ReviewsAutomatic Load Controller

EDECOA 3000 Watt Power Inverter DC 12V to AC 110V 120V for Car Truck RV with LCD Display and Remote Controller

  • This is a 12 V 3000 W modified sine wave inverter which converts DC 12v to AC 110V/120V.It is ideally suitable for Journeys, Camping, Tents, Boat Trip, Working on the way and everywhere, where is no electricity! Simply connect the Power Inverter with a Battery and then connect to electrical appliances..
  • POWER: Output continuous power: 3000 Watts.
  • EQUIPMENT: 2 AC outlets (US sockets)and upgraded remote controller with the humanized design LCD that you can check the battery capacity, load level, temperature, fan status, frequency, DC input voltage, AC output voltage, protection indication, etc..
  • MULTI-PROTECTION: Automatic voltage regulation(AVR).
  • WHAT YOU GET: EDECOA 3000W power inverter, battery cables, remote controller and user manual..
Check Stock

FDGBCF 24v dc Solar Water Pump, deep Well Submersible Pump 50mm (2 inch) Small Diameter

  • - Made of stainless steel, non-sensor shielding motor, motor efficiency over 90%..
  • - Permanent magnet, brushless DC motor for long lifetime.
  • - Powered by solar panel directly, fully automatic operation, remote operation safeguards.
  • - Prevent frequent start up of low solar power, the controller prolong the motor lifetime.
  • - The pump include Over-voltage protection / Under-voltage protection / Over-current protection / Over-load protection / Lightning protection.
Check Stock

EDECOA 24V 3000 Watt Power Inverter DC 24V to AC 110V 120V 3000W Power Converter with LCD Display and Dual USB Remote

  • This is a 24 V 3000 W modified sine wave inverter which converts DC 24v to AC 110V/120V.It is ideally suitable for Journeys, Camping, Tents, Boat Trip, Working on the way and everywhere, where is no electricity! Simply connect the Power Inverter with a Battery and then connect to electrical appliances..
  • POWER: Output continuous power: 3000 Watts.
  • EQUIPMENT: 2 AC outlets (US sockets)and upgraded remote controller with the humanized design LCD that you can check the battery capacity, load level, temperature, fan status, frequency, DC input voltage, AC output voltage, protection indication, etc..
  • MULTI-PROTECTION: Automatic voltage regulation(AVR).
  • WHAT YOU GET: EDECOA 3000W power inverter, battery cables, remote controller and user manual..
Check Stock

wrtgerht Mini Power Small Pump Male 3/4 inch to 1/2 inch Thread Connector Circulation Pump Automatic Water Flow Sensor Switch 120W (Color : Yellow)

  • WATER PRESSURE BOOSTER PUMP-- Warming: Before starting the unit check suction and ensure that the pump is primed..
  • WATER PUMP CONTROLLER-- Automatic Water Pump Electronic controlled sensor system design for easy automatic operation..
  • AUTOMATIC PRESSURE CONTROLLER FOR WATER PUMP-- Application: Suitable for almost all pumping systems without a pressure vessel..
  • AUTOMATIC WATER PUMP CONTROLLER-- Specification: Voltage: 220-240V.
  • HOME WATER PUMP-- Electronic operation: Electronic controlled sensor system design for easy automatic operation..
Check Stock

EDECOA 2000 Watt Power Inverter DC 12V to AC 110V 120V with LCD Display and Remote Controller Dual USB (2000W 12V (ET-RC Remote))

  • INFO: This is a 12V 2000W modified sine wave power inverter. It is ideally suitable for Journeys, Camping, Tents, Boat Trip, Working on the way and everywhere, where is no electricity!.
  • POWER: Output Continuous Power: 2000 Watts.
  • EQUIPMENT: 2 AC outlets (US sockets). An upgraded remote controller with the humanized design LCD that you can check the battery capacity, load level, temperature, fan status, frequency, DC input voltage, AC output voltage, protection indication, etc..
  • MULTI-PROTECTION: Automatic voltage regulation(AVR).
  • Every piece is tested before shipment. You will get an EDECOA 2000w power inverter, user manual, ET-RC remote controller, batteries cables..
Check Stock

EpRec 30A 12V 24V PWM Solar Charge Controller Compatible with Lead Acid/ Lithium-ion/ Lithium Iron Phosphate Battery

  • 【Upgraded Solar Panel Controller】This 30a solar charge controller compatibility with 12V 24V system.Fully 4-Stage PWM charge (Boost, ABS, Equalization,Float),the power MOSFET is used as and electronic switch without any mechanical switches and equipped with industrial-grade STM 8 microprocessor to prolong your battery life cycle..
  • 【LCD Display】Backlight LCD display PV/Battery/Load charge and discharge parameter.Dual USB can give your electronic product max 5V 2.5A..
  • 【Intelligent Control】This solar controller fit for lithium-ion/ lithium iron phosphate /Lead-acid batteries(OPEN,AGM,GEL,) with mutiple load timer(Load should be DC).It has a wide range of applicability and automatically identifies daytime/night.For protecting the lifespan of your battery, once the voltage of the battery drop below 8V, the solar controller will turn off automatically..
  • 【Safe to Use】PWM charge controller Protection:Dual MOSFET Reverse current /over heat /Under-voltage discharge discharge /short-circuit /open-circuit / over-load /over-charging protection.more safe for home, industrial,commercial etc..
  • 【Customer First】12 months honor warranty from EpRec and 24hrs after service.Your satisfaction is our priority..
Check Stock

QWORK Solar Charge Controller, 30A Adjustable Parameter Backlight LCD Display and Timer, 1 Piece

  • 30A Solar Charge controller: LCD display, one-click operation, automatic disconnection when the battery is full, automatic memory data storage..
  • Wide Application: Ideal for solar power generation systems, smart homes, solar chargers, solar ventilation systems, solar light boxes, solar billboards, solar warning lights and so on..
  • Multi-Layer Protection: Built-in overcurrent, short circuit protection, reverse connection protection and open circuit protection are all automatic recovery without damaging the controller..
  • Light Control and Time Control: The controller has light control and time control..
  • Three-Stage PWM Regulation Charging: Three-stage PWM regulation charging mode is adopted, including direct charging, lifting charging and floating charging. The controller is used to realize efficient and fast intelligent charging, and the service life of the battery is effectively prolonged..
Check Stock

MPPT 60amp Solar Charge Controller 12v 24v 36v 48v auto max 150V Solar Panel Regulator Input fit for Lead Acid Lithium Gel Battery

  • 【HIGH TRACKING EFFICIENCY】- Solar charge controller adopts advanced MPPT technology that ensures fast and stable track the maximum power point, high tracking efficiency of up to 99%, and peak conversion efficiency of 98%. Maximizing the energy from solar panels to charge your system. It auto detects 12V or 24V DC system voltages. The max load output current is 20A. If it exceeds the 20 amp DC load (240 watts), the overvoltage protection will turn off the output..
  • 【MULTIPLE ELECTRONIC PROTECTION】- Negative Ground Controller offers overcharging/over-discharging/overload/overheat/short circuit/reverse protection. Maximum degree avoids the damage due to system fault or installation error..
  • 【LCD SCREEN DISPLAY & REMOTE MONITORING】- 20A solar controller is equipped with an LCD screen and LED fault indicators, which can not only check device operating data and status but quickly determine system faults and modify controller parameters. Built-in Bluetooth module, you can download the ‘’ChargePro 2.0'' (new version) or "PVChargePro'' (old version) app for remote monitoring that keeps 300 days of historical data..
  • 【HIGHER HEAT DISSIPATION EFFICIENCY & FULL-LOAD WORKING】- Die-cast aluminum heat sink makes the heat dissipation efficiency higher,....
Check Stock

PowMr MPPT Charge Controller 60 amp 48V 36V 24V 12V Auto - Max 160VDC Input LCD Backlight Solar Charge for Vented Sealed Gel NiCd Lithium Battery【Software Update Version】(MPPT-60A)

  • ❶【Software Update Version】100% MPPT 60A solar charge controller Intelligent, Max efficiency ≥98.1%, PV utilization ≥99%.Built-in DSP controller with high performance Automatic battery voltage detection 12V/24V/36V/48V, Make sure batteries' voltage more than 12V to boost controller and make sure battery has enough power to Self-detection when connected to the controller..
  • ❷Fit for USER(can be set Lithium, Lifepo4, Li(NiCoMn)O2)/Vented/Flooded/Sealed/Gel/NiCd battery.User programmable for absorption voltage/Floating voltage/Low voltage disconnect./Load Timer. Real-time energy recording..
  • ❸Blacklight LCD Dispaly PV voltage/output power/Battery voltage/charging current/working mode/Temperature, ☀ TROUBLESHOOTING function and LCD display and can help users not only check the whole system operating data and statuses but also quickly identify system faults and modify parameters..
  • ❹Intelligence Fan-on temperature 003e45℃ and off 003c 40℃,Porous heat dissipation.and fan use BEARING technologies increase life UP TO 5000hrs in normal use..
  • ❺【What You Get】we consider that the larger diameter of the wire will be greater cost for customers, so we designed two connectors for each pos and negs on solar and batteries connectors. copper wires:9....
Check Stock

HQST MPPT Solar Charge Controller 20 Amp Negative Grounded Controller with Bluetooth LCD Display, 12V/24V DC Input Solar Panel Regulator for Gel Sealed Flooded and Lithium Battery

  • 【HIGH TRACKING EFFICIENCY】- HQST 12V 20 amp Solar charge controller adopts advanced MPPT technology that ensures fast and stable track of the maximum power point, high tracking efficiency of up to 99%, and peak conversion efficiency of 98%. Maximizing the energy from solar panels to charge your system. It auto-detects 12V or 24V DC system voltages. The max load output current is 20A. If it exceeds the 20 amp DC load (240 watts), the overvoltage protection will turn off the output..
  • 【PARALELL CHARGE FUNCTION】- 2 HQST MPPT controllers of the same series(M2420N/M2440N/M4860N) can work together to charge the same battery with the parallel charge cable (not included), to meet high power charging requirements and 2 controllers should set the same battery pack voltage. Our negative grounded controller offers overcharging/over-discharging/overload/overheat/short circuit/reverse protection. The maximum degree avoids the damage due to system fault or installation error..
  • 【LCD SCREEN DISPLAY & REMOTE MONITORING】- 40A solar controller is equipped with an LCD screen and LED fault indicators, which can check device operating data and modify controller parameters. Built-in Bluetooth module, you can download the ‘’ChargePro 2.0'' (new version) or the "....
Check Stock

HQST MPPT Solar Charge Controller 40 Amp Negative Grounded Controller with Bluetooth LCD Display, 12V/24V DC Input Solar Panel Regulator for Gel Sealed Flooded and Lithium Battery

  • 【HIGH TRACKING EFFICIENCY】- HQST 12V 40 amp solar charge controller adopts advanced MPPT technology that ensures fast and stable track of the maximum power point, high tracking efficiency of up to 99%, and peak conversion efficiency of 98%. Maximizing the energy from solar panels to charge your system. It auto-detects 12V or 24V DC system voltages. The max load output current is 20A. If it exceeds the 20 amp DC load (240 watts), the over voltage protection will turn off the output..
  • 【PARALELL CHARGE FUNCTION】- 2 HQST MPPT controllers of the same series(M2420N/M2440N/M4860N) can work together to charge the same battery with the parallel charge cable (not included), to meet high power charging requirements and 2 controllers should set the same battery pack voltage. Our negative grounded controller offers overcharging/over-discharging/overload/overheat/short circuit/reverse protection. The maximum degree avoids the damage due to system fault or installation error..
  • 【LCD SCREEN DISPLAY & REMOTE MONITORING】- 40A solar controller is equipped with an LCD screen and LED fault indicators, which can check device operating data and modify controller parameters. Built-in Bluetooth module, you can download the ‘’ChargePro 2.0'' (new version) or the ....
Check Stock