ReviewsEngine Oil Pump Pickup Tube O ring

Racing Power Company R9729 Orange Drag Race Oil Pan for Big Block Chevy

  • Brand New Weiand Oil Pan Kit, 7 Quarts, Gold Zinc Finish, Fits 1986-2002 Small Block Chevy Drag Racing Engines (Holley Part #5003WND).
  • Fits: 1986-2002 Small Block Chevy Drag Racing Engines | Includes: Application specific oil pan | Oil pan gasket | Oil pump pickup | Pan mounting bolt kit.
  • Features: Trap door baffles keep oil under control during hard acceleration | Increased oil capacity to keep high performance engine oil systems fed properly | Kit includes Pan, Pump Pickup, Pan Gasket, and pan mounting bolt kit.
  • Specs: Application: 1986-2002 Small Block Chevy | Brand: Weiand | Crank Scraper Included: No | Dipstick Location: Passenger | Emission Code: 5 | Finish: Gold Zinc | Material: Stamped Steel | Oil Pan Capacity: 7 Quarts | Oil Pan Depth: 8.125" | Oil Pan Type: Fabricated | Product Type: Oil Pan Kit | Sump Location: Rear | Windage Tray Included: No.
  • NOTE: Kit designed to work with standard volume oil pumps..
Check Stock

Vevitts 80w Oil Change Extractor Pump 12V Oil Extractor Pump for Changing Diesel Fluid Scavenge Suction Oil Transfer Pump Kits for Jet Ski, Truck, RV, ATV, Boat (Red)

  • 【Instructions for use】1. Please pay attention to the direction of the inlet and outlet, the positive and negative poles and the locking hose lock before use.
  • 2. Please start the vehicle and heat the engine oil to 40-60 degrees for about 5 minutes, otherwise, the oil change pump may have low suction or get stuck. 3. CAN NOT be used to extract water, gear oil (too viscous) or flammable liquid (fuel, gasoline,kerosene,etc.)..
  • 【Complete Diesel Change Pump Kit】The oil transfer pump is mini but powerful. With 4.6ft Outlet tube & 4ft Inlet tube, the 8.2ft long battery clamps makes the extractor pump kit possible for being used at large range. The 2 hoops are used to tighten the tubes to avoid oil spilling..
  • 【12V 80w Oil Extractor Pump】Oil change pump, a great helper for quick and clean oil changing and transfer, all parameter is verified by multiple test. Diesel Flow Rate: 3.5L/min, Engine Oil Flow Rate(40-60℃): 1L/min, Inlet Tube Length: 1.2m/47.2in, Outlet Tube Length: 1.4m/55.1in, Voltage: 12V, Maximum current: 5A..
  • 【Premium Quality】We use pure copper for motors.Good conductivity, corrosion resistance and rust resistance, effectively avoid leakage or short circuit. Instead of manual operation, it can help you change oil quickly and cleanly....
Check Stock

Z Whip LS Oil Pump Pickup Tube Girdle Pipe Hold Down Brace Support Billet Bracket MADE IN THE USA Compatible with GM Chevy LS Series Engines LSX LS1 LS3 LS2 LQ4 LS6 LQ9 5.3L 6.0L 6.2L

  • Compatible with all LS Series Engines 1997-2014 (GEN. III/IV small block chevy).
  • The factory oil pickup tube on LS engines is only secured by one bolt. This can potentially lead to a poor seal on the oil pump. Our Billet aluminum Oil pump girdle solves the issue by placing a clamp on both sides of the tube, securely holding it in place..
  • DOES NOT fit any LS oil pickup tube with welded flanges (GM # 12608593, Holley 302-1 and similar tubes). DOES NOT fit pickup tubes with two screw holes on their flange (Holley 302-2 tube and similar tubes)..
  • Proudly made in the USA from Aerospace Grade Billet Aluminum.
  • We are an AS9100D and ISO 9001:2015 Certified Manufacturer. Parts we produce fly at 30,000 feet where failure is not an option..
Check Stock

Engine Oil Pump Pickup Tube Compatible with 2004 2005 2006 LS1/LS2 Pontiac GTO #12572654

  • New GM OEM oil pump pickup tube. This is for GTO oil pans only..
  • Oil pump pickups are specific to the oil pan..
  • If you are swapping an LS motor, you need to order a pickup specific to the pan you are using..
  • 100% Brand New , reliability and durability. Kindly do not hesitate to contact us back in the future if you feel that you need further assistance..
Check Stock

BLACKHORSE-RACING LS Billet Aluminum Oil Diverter Barbell & Oil Bypass Valve Plug & Oil Pickup Tube Hold Down Kit Compatible with GM Gen III & IV LS Engines

  • ★A 1/4-20 threaded hole in the end of the Barbell for easy removal. No more digging and prying.
  • ★Material:CNC Billet 7075 billet aluminum material for long lasting durability.
  • ★Easy to install: use the existing extra hole on the oil pump.To be sure your oil tube sits flush on the oil pump so the O-ring can do its job,....
  • ★Fitment: LS1-2-3-6-7-9-LQ4-LQ9-4.8L-5.3L-6.0L-6.2L L92 LS4 L99 LSA and more.
  • ★Package Includes:1x Oil Diverter Barbel,1xOil Bypass Valve Plug ,1x Oil Tube Hold Down,Includes High Strength 10.9 Bolt,As the picture shown.
Check Stock

DNJ EK715E Engine Rebuild Kit for 2006-2011 / Subaru/Forester, Impreza, Legacy, Outback / 2.5L / SOHC / H4 / 16V / 2458cc / EJ253

  • THIS KIT INCLUDES: Piston Set, Piston Ring Set, Main Bearings Set, Rod Bearings Set, Full Gasket/Sealing Set.
  • FITS: 06-11 Subaru / Impreza, Forester, Legacy, Outback 2.5L H4 SOHC Naturally Aspirated EJ253.
  • FITMENT NOTES: w/o Oil Pump & Timing Belt Or Timing Kit, w/o Upper Int. Set, Rod Bearing w/ 52mm Journal.
  • You are assured to receive a worldwide proven Engine Rebuild Kit quality part with OE quality fit and performance..
  • IMPORTANT: This Engine Kit is in STANDARD SIZE in all of its components. If you need oversized Pistons, Piston Rings, Rod Bearings or Main Bearings, send us a message prior ordering, indicating the correct size you need, so our customer service team can confirm availability. If we do not receive communication from you, everything will be sent in STANDARD SIZE by default.
Check Stock

The ROP Shop | 2400 PSI Power Pressure Washer Water Pump for Excell & Devilbiss VR2400, VR2500

  • Includes - (1) Vertical Pressure Washer Pump with Chemical Injector, Unloader Valve, Thermal Release Valve & Outlet Tube (come installed).
  • This pump is for vertical gas engine driven units. In some instances, the pump may need to be removed to change engine oil. The mounting flange provides a convenient connection to most 7/8” diameter shaft vertical gas engines in 4.5-7 HP. The pump has a hole in the leg for draining the engine oil. The pump includes a built-in pressure control valve, downstream chemical injection system and thermal relief valve.
  • This has the outlet facing the front. Some specific pressure washers may require longer bolts and spacers to mount the pump to your engine. These bolts and spacers are NOT included, but may be purchased at your local hardware store. Common bolt sizes: Two - 5/16" 18 x 2 1/2", One - 5/16" 18 x 3 1/2".
Check Stock

High Pressure Oil Pump Kit with Base Gasket, HPOP Upgraded Full Replacement for 1994.5-2003 Ford Powerstroke Diesel Engine 7.3L F250-F550, E250-E450, Excursion (Pack of 14 Set)

  • (Specifics) This is a set of repair kit prevents oil leaks in the engine bay. It includes the components you to replace all seals and O-rings on your high-pressure oil pump and correctly reinstall the pump..
  • (Compatibility) Compatible with 1994.5-2003 Ford Vehicles with a 7.3L Powerstroke Diesel Engine.
  • (Interchangeable Part #)Replacement for F6TZ-9417-AA, 2C3Z-9G804-AB, 4C3Z-9C977-AA.
  • (Tips) Professional Installation is Highly Recommended (No Instruction Included).
  • (After-Sale Service) 1 Year Warranty guaranteed, and friendly Customer Service available..
Check Stock

Diesel Water Parking Heater Hydronic Heater 5KW 12V Boat Caravan Motorhome Truck Camper Trailer Remote Control Diesel Water Heater Kit

  • PROTECT YOUR ENGINE ➤ The water heating type parking heater uses automobile coolant to exchange heat, preheats the engine and the cab, solves the problem of difficult engine startup at low temperature, greatly reduces air-cooled wear caused by low temperature startup, and extends engine life by more than 30%..
  • LESS FUEL PREHEATING ➤ Compared with cold-start engine preheating, the water heating parking heater preheating consumes less fuel. In the cold winter, you can warm up the engine and cab before getting on the car to drive away the severe cold. Improve the driving environment and no longer need a warm store..
  • FULL INSTALLATION SET ➤ 1 x Water Parking Heater, 1 x Auto Switch And Remote Control (Batteries Not Included), 1 x Water Pump, 1 x Wiring Harness, 1 x Tube, 1 x Oil Pump, 1 x Pump Holder, 1 x Fuel Filter, 1 x Oil Tube, 1 x Big Elbow, 1 x Small Elbow, 1 x Air Inlet Hose, 1 x Exhaust Pipe, 1 x Exhaust Silencer, 1 x Hose Holder, 1 x Cross, 1 x Air Filter, 6 x Short Pipe, 1 x Oil Extractor, 12 x Hose Clamps, 12 x Small Hose Clamp, 5 x Screwiv, 4 x Screw, 1 x Iron Stent..
  • TECHNICAL PARAMETERS ➤ Material: Metal &....
Check Stock

Melling K-83 Oil Pump Repair Kit

  • ✅Description: Complete kit to rebuild your pwc jet pump. Includes all required bearings, seals, and o-rings. Exact kit you will receive is pictured..
  • ✅FITS: SEA-DOO 2004-2017 GTX 4-TEC ALL MODELS, 2006-2017 GTI 4-TEC ALL MODELS, 2005-2017 RXP 4-TEC ALL MODELS, 2005-2017 RXT 4-TEC ALL MODELS, 2004-2006 SPORTSTER 155, 2004-2008 SPEEDSTER..
  • ✅Made from high-quality materials for ultimate durability. Manufacture to meet or exceed OE standard.
  • ✅Package Includes: 1 x OIL SEAL 293-200-089, 1 x OIL SEAL 293-200-086, 1 x O-RING 293-300-090, 1 x O-RING 293-300-079, 1 x BEARING 267-000-030, 2 x O-RING 293-300-086, 2 x O-RING 293-300-013..
  • ✅1 Year Unlimited-mileage Quality Guarantee.
Check Stock

BOYISEN Oil Change Pump Extractor 12v 60W Oil Extractor Pump Diesel Fluid Transfer Scavenge Suction Pump Oil Quick Changer for Car, Boat, Marine, Motorbike, Truck, RV, ATV(Yellow)

  • 【Efficient Electric Pump】Oil change pump, a great helper for quick and clean oil changing and transfer, all parameter is verified by multiple test. Diesel Flow Rate: 1.5L/min, Engine Oil Flow Rate(40-60℃): 0.3L/min, Inlet Tube Length: 1.2m/47.2in, Outlet Tube Length: 1.4m/55.1in, Voltage: 12V, maximum current: 5A, maximum power: 60W.
  • 【NOTES】A, This oil transfer pump CAN NOT transfer WATER, GASOLINE, PETROL, FUEL or FLAMMABLE LIQUID. B, Please DO NOT misplace the direction of import and export, positive and negative poles and secure the hose clamps. C, Heat up your engine oil to 104°F-140°F before pumping D, We tested oil pump before shipping, there might be little oil stain in the pump, kindly understand. E, To make it last longer, it’s recommended to keep a little oil inside when the extractor pump is not in use..
  • 【Premium Quality】The quality of oil change pump extractor varies widely. We are using pure copper for the motor and alligator. Good electrical conductivity, corrosion resistance and rust free, effectively avoid leakage or short circuit. Overheat protection will cut off the power supply automatically for safety.
  • 【What You Get】The diesel change pump come with 2 outlet hose, 2 inlet hose, 4 hose locks and 2 battery clips. A....
Check Stock