ReviewsAutomotive Water Pump Seal

Carter Universal Electrical Fuel Pump Automotive Replacement 12V (P4602RV)

  • SIMPLE AND QUICK INSTALLATION: All necessary hardware is provided so you can have a hassle free automotive replacement installation. Instructions also included for a step by step wiring guide..
  • TOUGH TURBINE TECHNOLOGY: Inspired military strength and performance, this fuel pump provides improved and QUIET fuel flow for adequate pressure and lowers current strain to meet specific engine requirement..
  • FRESHER FUEL: Made with a multi-layer filtration technology, this electric pump provides 40% more dirt holding capacity, keeping your pump and engine safe from impurities and providing increased pump longevity..
  • WHAT'S INCLUDED:For a proper installation, Carter electrical in tank fuel pump comes with the following components: fuel pump, strainer, wire harnesses, tank seal, and grommets..
  • VEHICLE FIT:BMW 530i 1976-1975, 630CSi 1978-1977, 2002tii 1974-1972, Cadillac DeVille 1975, DeVille 1979-1977, Eldorado 1975, Eldorado 1977, Eldorado 1979, Fleetwood 1979-1975, Seville 1977-1976, Seville 1979, Ford Escort 1986-1983, EXP 1986-1983.
Check Stock

Athena Parts Water Pump Gasket Kit with Bearings for KAWASAKI KX 250 F 2004-2008, SUZUKI RMZ 250 2004-2006, black

  • Includes every gasket, O-ring, bearing, and seal required to rebuild a water pump..
  • Typical kit includes the following -Bearings where applicable. -Rubber Seals. -Mechanical Water pump seal where applicable. -Side cover gasket. -Water pump gasket. -Snap rings located on water pump shaft. -Copper drain washers..
Check Stock

FLUENTPOWER 3/4 HP Utility Pump with Full Stainless Casing, Submersible Sump Water Pump with Float Switch,Max Lift 27 Ft and Max Flow 3300 GPH, 3/4" Garden Hose Adapter and 1"&1.5" MNPT Included

  • 【Float Switch Automatically Control】- The pump is automatically ON/OFF controlled by float switch according to water level. It starts at water level 30~50cm and stop at 10~15cm. It can remove water down to 1 cm by manually control..
  • 【Full Stainless Casing and Long Cable Cord】Solid metal casing is resistant to rust. This pump is only works with clean water that contains small solid less than 5mm. Pump also comes with a long 26.2ft cable cord, which allows pump to go deep enough (23ft) in the water..
  • 【Oil-Filled Seal Structure with Thermal Protection】- Oil-filled seal structure gives pump longer duration, which is much longer than regular mechanical seal. Thermal protector ensures that the pump will not be burned out. Even when the pump trigger thermal overload protector, pump will rework after cooling down..
  • 【3/4 HP Power High Efficiency】- Maximum capacity of transferring water up to 3300 GPH with 1.5″ discharge port and hose horizontally, Maximum delivery height is 28ft vertical, 2200 gallons per hour on at 10ft discharge lift..
  • 【GHT 3/4″, NPT1″ and 1.5″ male tread connectors included】- With 1.5″ discharge port will give pump maximum output flow rate. Multiple hose adapters help you to get pump starte....
Check Stock

Go, Flush, Wash and Dry

  • Internally mounted, high speed, non-clogging, centrifugal, waste macerating pump driven by powerful 240 watt, 12 volt dc, permanent magnet motor with ball bearings and robust ceramic seal, discharges up to 5ft (1.5m) above the base of the toilet..
  • Raw Water Rinse pump inlet - ¾" (19mm) hose tails. Flush pump discharge - 1½" (38mm) hose tail..
  • Jabsco, self-priming rinse pump up to 3m (10ft), dry running, diaphragm water pump driven by 12 volt dc, permanent magnet, ball bearing motor..
  • One Touch 'Press and Release' switch pad mounted on wall with four flush and rinse finctions, sealed for life, with 10 -feet (3m) link cable, fitted quick connector, and heat shrink seal..
Check Stock

FLUENTPOWER 3/4HP Utility Pump 3300GPH Stainless Steel Submersible Sump Pump, Drain Clean Water for Basement Flood Cellar Pool Pond Garden and Hot Tub

  • ☘【3/4 HP HIGH EFFICIENCY】Equipped with 3/4 HP powerful motor, the capacity of transferring water can be Max. 3300 GPH with 1.25" discharge hose horizontally. Pump has the ability to lift water up to Max. 28 ft vertical, 2200 gallons per hour on at 10 ft discharge lift. This utility pump works with CLEAN water which contains small solid less than 0.2"..
  • ☘【FULL STAINLESS STEEL CASING】Assembled by integrated 304 stainless steel housing and pump base with better cooling ability for long life. Pump also comes with a 26.2 ft long cable cord, which allows pump to go deep enough (23 ft) in the water. This pump can be used in Min 7"x7" pit..
  • ☘【SIMPLE PLUG-IN CONTROL】The pump ON/OFF is controlled by cable plug. It can start pumping water from 2" down to 0.4". Designed for quickly draining water in hot tub, water tank, rain barrel, swimming pool, garden ponds, wells and so on..
  • ☘【SAFETY ENSURE& DURABLE】Oil-Filled Seal Structure gives pump longer duration, which is much longer than regular mechanical seal. Full corrosion-resistant shell and thermal protection ensures the pump will not be burned out, even when the pump trigger thermal overload protector, pump will rework after cooling down..
  • ☘【EASY TO INSTALL】Comes with three plastic ada....
Check Stock

Utility Pump Replacement Carbon Brushes,Impeller,Shaft Seal Part for FPOWER Water Transfer pump (1 Set)

  • Utility Pump Replacement Carbon Brushes,Impeller,Shaft Seal Part for FPOWER Water Transfer pump (1 Set).
  • Package Content: 2 x Carbon Brushes, 1 x Impeller, 1 x Seal.
  • Carbon Brush Size (Approx) : 18 x 6 x 6 mm.
  • Impeller Measures: 1-3/8" Diameter, 1/2" Width with D Shaped Drive Hub for 5/16" Diameter Shaft.
  • Impeller&Seal are also fits in FPOWER DC 12-Volt Utility Water Transfer Pump.
Check Stock

Hand Bilge Pump Manual Hand Water Pump for Kayaks Canoes and Boats Emergency Hand-Operated Marine Bilge Pump with Reversible Hose

  • ⛵HAND BILGE PUMP FOR BOATS: Our manual bilge pump length is 17", and the maximum unfolded length is 28.3", which is easy to store and takes up minimal space. It’s the perfect boating accessory for kayaks, canoes, dinghys and small boats. Our bilge pump remove water quickly and downward strokes for maximum efficiency and less fatigue.
  • ⛵MAKES WATER REMOVAL EASIER & FASTER: Our hand water pump features a 34.6" long hose with a 1.16" intake nozzle and 1.37" diameter hose that makes reaching the bottom of your boat easier and removing excess water faster. This hand suction pump works great to remove water from the bottom of a motorboat, canoe or dinghy.
  • ⛵EASY TO USE: Just simply connect the hose to the end of the pump, insert the bottom of the pump into the water, and use the handle to start pumping. It sucks water when you push the handle in, and disperses the water when you pull the handle out!.
  • ⛵NO CLOG FILTER & ANTI-LEAK DESIGN GASKET: Our marine bilge pump Features a filtered nozzle to prevent seaweed, leaves and debris from clogging this hand water pump. And The premium rubber sea....
Check Stock

Air Operated Double Diaphragm Pump QBY4-25L 1 inch Outlet 35 GPM Pneumatic Transfer Max 120 PSI Industrial Use Chemical Waste Oil Dual Dissepiment Nitrile Fluorine Rubber by Cast Iron Aluminum Alloy

  • ...corrosion for reliable performance and long life. Bolted construction is designed for leak-free fluid handling..
  • 【WIDELY USE】The diaphragm pump with convenient operating are widely used in various industries, such as petroleum, metallurgy, mining, coating material, paint, printing, paper making, water treatment, automotive etc..
Check Stock

Jabsco Lite Flush Compact 12 Volt Marine Electric Toilet with Panel Control

  • Internally mounted, high speed, non-clogging, centrifugal, waste macerating pump driven by powerful 240 watt, 12 volt dc, permanent magnet motor with ball bearings and robust ceramic seal, discharges up to 5ft (1.5m) above the base of the toilet..
  • Raw Water Rinse pump inlet - ¾" (19mm) hose tails. Flush pump discharge - 1½" (38mm) hose tail..
  • Jabsco, self-priming rinse pump up to 3m (10ft), dry running, diaphragm water pump driven by 12 volt dc, permanent magnet, ball bearing motor..
  • One Touch 'Press and Release' switch pad mounted on wall with four flush and rinse finctions, sealed for life, with 10 -feet (3m) link cable, fitted quick connector, and heat shrink seal..
Check Stock

EAI Oil Seal Compatible for Honda OEM# 91203-KCY-671

  • !!SAME BUSINESS DAY SHIPPING!! SUPERIOR QUALITY and DURABILITY: EAI Automotive Oil Seals are engineered with sturdy Carbon Steel Spring and high strength Nitrile Rubber for reliable and long-lasting performance. The rubber cover seal is lightweight and not easy to age..
  • SEAL OFF LEAKAGE and DIRT: No more getting stressed up by spills from your rotary elements! Crafted with Nitrile Rubber, Garter Spring and Carbon Steel Case, this oil seal effectively prevents the leakage of lubricants and prevents the entry of dust and dirt into your precious machine..
  • OEM# : 91203KCY671. The perfect Automotive Oil seal for your HONDA Vehicle.
  • HIGH-TEMPERATURE RESISTANCE: With its 70A Nitrile Butadiene Rubber cover material design, this spring loaded metric rotary shaft will withstand temperatures from -40℉ to 226℉.
  • HYDROCARBON FLUIDS: Engineered for the hydrocarbon fluids sealing environment, this oil seal boosts a good resistance to grease, mineral oil, hydraulic fluids, and petroleum oil. What more, this seal has low swelling in water, ensuring long term use..
Check Stock

LINGVUM Bilge Pump for Kayak Canoe and Boat - 17 Inch Manual Portable Kayak Hand Water Pumps with Reversible Hose Orange

  • CONVENIENT BILGE MANUAL WATER PUMP --- Our manual bilge pump length is 16.5", the maximum unfolded length is 25.5", equipped with a 23.2"long hose. At the same time, Our bilge pump has two water inlets and a long hose that attaches to either end, removing water quickly and reducing your fatigue.
  • MAKES WATER REMOVAL EASIER --- The maximum displacement is 0.4L each time. The premium rubber seal creates a watertight seal that won't come loose or leak allowing for the maximum amount of suction and discharge that performs better than other hand bilge pumps. Suction spacers can allow water to flow into the manual water pump at the fastest speed.
  • SCENE TO BE USED --- Perfect for emergency water removal in boats, kayaks, canoes or dinghies. With our kayak bilge pump, rest easy knowing that you’ll have a quick and easy way of removing water in those difficult times. Spending time on the water is supposed to be fun! Perfect boating and kayaking accessory.
  • LIGHTWEIGHT & PORTABLE --- This kayak hand pump is light (Only 0.78 pounds), easy to carry and store. Foam padded handgrip is non-slip and provides buoyanc....
Check Stock