ReviewsContinuity

Megger MIT310-EN Insulation Tester, 1000 Megaohms Resistance, 250V, 500V, 1000V Test Voltage

Insulation tester for testing insulation resistance, voltage, and continuity in electrical installations.
Average-sensing meter provides accurate readings when measuring linear loads, where the current or voltage has a sinusoidal waveform.
Dual digital display with analog arc function to replicate response of analog meters.
Measures insulation resistance from 0 to 1,000 megohms, voltage from 0 to 600V, and continuity from 0.01 to 100 ohms.
Safety rated to European Standard EN61010-1 Category III, 600V and IP54 rated for protection against dust and splashing water.

Check Stock

Automotive Car Repair Diagnostic Tool Cable Circuit Wire Tracker Tracers Analyzer Short Open Finder Tester Checker Device Detector Probe DC 6-42V

7" flexible probe allows reaching wires in congested places.
Sender:Tone/Off/Cont (Continuity) switch / Tone/Cont (Continuity) LEDs / Red and black test leads cable (61cm length, approximate).
Receiver: On/Off button / Test button / Probe length: 7" flexible probe.

Check Stock

TPI 100 EZ One Button Digital Multimeter with Protective Boot 40 Megaohms Resistance 600V AC/DC Voltage

Auto-ranging digital multimeter measures voltage and resistance, and performs continuity tests.
Average-sensing meter provides accurate readings when measuring linear loads where the current or voltage has a sinusoidal waveform.
Audible continuity sensor confirms that the circuit conducts electricity.
Molded rubber boot helps protect against damage from falls, impacts, and abrasion.
Meets IEC safety standard 61010 and is certified for Category II installations up to 1000V and Category III installations up to 600V.

Check Stock

Gardner Bender GDT-3200 Digital Multimeter, 7 Funct., 7 Range, Tests AC/DC Volt, Resist, Diode, Continuity, Temp and Battery, Auto Ranging

Clear, digital LCD display with backlighting.
Full family of digital multi-meters test AC Voltage, DC Voltage, Resistance, Continuity, Temperature, Diodes, and Batteries. Manual and Auto Ranging Styles.

Check Stock

Amprobe DGC-1000A Clamp Ground Resistance Tester

Ground resistance tester for measuring ground resistance, current, and continuity in multi-grounded systems.
True RMS meter provides accurate readings when measuring linear or non-linear loads where the current or voltage has a sinusoidal or nonsinusoidal waveform.
Clamp-on head to measure resistance on a ground rod without the use of additional ground rods and without disconnecting the grounds under test.
Measures ground resistance from 0.025 to 1,500 ohms and AC current up to 10A.
Safety rated to European Standard 61010-2-32 Category III 300V, Category II 600V.
Continuity beep if the resistance is lower than 40.00 Ohms.

Check Stock

CMTOOL Test Light Automotive Power Circuit Probe Tester with 4M Test Lead 6-24V DC Led Light Tester Fuse Tester 12V Wire Circuit Tester Auto 12 Volt Electrical System Tools Car Truck Circuit Test Pen

..., high-temperature resistant, impact-resistant and has a longer service life. The tester also has an overload protection device, When the current exceeds 7A, the circuit breaker inside the device will automatically trip and give out a buzzer prompt..
2.【Polarity Test and Continuity Test】The tester is made of insulating material and high-quality stainless steel, which can help you quickly identify the positive and negative polarity of the vehicle cable and plug. When the tester touches the positive pole, the LED should be red.
when it touches the negative pole, the LED should be GREEN. The electric circuit tester is also used to check the continuity of switches, relays, diodes, fuses, and circuits..
3.【Component Activation and Testing】For professionals or car enthusiasts, this continuity tester is a great tool. The automotive short circuit tester can activate the components in/out of the vehicle's electrical system. The LED indicator and buzzer prompt can easily test and check whether the components are defective, or whether the rated current of the component is higher than the rated current of the tester..

Check Stock

Rothco Vintage Paratrooper Shorts, ACU, Large

[All Functions in Your Hand] - The KZYEE KM10 Power Scan Kit is the revolutionary circuit tester for 12-24V vehicles. You can access four precise diagnostic modes (DC Voltage, AC Voltage, Resistance and Diode), providing efficient electrical system testing, continuity testing, fault diagnosis, ground testing without fuses, component activation on and in the vehicle, and voltage detection. It is the perfect tool for all automotive electrical needs..
[Built-in Diagnostic Power] - With the press of a switch, you'll have an instant hot lead or ground lead. Use the probe tip and ground lead together to power up components in your hand. Easy to apply, it can power components such as radiator fans, starter motors, relays, window regulators, and windshield wipers. Quickly check components for continuity, identify positive, negative and open circuits, and locate shorts without wasting fuses..
[Best Repair Assistant for You] - Intuitive interface, the KM10 probe tester is an essential tool for automobile user to check system failure by themselves. The power circuit probe kit can also perform continuity and resistance checks, checking for the good and bad grounds, which a....

Check Stock

MR CARTOOL DY2201 Digital Car Tester Multimeter 500-10000 RPM Dwell Angle Temperature Meter Multimeter

【Function】Measure DC voltage and current, AC voltage and current, resistance, Duty ratio, temperature, diode transistor, continuity, dwell angle of automobile distributor contact, and motor speed.
Full range overload protection, continuity buzzer.
【Applies to】This product is suitable for automobile detection and servicing, engineering design, experimental test, production experiment, etc..
【Protection】To avoid misoperation, mechanical protection device is applied to the current measuring jack .The "mA" or "20" A socket can be opened only when selecting current for measurement, otherwise they will be blocked to effectively avoid inserting wrong probe, enhancing the product safety and life.

Check Stock

Digital Multimeter Voltmeter Battery Voltage Multi Tester AC DC Volt OHM Amp Current Meter Circuit Continuity Resistance Diode Electrical Tester with Test Leads Backlight LCD Display

Accurately Test Full Features: Accurately measures AC/DC voltage, DC current, resistance, continuity test, diode and batteries (1.5, 9, 12v battery settings), transistor HFE. A very useful multimeter tester for solving industrial and household electrical issues. Suitable for outlets, fuses, automotive circuit, testing electronics, science projects, learning electronics, appliance repair, etc..
Circuit Continuity & Safe: Audible continuity sensor checks that the circuit or wires conduct electricity. Recommended by many teachers, professionals and engineers. Volt meter tester is designed to troubleshooting with accuracy. Overload protection on all ranges to ensure long-term service life..
Easy to Use: 2.7″ large backlit LCD display, data hold, low battery indicator and kickstand make voltage meter taking and recording measurements easier than ever before. Easy to read on large back-light screen for visibility in dimly light areas..
Protective Orange Shell with Stand Built: Can be hand held or stood using its fold out stand. Digital multimeters with good protective sleeve made of kind of non-slip slightly soft plastic that will help with drop protection..
2 YEARS Warranty & Included 9V Battery: It’s a suitable voltage tester if you want to do some house....

Check Stock

6000 Counts TRMS Digital Multimeter Auto Ranging - Electrical Meter Multitester for AC/DC Current Voltage Resistance Capacitance Frequency/Duty,Diode/hFE, NCV, Temperature with Auto Backlight

✔AUTO RANGING & WIDE RANGE for accurate measurement of AC/DC Volt 600V, AC/DC Amp current 10A, Resistance 60m ohm, continuity, capacitance, frequency hz /duty, specific 1.5V/9V battery test, Data Hold, NCV (non-contact ac voltage detector), temperature test (℉/℃). 4 digits (6000 counts) high accuracy TRMS multitester..
✔4 MOUNTING OPTIONS DMM to free your hands for taking measurement, including fold-out kickstand, magnet, wrist/hang strap for wearing around your wrist or hanging. Strong magnetic allows you to stick the VOM to a metal object: water heater, chasis, breaker box, etc. Portable small size voltmeter with large display, easy to carry along in tool bag..
✔AUDIBLE VISUAL CONTINUITY TEST with alarm buzzer and indicator light, quick and neat response in continuity tone, handy for test on diodes and LEDs, hFE, capacitors and resistors. Ideal multimeter for electronic, hobbyist, HVAC, household, automotive, industrial electrical troubleshoot.
✔AUTO LCD BACKLIGHT + AUTO SHUT OFF after 15 minutes of inactivity to save your battery, manual power off optional. Automatic LCD backlit screen based on ambient brightness condition, and lights up dial light indicator for easy reading in dim area..
✔w/ ALL ACCESSORIES YOU NEED for this DVOM: multi....

Check Stock

Fieldpiece Compact HVACR Clamp Multimeter SC260 – True RMS Clamp Meter with Temperature, Capacitance & Backlight

The HS36 works with all Fieldpiece accessory heads enabling the user to test a wider variety of parameters from a single meter..
Auto Ranging: The HS36 is an auto ranging meter and is very accurate..
Non-Contact Voltage Indication: The NCV function is sensitive enough to detect 24VAC on thermostats..
High Voltage and Continuity Indicators: The Hi-V LED/Beeper for circuits over 30V. The continuity LED and beeper tells you if a circuit is open or closed..
Microamps for measuring the flame diode current in a heater control -- Capacitance for motor-start and motor-run capacitors..

Check Stock