ElecGear 4X Replacement Joystick (EL2 FU 10K) for PS4 / PS3 Wireless Controller, Analog Stick Controller Sensor Assembly Thumbstick Module for Playstation
...log joystick was found in some PS4 DualShock 4 came with PlayStation 4 Pro, and some PS3 controllers also use this version. The thumbstick module was made by Favor Union (FU). The stick controller comes with 10KΩ trimmer potentiometers in orange.
[Compatibility] – The 14 prongs were positioned as the same as ALPS edition. Technically, the whole unit is interchangeable with EL1 ALPS 10K used in PS4 controllers, and other brands like ‘Scuf’ and ‘Razer Raiju Ultimate’ with ALPS joysticks inside. However, the trim pot resistor alone is not interchangeable with ALPS edition.
[Additional Resistor] – Complicated moving mechanism and daily wear and tear finally caused drifting. Even new sensors cannot be 100% balanced. Calibrating in controller settings might not work. We packed 10x correction resistors to solve the potential problem in hardware level. Solder one or two paralleled tiny resistors onto the potentiometer at the opposite direction against drifting. It will help correct 3 to 5 degrees drifting.
[When to replace] – The analog joystick needs to be replaced when your controller has the problem of drifting, creeping, stuttering, a blind spot, a dead spot, a dead zone, no reaction when clicking, or it wouldn't center after years of we....