ReviewsCurrent Comparator

5PCS Vibration Sensor Module SW-420 Alarm Switch DIY Normally Closed High Sensitive Efficient Module for Arduino

Using SW-420 normally closed type vibration sensor.
Comparator output - clean signal - good strong driving waveform - ability -003e 15mA.
Display format: digital switching output (0 and 1).

Check Stock

uxcell Angle Sensor Module SW-520D Ball Switch Tilt Sensor Module for Arduino

Output form: digital switch output (0 and 1).
Sensor can sense changes in body angle. A fixed bolt holes for easy installation..
Using the highly sensitive switch SW-520D as the angle sensor. Using a wide voltage LM393 comparator..
The comparator output, signal clean, good waveform, driving ability is strong, for more than 15 ma..
For purchasing electronic modules should have some basic knowledge of electronics. Most modules only provide descriptions or information. Beginners should be cautious..

Check Stock

uxcell Angle Sensor Module SW-520D Golden Ball Switch Tilt Sensor Module for Arduino 5pcs

Output form: digital switch output (0 and 1).
Sensor can sense changes in body angle. A fixed bolt holes for easy installation..
Using the highly sensitive switch SW-520D as the angle sensor. Using a wide voltage LM393 comparator..
The comparator output, signal clean, good waveform, driving ability is strong, for more than 15 ma..
For purchasing electronic modules should have some basic knowledge of electronics. Most modules only provide descriptions or information. Beginners should be cautious..

Check Stock

Taidacent AD8015 Wideband/Differential Output Transimpedance Amplifier Module Single-Ended to Differential 240M Bandwidth 155Mbps Data Rate

The AD8015 is a wide bandwidth, single supply transimpedance amplifier optimized for use in a fiber optic receiver circuit. It is a complete, single chip solution for converting photodiode current into a differential voltage output..
The 240 MHz bandwidth enables AD8015 application in FDDI receivers and SONET/SDH receivers with data rates up to 155 Mbps. This high bandwidth supports data rates beyond 300 Mbps. The differential outputs drive ECL directly, or can drive a comparator/ fiber optic post amplifier..
In addition to fiber optic applications, this low cost, silicon alternative to GaAs-based transimpedance amplifiers is ideal for systems requiring a wide dynamic range preamplifier or singleended to differential conversion..
Application: Fiber Receiver: SONET/SDH, FDDI, Fibre Channel Stable High Capacitance Detector.

Check Stock

MC14046BCP Phase Lock Loop (PLL) IC 1.9MHz 1 16-DIP (0.300\

The CD4046B CMOS Micropower Phase-Locked Loop (PLL) consists of a low-power, linear voltage-controlled oscillator (VCO) and two different phase comparators having a common signal-input amplifier and a common comparator input..
Very low power consumption: 70 µW (typ.) at VCO, VCO inhibit control for ON-OFF keying and ultra-low standby power consumption fo = 10 kHz, VDD = 5 V, Source-follower output of VCO control input (Demod. output), 100% tested for quiescent current at 20 V.
Operating frequency range up to 1.4 MHz (typ.) at VDD = 10 V, RI = 5 k, High VCO linearity: 003c1% (typ.) at VDD = 10 V, 5-V, 10-V, and 15-V parametric ratings.
Low frequency drift: 0.04%/°C (typ.) at VDD = 10 V, Choice of two phase comparators: Exclusive-OR network (I) Edge-controlled memory network with phase-pulse output for lock indication (II), Zener diode to assist supply regulation, Standardized, symmetrical output characteristics, Meets all requirements of JEDEC Tentative Standard No. 13B, "Standard Specifications for Description of 'B' Series CMOS Devices".
A Versatile Building Block for Micropower Digital and Analog Applications, Example Applications: FM demodulator and modulator, Frequency synthesis and multiplication, Frequency discriminator, Data synchronization....

Check Stock

Bwsensing Tilt Sensor BWK228 Dual Axis Inclinometer with 0.02 Degree Resolution and 0.2 Degree Accuracy 4-20mA 0-20mA 0-24mA Analog Output for Optional

【Basic Features】: The working voltage of 3V - 5V.
Output form: digital switch output (0 and 1).
【Easy installation】: Sensor can sense changes in body angle. A fixed bolt holes for easy installation..
【High sensitivity】: Using the highly sensitive switch SW-520D as the angle sensor. Using a wide voltage LM393 comparator..
【Good overall performance】: The comparator output, signal clean, good waveform, driving ability is strong, for more than 15 ma..
【Item Condition】: The module is 100% made of original electronic components, and the product is a brand new product, you can buy it with confidence.

Check Stock

YOHAWJAN Bicycle Speedometer Waterproof Wireless Bike Computer Bike Odometer with LCD Display & Multi-Functions

...an read your statistics from the bicycle speedometer easily..
【Multi-functions】The wireless bike speedometer can record the average speed, maximum speed, current speed (measured in mph/ kph unit), riding time, to keep track of your cycling more effectively and you can find more functions such as scan mode, speed comparator, maintenance, clock, etc..
【Auto Wake-up Function】the wireless bike computer is designed with an automatic power-on/ off function.
It can automatically wakes from sleep mode.
The bike computer will enter into sleep mode if showing no signals for 300 seconds and will automatically turn back to the previous mode with all the data collected once any signal is received..
【Easy to Install】Simple installation that only takes a few minutes. Easy to navigate interface with only two buttons to access all measurements. Great basic functions of the speedometer and very specific tire size that enable accurate calculations..
【A Wide Range of Applications】The wireless bicycle computer can be applied to most types of bicycles, for instance, mountain bikes, road bikes, electronic bikes, folding bikes. If the computer display, sensor, and magnet can be installed within the specified distances device should be fully compatible..

Check Stock

AITIAO 3Pcs GY-530 VL53L0X Laser Ranging Sensor Module GY-530 VL53L0X Time-of-Flight (ToF) Laser Distance Sensor 2.8-5V I2C IIC Interface Communication

Using the sensitive type photosensitive resistance sensor, high sensitive.
With adjustable potentiometer can adjust and detect the brightness of the light.
The output format: Digital switching output (0 and 1)..
Waveform of the comparator output signal is good,strong driving ability, for more than 5mA..
Applications: It is widely used in light intensity detected,light brightness sensors,smart car module..
Package Included:12 X Photosensitive Resistance Sensor Module.

Check Stock

1pcs/lot Brand CD4HC7046AE 74HC7046 DIP-16 Phase-Locked Loop

The CD4046B CMOS Micropower Phase-Locked Loop (PLL) consists of a low-power, linear voltage-controlled oscillator (VCO) and two different phase comparators having a common signal-input amplifier and a common comparator input..
Very low power consumption: 70 µW (typ.) at VCO, VCO inhibit control for ON-OFF keying and ultra-low standby power consumption fo = 10 kHz, VDD = 5 V, Source-follower output of VCO control input (Demod. output), 100% tested for quiescent current at 20 V.
Operating frequency range up to 1.4 MHz (typ.) at VDD = 10 V, RI = 5 k, High VCO linearity: 003c1% (typ.) at VDD = 10 V, 5-V, 10-V, and 15-V parametric ratings.
Low frequency drift: 0.04%/°C (typ.) at VDD = 10 V, Choice of two phase comparators: Exclusive-OR network (I) Edge-controlled memory network with phase-pulse output for lock indication (II), Zener diode to assist supply regulation, Standardized, symmetrical output characteristics, Meets all requirements of JEDEC Tentative Standard No. 13B, "Standard Specifications for Description of 'B' Series CMOS Devices".
A Versatile Building Block for Micropower Digital and Analog Applications, Example Applications: FM demodulator and modulator, Frequency synthesis and multiplication, Frequency discriminator, Data synchronization....

Check Stock

Juried Engineering CD4046BE CD4046B CD4046 CMOS Micropower Phase-Locked Loop Breadboard-Friendly IC DIP-16 (Pack of 5)

The CD4046B CMOS Micropower Phase-Locked Loop (PLL) consists of a low-power, linear voltage-controlled oscillator (VCO) and two different phase comparators having a common signal-input amplifier and a common comparator input..
Very low power consumption: 70 µW (typ.) at VCO, VCO inhibit control for ON-OFF keying and ultra-low standby power consumption fo = 10 kHz, VDD = 5 V, Source-follower output of VCO control input (Demod. output), 100% tested for quiescent current at 20 V.
Operating frequency range up to 1.4 MHz (typ.) at VDD = 10 V, RI = 5 k, High VCO linearity: 003c1% (typ.) at VDD = 10 V, 5-V, 10-V, and 15-V parametric ratings.
Low frequency drift: 0.04%/°C (typ.) at VDD = 10 V, Choice of two phase comparators: Exclusive-OR network (I) Edge-controlled memory network with phase-pulse output for lock indication (II), Zener diode to assist supply regulation, Standardized, symmetrical output characteristics, Meets all requirements of JEDEC Tentative Standard No. 13B, "Standard Specifications for Description of 'B' Series CMOS Devices".
A Versatile Building Block for Micropower Digital and Analog Applications, Example Applications: FM demodulator and modulator, Frequency synthesis and multiplication, Frequency discriminator, Data synchronization....

Check Stock

Juried Engineering CD4046BE CD4046B CD4046 CMOS Micropower Phase-Locked Loop Breadboard-Friendly IC DIP-16 (Pack of 10)

The CD4046B CMOS Micropower Phase-Locked Loop (PLL) consists of a low-power, linear voltage-controlled oscillator (VCO) and two different phase comparators having a common signal-input amplifier and a common comparator input..
Very low power consumption: 70 µW (typ.) at VCO, VCO inhibit control for ON-OFF keying and ultra-low standby power consumption fo = 10 kHz, VDD = 5 V, Source-follower output of VCO control input (Demod. output), 100% tested for quiescent current at 20 V.
Operating frequency range up to 1.4 MHz (typ.) at VDD = 10 V, RI = 5 k, High VCO linearity: 003c1% (typ.) at VDD = 10 V, 5-V, 10-V, and 15-V parametric ratings.
Low frequency drift: 0.04%/°C (typ.) at VDD = 10 V, Choice of two phase comparators: Exclusive-OR network (I) Edge-controlled memory network with phase-pulse output for lock indication (II), Zener diode to assist supply regulation, Standardized, symmetrical output characteristics, Meets all requirements of JEDEC Tentative Standard No. 13B, "Standard Specifications for Description of 'B' Series CMOS Devices".
A Versatile Building Block for Micropower Digital and Analog Applications, Example Applications: FM demodulator and modulator, Frequency synthesis and multiplication, Frequency discriminator, Data synchronization....

Check Stock