ReviewsEeprom Reader

SunFounder Mega 2560 R3 ATmega2560-16AU Board Bundled with R3 Board and Ethernet Shield W5100 for Arduino

  • The mega 2560 R3 Board is 100% compatible with Arduino. Powered via the USB connection or with an external power supply. The power source is selected automatically..
  • The ATmega2560-16au has 256 KB of flash memory for storing code (of which 8 KB is used for the bootloader), 8 KB of SRAM and 4 KB of EEPROM (which can be read and written with the EEPROM library). Comes preburned with a bootloader that allows you to upload new code to it without the use of an external hardware programmer. It communicates using the original STK500 protocol (reference, C header files)..
  • This version is optimized in the original version, both to ensure consistent and compatible with the original, but also easy to use..
  • R3 board compatible with Arduino. The board for Arduino use ATMEGA16U2 chip, Faster transfer rates and more memory.R3 board control using r3 ATmega328P chip. Includes new pin configuration (SCL, SDA, IOREF).Clearly print on the female header connector, more precise and easier to use the wire..
  • With this Ethernet Shield, for Arduino board can be used to connect to internet. Can be used as server or client. Directly plug puzzle board, no soldering required. It is directly compatible with Arduino official Ethernet Library. It adds a micro-SD card slot, which can be ....
Check Stock

Adafruit Ultimate GPS Logger Shield - Includes GPS Module

  • Easy-to-sew or solder pads for embedding in your wearable project.
  • Low cost enough, you can use one for every weekend project.
  • Ultra low power, draws only 9 mA while running.
  • ATtiny85 on-board, 8K of flash, 512 byte of SRAM, 512 bytes of EEPROM.
Check Stock

Teensy LC USB Development Board Without Pins

  • 32 bit ARM Cortex-M0+ 48 MHz CPU 62kB Flash Memory, 8kB RAM, 1/8(emu)kB EEPROM.
  • 13 High Resolution Analog Inputs 27 Digital I/O Pins (NOT 5V Tolerant).
  • 10 PWM outputs 7 Timers for intervals/delays, separate from PWM.
  • 3 UARTs (serial ports) SPI, I2C, & I2S I2S (for high quality audio interface).
  • 4 Lightweight DMA channels Touch Sensor Inputs.
Check Stock

Emergency Wall Telephone Pre-programmed to Auto Dial 911 - RED

  • Auto dials any pre-programmed telephone number (911 as default).
  • Works on any analog phone line (PSTN, VOIP) that is FSK or DTMF compatible.
  • Retains programming even if disconnected from phoneline (EEPROM technology)..
  • Telephone line powered (no external power required)..
  • Easy to install and re-program (Comes with wallplate and do-it-yourself programming instructions).
Check Stock

Robox 3D Printer Dual Extruder High Definition

  • Headlock System: Allows quick change of print head.
  • Quick Fill Dual Nozzle Technology: Detailed perimeter nozzle (0.3mm).
  • Smart Reel System: Automatic material recognition.
  • wide range of materials and colors available.
  • Smart Extruder System: Supports single or dual extruders.
  • Fully automatic material loading/unloading.
  • Automaker Software: East to use interface.
Check Stock

DIYmall 6M GPS Module with EEPROM for MWC/AeroQuad with Antenna for Arduino Flight Control Aircraft

  • When you test the GPS module, pls kindly note that you need test it in outdoor wide plain place, not indoor..
  • The 6M GPS module with ceramic destined antenna, super signal,can be quickly positioned..
  • The 6M GPS module uses serial comms to the host. It is setup to use 9600baud by default..
  • LED signal indicator,With data backup battery..
  • EEPROM power down to save the configuration parameters data..
Check Stock

HiLetgo GY-NEO6MV2 NEO-6M GPS Flight Controller Module 3V-5V with Super Strong Ceramic Antenna for Arduino EEPROM APM 2.5

  • Module with a ceramic antenna, superior signal.
  • Save the configuration parameter data EEPROM Down.
  • Default baud rate: 9600, Interface: RS232 TTL.
  • Compatible with a variety of flight control module.
Check Stock

Diodes Incorporated Microprocessors - MPU ARM Cortex-A5 MPU 32bit, Video decoder (ATSAMA5D44A-CU)

  • 1 Pcs ATTINY84A-PU 8-bit Microcontroller with 8K Bytes In-System Programmable Flash..
  • MCU MICROCONTROLLER, 8 BIT, ATTINY, 20MHZ, DIP-14..
  • 8K Bytes of In-System, Self-programmable Flash Program Memory.
  • 512 Bytes of In-System Programmable EEPROM.
  • New and original ,quality ensured , no-hassle refund if you are not 100% satisfied!.
Check Stock

SCM / 24/93 Series EEPROM Memory Chips USB PIC Programmer SP200SE/SP200S Enhanced Version

  • Support WIN98, WINME, WIN2000, WINXP, VISTA, WIN7 and other 32-bit and 64-bit operating systems.
  • Support hundreds of types of single-chip microcomputer and EEPROM burn of Atmel, Microchip, SST, ST, WINBOND, STC, MSP430 and other brands.
  • USB port power supply, front-line data power supply, convenient for laptop users.
  • ISP interface USES the standard IDC10PIN interface recommended by Atmel company.
Check Stock

GY-NEO6MV2 GY-GPS6MV2 NEO-6M GPS Module with Flight Control APM2.5 for Arduino

  • EEPROM save the configuration parameter data when power down.
  • With data backup battery The LED signal lights The default baud rate: 9600.
  • Compatible with various flight control modules.
  • Module size 25 x 35 mm (0.98'' x 1.37'') Antenna size: 25 x 25 mm (0.98''x 0.98'').
  • Package Content: 1 x GY-NEO6MV2 GPS Module.
Check Stock

LILYGO TTGO T-Beam V1.1 ESP32 915Mhz WiFi Bluetooth Module ESP32 GPS NEO-6M SMA 18650 Battery Holder with OLED…

  • Chipset: ESPRESSIF-ESP32 (Wi-Fi & Bluetooth compatible).
  • GPS Modules: NEO-6M, 3V-5V power supply Universal Destined module with ceramic antenna, signal super Save the configuration parameter data EEPROM....
  • Lora: Support Lora network,antenna connector is RG316.
  • OLED: It has a 0.96 inch screen and a high resolution of 128 * 64.
Check Stock