ReviewsConduit Insulated Throat

Southwire 58133801 1/2-in 90 Degree Liquid-Tight Connector,Grey

  • All nylon construction resists salt water, weak acids, gasoline, alcohol, oil, grease, and common solvents. Molded of type nylon 6. Flammability classification 94V-2: temperature index 125°C.
  • No disassembly required. Instead, the installer simply pushes the conduit or tubing onto the ferrule, tightening the domed sealing nut. The completed assembly can then be secured in the chassis by the locknut (or first secure the connector into an NPT threaded hole).
  • No threading of the conduit or tubing required to install, eliminating the possibility of cutting the conduit and creating leak paths. Applications: HVAC equipment.
  • Complete conduit/connector system is reusable. Conduit will not wind tight onto the connector during assembly and can be easily removed by pulling while turning in a clockwise direction.
  • for original equipment manufacturers or field installers. 0 Ring and steel locknut included.
Check Stock

Leviton 42777-1WA Surface Mount Backbox, Single Gang, White, Box Depth Is 1.89 Inches

  • For use with conduitDescriptionThomas & Betts 583611/2-30 Single Gang Utility BoxThomas & Betts 583611/2-30 Single Gang Utility Box Features:Three 1/2" each side conduit knockoutsOne 1/2" each end conduit knockoutsTwo 1/2" bottom conduit knockoutsFactory provided raised ground screw locationSteel13.0 cubic inch capacity1-7/8" deep with conduit knockouts.
Check Stock

H1499 4 in. Steel Recessed Lighting Housing for Remodel Shallow Ceiling, Low-Voltage, No Insulation Contact, Air-Tite

  • Air-Tite rated design meets restricted air flow code requirements which prevents airflow between attic and living areas and saves on both heating and air conditioning costs.
  • Has four remodel clips which secure the recessed housing and accommodates 1/2 in. and 5/8 in. ceiling material.
  • Compatible with a wide variety of 4 in. low-voltage recessed light trims but is best with Halo 1496, 1493, 1421, 1420 and 1419 series models.
  • NM cable pryouts and conduit knockouts in junction box.
  • Can be installed from below the ceiling in home remodel applications, ideal for those who have limited or no access to their ceiling.
  • For use in non-insulated ceilings or insulated ceilings where insulation is kept at least 3 in. from all sides of the recessed light fixture.
  • 3 "Quick Connect" connectors eliminate the need for separate wire nuts - simply strip supply wires and push in.
  • Listed for damp location when used with dedicated wet rated recessed ceiling lights.
  • Features an integral thermal protector to guard against misuse of insulation materials and improper lamping.
Check Stock

HydroMaxx Flexible PVC Non Metallic UL Liquid Tight Electrical Conduit (1\ Dia x 25 ft)

  • Non Metallic Flexible Liquid Tight Conduit with 2 Free Straight and 2 Free Angle Fittings.
  • Conduit is Flexible - Can be used in extremely Tight Quarters, Light Weight - Lower Installed Costs.
  • Liquid Tight Conduit Resists Corrosion, Oil and Water, Smooth Inside for Easier Wire Pulling, Resists Crushing and Stretching,Outdoor Sunlight Resistant.
  • These Non-Metallic connectors are molded of Type Nylon 6, O Ring and Steel Lock-nut included, for Indoor and outdoor use.
  • No Threading of Conduit Required to Install, No Disassembly Required (Just Push Tubing onto Fitting).
Check Stock

Woods Southwire 55094222 Liqua Flex 1/2-Inch by 50-Feet Non-Metallic Liquidtight Flexible Conduit

  • Non Metallic Flexible Liquid Tight Conduit with 2 Free Straight and 2 Free Angle Fittings.
  • Conduit is Flexible - Can be used in extremely Tight Quarters, Light Weight - Lower Installed Costs.
  • Liquid Tight Conduit Resists Corrosion, Oil and Water, Smooth Inside for Easier Wire Pulling, Resists Crushing and Stretching,Outdoor Sunlight Resistant.
  • These Non-Metallic connectors are molded of Type Nylon 6, O Ring and Steel Lock-nut included, for Indoor and outdoor use.
  • No Threading of Conduit Required to Install, No Disassembly Required (Just Push Tubing onto Fitting).
Check Stock

Liquid-Tight Conduit and Connector Kit,Flexible Non Metallic Liquid Tight Electrical Conduit,1/2inch50ft Electrical Conduit Kit,with 5 Straight and 3 Angle Fittings Included,1/2 in Dia

  • 【PREMIUM Liquid-Tight Conduit】- Length:50"，ID：1/2inch，OD：0.83inch，Thick: 2.5 mm The Flexible Non Metallic Liquid Tight Electrical....
  • 【Complete Accessories】-1/2-Inch 50 Foot Flexible Electrical Conduit with 5 Straight and 390-Degree Conduit Connector Fittings.
  • 【Safety and Sturdiness】-Resists corrosion, abrasion, oil, water, acid, metal shavings, and rough environments.
  • 【Effortless Installation】-The Liquid-Tight Conduit Fits is fast, and only one person can complete the work in a few minutes. flexible conduit....
  • 【Wide Application】-HVAC Equipment, machine tools, marine equipment, motors and controls, printing equipment, pumps, refrigeration equipment,....
Check Stock

Woods 55082122 AL Flex Fo5000050M Type Rwa Reduced Wall Flexible Conduit, 1/2 in X 50 Ft, Aluminum

  • Non Metallic Flexible Liquid Tight Conduit with 2 Free Straight and 2 Free Angle Fittings.
  • Conduit is Flexible - Can be used in extremely Tight Quarters, Light Weight - Lower Installed Costs.
  • Liquid Tight Conduit Resists Corrosion, Oil and Water, Smooth Inside for Easier Wire Pulling, Resists Crushing and Stretching,Outdoor Sunlight Resistant.
  • These Non-Metallic connectors are molded of Type Nylon 6, O Ring and Steel Lock-nut included, for Indoor and outdoor use.
  • No Threading of Conduit Required to Install, No Disassembly Required (Just Push Tubing onto Fitting).
Check Stock

Klein Tools 80035 Level, Digital Electronic Level and Angle Gauge Tool Kit with Plumbers Straps, Measures Angles, Magnetic Base, 2-Piece

  • MEASURE OR SET ANGLES, check relative angles, or can be used as a digital level.
  • REVERSE CONTRAST DISPLAY improves visibility.
  • MAGNETIC BASE attaches to conduit, pipes, saw blades and other ferromagnetic surfaces.
  • V-GROOVE EDGES enable optimal alignment on conduit and pipes.
  • DIGITAL LEVEL MEASURES 0-90 Degree or 0-180 Degree ranges.
  • PLUMBER'S KIT straps to non-magnetic pipes and conduit to present a magnetic surface.
  • FLEXIBLE, ADJUSTABLE LENGTH STRAPS connect the metal plate to pipes, conduit, or other objects.
Check Stock

AMZCNC 8 Ton 1/2 Inch to 2 Inch Hydraulic Knockout Punch Driver Tool Kit with 6 Dies Hole Complete Tool Electrical Conduit Hole Cutter Set (8T（1/2"~2"）)

  • Labor-Saving & Hydraulic 10T: It is a knockout punch set with a separable hydraulic pump. The maximum crimping power is 10 T. It features a good tightness and no oil leakage..
  • Durable Dies & Punches Set:Actual hole diameter is 0.89" for ½" conduit. Actual hole diameter is 1.11" for ¾" conduit. Actual hole diameter is 1.36" for 1" conduit. Actual hole diameter is 1.7" for 1¼" conduit. Actual hole diameter is 1.95" for 1½" conduit. Actual hole diameter is 2.42" for 2" conduit fully meeting your needs. Two draw bolts are solid and built to last. Max thickness for steel: 1/8".
  • Max thickness for stainless steel: 1/16"..
  • Convenient Operation: The knockout set is fast and easy to operate. With the excellent cooperation of a drill bit and a driving bolt, you can easily get a clean and uniform hole. And the long plastic handle ensures zero sliding and effective force transfer, improving work efficiency..
  • Portable Carrying Case: The stud punch tool is stored in a durable plastic toolbox that is not easily broken, saving space. It is compact, light-weigh....
Check Stock

Southwire SDCFR Conduit Fitting Reaming Screwdriver Heavy Duty Dual Function Multi Use Detachable Head Compatible with Drill Cushion Grip Handles for Comfort

  • Conduit fitting reaming screwdriver that perfectly reams and smooths 1/2", 3/4", and 1" Thin-wall Conduit ends to protect wire and permit correct....
  • Dual function: Conduit reamer reams inside and outside of conduit simultaneously.
  • Comfortable grip: Comfortable cushioned grip allows a firm grip and greater torque.
  • Multi USE head: reaming head can be removed and used with your power drill.
  • Head compatible with drill: detachable head can also be used in a drill...........
Check Stock

Genuine Henkel Loctite 2701 Maximum Strength - Threadlocking Adhesive - 50 ML - 12 Pack

  • Oxide-inhibiting compounds produce low initial contact resistance, seal out air and moisture, prevent oxidation or corrosion, exhibit superior weathering characteristics, are usable over wide temperature ranges, and provide a high conductivity “gastight” joint..
  • Compounds contain homogeneously suspended metal particles. The suspended metal particles assist in penetrating thin oxide films, act as electrical “bridges” between conductor strands. the integrity of the connection.
  • Aid in gripping the conductor, improve electrical conductivity and enhance the integrity of the connection.
  • The specially formulated compounds are for use with compression and bolted connectors providing an improved service life for both aluminum connections..
  • PENETROX A is a natural (petroleum) base compound with evenly suspended zinc particles. It is recommended for aluminum to aluminum, aluminum to copper connections and aluminum conduit threads. It is not recommended for use with rubber or polyethylene insulated conductors. UL listed to 600V..
Check Stock