forward, two PWM input frequency up to 25kHZ.
  • two heat flow passing through an error signal output..
  • Isolated chip 5V power supply (can be shared with the MCU 5V), can also use the on-board 5V supply.
Check Stock

Nextbook Tablet Charger Adapter 5V 3A 2A 2.5A 1A AC DC Adapter w/ 8 Tips for Amazon Fire USB Hub TV Box LED Pixel Light Camera Speaker GPS Toys Webcam Router Power Supply Cord

  • 【5V 3A POWER SUPPLY】Input: 100-240V 1.5A, 50-60Hz. Output: DC 5V 3A 3000mA, 15W Max. 5V 2.5A, 5V 2A, 5V 1.5A, 5V 1A are also compatible with. Wire length: 1.5M/ 5 Ft..
  • 【5 VOLT UNIVERSAL POWER SUPPLY】15W 5V 3A AC DC power supply adapter is widely used, compatible with: IP Security Camera, LED Pixel Light, USB-HUB, Graco Swing, Kindle Fire Tablet, Baby Monitor, Home Phone System, VoIP Telephone Routers, Serato DJ Controller, Nextbook, Tablet, Raspberry Pi 3 3B 3B+ 2, more..
  • 【COMPATIBLE WITH MOST HOUSEHOLD ELECTRONICS】5V 3A 15W power adapter charger works with Graco Swing, Kindle Fire Tablet, Home Phone System, Android smart phones, Android tablets, VoIP Phone Router, Serato DJ Controller, Nextbook, 5V scanner, USB Hub, toys, LED light, camera, digital recorder, webcam router, slingbox 360, Bluetooth Speaker, drill convertor, DVR, radio, Raspberry Pi 2, KVM switch, G-Box, night light, 2.5-inch HDD Enclosure, lelo products, ROKU 1, ROKU 2, Roku streaming.
  • 【WITH 8 DIFFERENT PLUGS】5V power cord charger with 8 tips works with most of your 5V devices. Tips can be switched easily. No need to prepare many chargers for different appliances. Inner positive(+), Outter negative(-).
  • 【PACKAGE INCLUDES】1 x 5V 3A power supply, 8 pcs x Plug. (5.5*2.1mm,....
Check Stock

5V 2A Power Adapter POWSEED DC in 5V Power Cord Charger 10W AC Adapter for Kindle Fire Kindle fire HDX Tablet Monitor TV Box Camera BT Speaker Webcam Router eReader and More 5V Electronics

  • This 5V 2A Power Adapter POWSEED DC in 5V Power cord Charger 10W AC Adapter with multiple tips works for many small digital electronics like PS4....
  • Worldwide Input:110-240V, Output: 5V 2.1A Max 10W. This 5V charger compatible 5v 1A, 5v 1.5A, 5v 1.75A, 5v 2A, 5v 2000 mA,5v 1000 mA, 5v 1000mA, 5v....
  • MULTIPLE TIPS – POWSEED 5V 2A Adapter with various popular DC plugs, can power most your DC5V charging devices. Providing you more power choices.....
  • Design-safeguard features against incorrect voltage, short circuit, internal overheating and overloading. POWSEED 5v 2a power supply is made from....
  • Package include: 1 x 5 vlot DC Power Supply, 1 Set x DC Power Plug.
Check Stock

sb components Raspberry Pi Pico Board with Raspberry Pi Pico Breadboard Kit, Multi-Purpose Raspberry Pi Pico Breadboard Kit

  • Raspberry Pi Pico is Raspberry Pi's first microcontroller board, designed especially for physical computing.
  • It can be easily reprogrammed over USB from a Raspberry Pi or other computer using the C/C++ SDK or the official MicroPython port.
  • Raspberry Pi Pico Breadboard Kit is a multi-purpose Kit that consists of a “400 points half-size breadboard”.
  • Pico Breadboard Kit consists a programmable buzzer, 4 programmable LEDs, 4 pushbuttons, and dedicated 5V, 3v3, and GND pins at a single place.
  • Raspberry Pi Pico Breadboard Kit is specially made to work with the Raspberry Pi Pico Board.
Check Stock

SparkFun Compatible with Arduino Pro Mini Starter Kit - 5V/16MHz - Comes to get a Project Started

  • The Pro Mini is SparkFun's minimal design approach to Arduino running at 5V with a 16MHz bootloader. Does not come with connectors populated so that you can solder in any connector or wire with any orientation you need..
  • Includes: Compatible with Arduino Pro Mini 328 - 5V/16MHz, FTDI Basic Breakout - 5V, Breadboard - Mini Modular (White), USB Mini-B Cable - 6".
  • Also includes: Break Away Headers - Straight (40-pin), Jumper Wires Premium 4" M/M (30 pack), LED - Basic Red 3mm, LED - Basic Green 3mm, 2x Resistor 330 Ohm 1/6th Watt PTH, Break Away Headers - Right Angle (6-pin), 2x Female Headers (2-pin).
  • Pro Mini Features: ATmega328 running at 16MHz with external resonator (0.5% tolerance), 0.8mm Thin PCB, USB connection off board, Supports auto-reset, 5V regulator.
  • Pro Mini Features: Max 150mA output, Over current protected, Weighs less than 2 grams! DC input 5V up to 12V, On board Power and Status LEDs, Analog Pins: 8 Digital I/Os: 14, 0.7x1.3" (18x33mm).
Check Stock