ReviewsBearing End shield

Aicosineg 2Pcs 6807-2RS Deep Groove Ball Bearings Double Sealed Bearings Ball Bearings High Carbon Chromium Bearing Steel Roller Guide Bearings for Scooters Elevators Skateboards 1.38x1.85x0.28in

• Material:High Carbon Chromium Bearing Steel(GCr15).
• 【High Quality】-The bearings is made of bearing steel for durability and resistance to rust, corrosion and deformity under heavy loads.
• 【Feature】-Rolling bearings use rolling elements to maintain the separation between moving parts to reduce rotational friction and support radial and axial loads,and it has small friction and high-limit speed.
• 【Strictly Shielded】-The bearing has shield to keep lubricant in and contaminants out.
• protects the working parts of the bearing from environmental debris that may be introduced and could reduce the ball bearing speed and lifespan.
• 【Application】-Rolling bearings are used in a range of applications from agricultural machinery to conveying equipment,robotics,dental equipment, elevators, rolling mills, ship rudder shafts, aggregate crushers,skateboards, inline skates, and scooters, among others.

10 Pack 6204-2RS Double Rubber Seal Bearing 20x47x14mm,Stable Performance,Cost Effective, Deep Groove Ball Bearings

• 【Wide Application】Rolling bearings are used in a range of applications from agricultural machinery to conveying equipment, robotics,dental equipment, elevators, ship rudder shafts, skateboards, inline skates, scooters and , among others..
• 【6204-2RS Dimension】Inner Dia.=0.79 inch, Outer Dia.=1.85 inch, Thickness=0.55 inch.
• 【Material】The bearing is made of high quality bearing steel, good durability and resistance to heavy loads(Synthetic Grease Formula included Wear-Resistant Additives and High Temperature Grease can be rated to 410 F.
• 【Features】Pre-lubricated, normal accuracy, less friction, higher speed, smooth and low noise.
• 【Strictly Shielded】Shields on both sides of the bearing help to keep dust out.Premium Support & 12 Months Warranty.

Othmro 1Pcs R24 2RS Deep Groove Ball Bearings Double Sealed Bearings High Carbon Chromium Bearing Steel Ball Bearings 1.5x2.63x0.44inch Deep Groove Bearings for Scooters Elevators Skateboards

• Material:High Carbon Chromium Bearing Steel.
• 【High Quality】-The bearings is made of bearing steel for durability and resistance to rust, corrosion and deformity under heavy loads.
• 【Feature】-Rolling bearings use rolling elements to maintain the separation between moving parts to reduce rotational friction and support radial and axial loads,and it has small friction and high-limit speed.
• 【Strictly Shielded】-The bearing has shield to keep lubricant in and contaminants out.
• protects the working parts of the bearing from environmental debris that may be introduced and could reduce the ball bearing speed and lifespan.
• 【Application】-Rolling bearings are used in a range of applications from agricultural machinery to conveying equipment,robotics,dental equipment, elevators, rolling mills, ship rudder shafts, aggregate crushers,skateboards, inline skates, and scooters, among others.

Zoty MR115ZZ Bearing 5x11x4mm RC Hobbies Radio Control Steering Bearing Set Pack of 10 pcs

10 Pack 6205-2RS Double Rubber Seal Bearing 25x52x15mm,Pre Lubricated,Stable Performance,Cost Effective, Deep Groove Ball Bearings

• 【Wide Application】Rolling bearings are used in a range of applications from agricultural machinery to conveying equipment, robotics,dental equipment, elevators, ship rudder shafts, skateboards, inline skates, scooters and , among.
• 【6205-2RS Dimension】Inner Dia.=0.98inch, Outer Dia.=2.05inch, Thickness=0.59inch.
• 【Material】The bearing is made of high quality bearing steel, good durability and resistance to heavy loads(Synthetic Grease Formula included Wear-Resistant Additives and High Temperature Grease can be rated to 410 F).
• 【Features】Pre-lubricated, normal accuracy, less friction, higher speed, smooth and low noise.
• 【Strictly Shielded】Shields on both sides of the bearing help to keep dust out.Premium Support & 12 Months Warranty.

10 Pack 6202-2RS Double Rubber Seal Bearing 15x35x11mm,Pre Lubricated,Stable Performance,Cost Effective, Deep Groove Ball Bearings

• 【Wide Application】Rolling bearings are used in a range of applications from agricultural machinery to conveying equipment, robotics,dental equipment, elevators, ship rudder shafts, skateboards, inline skates, scooters and , among others..
• 【6202-2RS Dimension】Inner Dia.=0.59 inch, Outer Dia.=1.38 inch, Thickness=0.43 inch.
• 【Material】The bearing is made of high quality bearing steel, good durability and resistance to heavy loads(Synthetic Grease Formula included Wear-Resistant Additives and High Temperature Grease can be rated to 410 F).
• 【Features】Pre-lubricated, normal accuracy, less friction, higher speed, smooth and low noise.
• 【Strictly Shielded】Shields on both sides of the bearing help to keep dust out.Premium Support & 12 Months Warranty.

VCT Rear Axle Bearing Remover Puller Slide Hammer Set Remove Semi-Floating

• EASY TO USE: Slide flat end of puller through center of bearing and flat against backside of bearing, then slide washer down the center of the shaft against front side of bearing and tighten the nut on smaller end of puller, then thread a slide hammer (not included) to the puller and slide hammer back and forth until the bearing comes out.
• The washer captures the bearing firmly to distribute the applied force over the entire bearing and prevent damage.
• Use the VCT Pneumatic SAE Standard Rear Axle Bearing Puller 3-Piece Service Set – Domestic Car Vehicle Bearings Removal Tool Kit to service semi-floating rear axle bearings on your vehicle.
• These tools make the job simple and prevent damage to your bearings when pulling.
• Much easier than claw-type axle bearing pullers that slip off and chew up the old bearings.
• For removal only, not intended for installation.
• FITS YOUR CAR: Standard SAE sizes work for most American domestic makes and models.
• Set includes the following sizes to fit main bearing tube – 1 inch to 1-7/8 inches, 1-5/16 inches to 2-3/8 inches, and 1-3/8 inches to 2-7/8 inches.
• Sizes permanently laser-etched on tool for easy identification.
• Each tool fits a basic slide hammer with a 5/8-inch x 18 thread pitch.

Hooshion Metal Tripod Umbrella Holder, Outdoor Camera Tripod Umbrella Holder Metal Clip Bracket Stand Clamp Photography Accessory(Metal Clip Not Plastic Clip)

• Umbrella chair clamp middle is designed to rotate and adjust the angle function.You can adjust the angle to the suitable position.The umbrella clip is composed of two parts, the top can be detached for use, and the standard 1/4 screw head of the at the top can be used as a base for digital cameras and GoPro..
• Umbrella clip for camera, one end to clamp tripod axis, the other end clamp umbrella handle, can be clamped on the center axis of tripod or tripod tripod..
• The umbrella holder for chair body is made of metal, which is more durable and more load-bearing than most plastic umbrella clips on Amazon..
• Umbrella holder clamp Length 17.5cm, clip opening is up to 3.5cm, it can clamp umbrella's rod or bottom handle.There is rubber pad in the inner clip, it is non-slip and anti-scratch..
• Solve the need to shoot in the rain, insert an umbrella to protect your camera from damage. On sunny days, you can add an umbrella to shield your camera from the sun..

Bones Super Swiss 6 Skateboard Bearings 8 Pack

• BRAND DEEPDREAM: Created using the highest precision German manufacturing techniques to be the most precise bearing in the world.
• TOP QUALITY AT LOW END PRICES: DEEPDREAMgo head to head with Bones Swiss Bearings and are built for racing and durability at a fraction of the cost..
• PREMIUM STEEL: The steel used for DEEPDREAMis the highest end steel available in the world. The precision and smoothness of their spin can not be matched by any other bearing..
• Dimensions suitable for use in such applications as skateboards bearing , inline skates, and scooters.
• HASSLE-FREE MONEY-BACK GUARANTEE: Designed to last longer than any other bearing on the market. If for any reason you are not 100% satisfied, please return your DEEPDREAMfor a no-questions asked, full refund.

Othmro 10Pcs 6204-2RS Deep Groove Ball Bearings Double Rubber Sealed Bearings High Carbon Chromium Bearing Steel Roller Guide Bearing 0.79x1.85x0.55inch for Scooters Skateboards

• 【Size】-20x47x14mm(Inner DiaxOuter DiaxThickness).
• 【High Quality】-The bearings is made of bearing steel for durability and resistance to rust, corrosion and deformity under heavy loads.
• 【Feature】-Rolling bearings use rolling elements to maintain the separation between moving parts to reduce rotational friction and support radial and axial loads,and it has small friction and high-limit speed.
• 【Strictly Shielded】-The bearing has shield to keep lubricant in and contaminants out.
• protects the working parts of the bearing from environmental debris that may be introduced and could reduce the ball bearing speed and lifespan.
• 【Application】-Rolling bearings are used in a range of applications from agricultural machinery to conveying equipment,robotics,dental equipment, elevators, rolling mills, ship rudder shafts, aggregate crushers,skateboards, inline skates, and scooters, among others.

10 Pack Flanged Ball Bearings 5/8' x 1-3/8' x 1/2', Pre Lubricated, for Lawn Mower, Wheelbarrows, Carts & Hand Trucks Wheel Hub, Replacement for JD AM118315, AM35443, Stens 215-038, 215-061 Etc

• 【Wide Application】Suitable for Suitable for applied in lawn mower, wheelbarrows, garden carts, hand trucks, pressure washers, generators, air compressors and more.
• 【Dimension】Suitable for - Shaft diameter 5/8" and hubs wheels diameter 1-3/8".
• 【Material】The bearing is made of high quality bearing steel, good durability and resistance to heavy loads.
• 【Features】Pre-lubricated, normal accuracy, less friction, higher speed, smooth and low noise.
• 【Strictly Shielded】Shields on both sides of the bearing help to keep dust out.Premium Support & 12 Months Warranty.