ReviewsDbm Imports

HiLetgo 0.1-500MHz AD831 High Frequency RF Mixer Drive Amplifier Module Board HF VHF/UHF

Linksys WRT54G2 Wireless-G Broadband Router General Features:.
Standards: IEEE 802.3, IEEE 802.3u, IEEE 802.11g, IEEE 802.11b Buttons Reset, Wi-Fi Protected Setup.
Cabling Type CAT5 Number of Antennas 2 Internal Antennas RF Power (EIRP) in dBm 18 dBm.
UPnP able/cert Able Security Features Stateful Packet Inspection (SPI) Firewall, Internet Policy.
Wireless Security Wi-Fi Protected Access 2 (WPA2), WEP, Wireless MAC Filtering.

-10dBm LO Power Consumption: Provides +24dBm third order intercept point, can achieve -10dBm LO power consumption, without high power LO drivers, there are no corresponding shielding and isolation problems, can improve system performance and reduce costs.
Wide Application: Suitable for applications such as RF‑IF down conversion in HF and VHF receivers, second mixer in base stations, DC baseband conversion, quadrature modulation and demodulation, and Doppler detection in imaging.
10.3dB SSB Noise Figure at 70MHz: With the output amplifier and optimal source impedance of this mixer module, the SSB noise figure is 10.3dB at 70MHz. There is no insertion loss, no external duplexer, and no passive termination.
Single Power Supply: The mixer module is designed to be powered by a single power supply, and the RF, IF and LO ports have DC isolation capacitors for easy use.
Low Distortion and Wide Dynamic Range: AD831 is a low distortion, wide dynamic range, single chip mixer, very practical.

【Important Data】: SSB noise figure (NF) of 9.75 dB--Input IP3: 28.5 dBm--Input P1dB: 13.3 dBm--Typical LO drive: 0 dBm--Power conversion gain of 1.8 dB.
【Wild Used】: This 5V double balance up and down frequency mixer module is widely used for cellular base station receivers, Radio link down converters, Broadband block conversion, Instrumentation.
【Low Power】: Our 130mA 50 Ohms Balun coil coupling frequency conversion mixer features adjustable bias for low power operation, so you can trust and use this RF mixer inverter with confidence.
【Wonderful Components】: This 5V ADL5801 double balance up and down frequency mixer module is equipped with exposed paddle, 4mm x 4mm, 24-lead LFCSP package, so it will be an ideal choice for you.
【Size】: Power supply: DC+5V@80mA(anti-reverse connection protection.)--RF_IN/RF_LO input frequency range: 10-6000Mhz--Input and output impedance: 50 ohm--Type:Input Balun coupling, Input/output Balun coupling(Optional)--Weight: Approx.15g/0.5oz.

9KHz-2.1GHz, Phase Noise98dBc/Hz, RBW 1Hz-1MHz, Min. DANL -161dBm/Hz, Total Amplitude Accuracy0.7dB, 10.1 lnch WVGA(1024x600) Touch Screen.
Includes tracking generator and pre-amplifier.
-161 dBm/Hz Displayed Average Noise Level (DANL).

-10dBm LO Power Consumption: Provides +24dBm third order intercept point, can achieve -10dBm LO power consumption, without high power LO drivers, there are no corresponding shielding and isolation problems, can improve system performance and reduce costs.
Wide Application: Suitable for applications such as RF‑IF down conversion in HF and VHF receivers, second mixer in base stations, DC baseband conversion, quadrature modulation and demodulation, and Doppler detection in imaging.
Low Distortion and Wide Dynamic Range: AD831 is a low distortion, wide dynamic range, single chip mixer, very practical.
10.3dB SSB Noise Figure at 70MHz: With the output amplifier and optimal source impedance of this mixer module, the SSB noise figure is 10.3dB at 70MHz. There is no insertion loss, no external duplexer, and no passive termination.
Single Power Supply: The mixer module is designed to be powered by a single power supply, and the RF, IF and LO ports have DC isolation capacitors for easy use.

-10dBm LO Power Consumption: Provides +24dBm third order intercept point, can achieve -10dBm LO power consumption, without high power LO drivers, there are no corresponding shielding and isolation problems, can improve system performance and reduce costs.
Single Power Supply: The mixer module is designed to be powered by a single power supply, and the RF, IF and LO ports have DC isolation capacitors for easy use.
10.3dB SSB Noise Figure at 70MHz: With the output amplifier and optimal source impedance of this mixer module, the SSB noise figure is 10.3dB at 70MHz. There is no insertion loss, no external duplexer, and no passive termination.
Wide Application: Suitable for applications such as RF‑IF down conversion in HF and VHF receivers, second mixer in base stations, DC baseband conversion, quadrature modulation and demodulation, and Doppler detection in imaging.
Low Distortion and Wide Dynamic Range: AD831 is a low distortion, wide dynamic range, single chip mixer, very practical.

Frequency band: 15MHz-2.7GHz and 4.85GHz-6.1GHz.
Graphics LCD 128x64 pixels, great visibility outdoors.
PC Windows client supports Windows XP/Vista/Win7 both 32 and 64bits.
Audio Analysis by means of an acoustic signal proportional to the modulation frequency.

Single Power Supply: The mixer module is designed to be powered by a single power supply, and the RF, IF and LO ports have DC isolation capacitors for easy use.
10.3dB SSB Noise Figure at 70MHz: With the output amplifier and optimal source impedance of this mixer module, the SSB noise figure is 10.3dB at 70MHz. There is no insertion loss, no external duplexer, and no passive termination.
Low Distortion and Wide Dynamic Range: AD831 is a low distortion, wide dynamic range, single chip mixer, very practical.
-10dBm LO Power Consumption: Provides +24dBm third order intercept point, can achieve -10dBm LO power consumption, without high power LO drivers, there are no corresponding shielding and isolation problems, can improve system performance and reduce costs.
Wide Application: Suitable for applications such as RF‑IF down conversion in HF and VHF receivers, second mixer in base stations, DC baseband conversion, quadrature modulation and demodulation, and Doppler shift detection in imaging.