ReviewsF32ttl74alto

Analog Multiplexer Single 8:1 ñ9 Volt 20 Volt 16-Pin Plastic DIP Tube

  • The internal switch is bidirectional, with a low on resistance and off leakage, and to prevent talk, please turn off the switch first and then on..
  • It is suitable for digital and analog signals (voltage cannot be higher than VCC) and can be connected in either direction. To control this, please connect the four digital outputs to the address selection pin of the chip (SO-S3) and send it the binary address of the desired channel..
  • Drive it to a high level, and it will completely disconnect the common pins (all switches are disconnected)..
  • Because the multiplexer can also process digital signals, you can use it to transfer TTL-level serial data to multiple devices through pipe or transfer from multiple devices..
  • This is a very convenient 16 channel CD74HC4067 analog/digital multiplexer/demultiplexer..
Check Stock

650nm 660nm Adjusted Red Laser Line Dot Cross Laser Diode Module 3V-5.5V 100mW Laser Dot/Line/Cross Module Focusable 13mmx42mm with US Power Adapter and Heatsink

  • Wavelength: 532nm, Output power: 95-120 mW.
  • Operating voltage: DC 12V, Operating Current: 003c500mA.
  • Reverse polarity protection: Yes, with automatic identification of positive and negative.
  • Laser Module Size:74 x 30 x 30mm , Circuit Board size:71.5 x 35 x 20mm.
Check Stock

20PCS CD4053 CD4053B CD4053BE DIP-16 Analog Multiplexer IC

  • Process Digital Signals: Because the multiplexer can also process digital signals, you can use it to transfer TTL level serial data to multiple devices through pipe or transfer from multiple devices..
  • High Level: Drive it to high level, and it will completely disconnect the common pins (all switches are disconnected)..
  • Scope of Application: It is suitable for digital and analog signals (voltage cannot be higher than VCC) and can be connected in either direction. To control this, please connect the four digital outputs to the address selection pin of the chip (SO-S3) and send it the binary address of the desired channel..
  • 16 Channel Analog Multiplexer: This is a very convenient 16 channel CD74HC4067 analog, digital multiplexer, demultiplexer..
  • Bidirectional Internal Switch: With a low on resistance and off leakage, and to prevent talk, please turn off the switch first and then on..
Check Stock

Godox AD200 200Ws 2.4G TTL Speedlite Flash Strobe 1/8000 HSS Monolight with 2900mAh Lithium Battery and Bare Bulb Flash Head to Provide 500 Full Power Flashes Recycle in 0.01-2.1 Second

  • Godox AD200 Pocket Flash Speedlite has tiny Body, Interchangeable bare bulb flash heads and speedlite flash head, fast recycle time up to 0.01-2.1s, fast duration up to 1/13000s, When using Godox 2.4G wireless X system. Godox AD200 Speedlite Monolight is compatible with Canon E-TTL, Nikon i-TTL and Sony TTL etc..
  • 200Ws, GN60(m ISO 100, with AD-S2 standard reflector, @28mm) and GN52 (m ISO 10, @35mm). Stable color temperature at 5600 ± 200K over the entire power range. Professional lithium battery pack has large capacity(14.4v/2900mAh)to provide 500 full power flashes and 0.01-2.1s fast recycling.
  • 8 steps of power adjustment (1/1~1/128)offer better light effects. Godox AD200 Speedlite Monolight is Fully support flash exposure compensation. 1/8000s high speed sync, first curtain sync, second curtain sync, modeling lamp(speedlite head only), manual flash, multi flash, C.Fn custom setting, etc..
  • GODOX AD200 pocket Speedlite Monolight has strong power with lightweight and great portability. Easily packed in your pocket. With master slave function,Godox AD200 Speedlite Monolight can be Used in combination with Godot TTL camera flashes, TTL outdoor flashes, etc..
  • Built-in Godox 2.4G wireless X system and fully support of TTL functions,Use Godox 2.4G wireless X....
Check Stock

Analog Devices ADG509ATQ Analog Multiplexer

  • 【16-channel Analog Multiplexer】- This is a very convenient 16 channel CD74HC4067 analog/digital multiplexer/demultiplexer..
  • 【Used for】- It is suitable for digital and analog signals (voltage cannot be higher than VCC) and can be connected in either direction. To control this, please connect the four digital outputs to the address selection pin of the chip (SO-S3) and send it the binary address of the desired channel..
  • 【Process Digital Signals】- Because the multiplexer can also process digital signals, you can use it to transfer TTL-level serial data to multiple devices through pipe or transfer from multiple devices..
  • 【Bidirectional Internal Switch】- The internal switch is bidirectional, with a low on resistance and off leakage, and to prevent cross talk, please turn off the switch first and then on..
  • 【Note】- Drive it to a high level, and it will completely disconnect the common pins (all switches are disconnected). Please note that the new type and old type of this product will be sent randomly, and make sure you will not mind before ordering..
Check Stock

FOVERN1 Alto Sax Saxophone Plastic Mouthpiece with Cap Metal Buckle Reed Kit for Alto Saxophone Saxophone Parts

  • Material: the alto saxophone mouthpiece cushion is made of good quality rubber, which will not harm to your health.
  • It's a good accessory of saxophone and clarinet.
  • Package contents: you will receive 4 sheets, each sheet has 8 pieces mouthpiece cushions, the size of alto mouthpiece pad is about 2.7 x 2 cm/ 1.06 x 0.78 inch, 0.8 mm in thickness.
  • Adhesive: this soft rubber pad with adhesive, which allows the teeth firmly fixed to the mouthpiece without slipping, no residue/ adhesive will be left on the instrument while peeling off.
  • Wide application: the alto mouthpiece pad can protect the saxophone flute head and protect the teeth of the players, which is a great accessory for alto/ tenor saxophones beginners and suitable for the alto saxophone, tenor saxophone, and clarinet.
  • Tip: after using these mouthpiece pads, please place it in a ventilated area and avoid direct sunlight.
Check Stock

OEM Nexperia 74HC4067PW,112, Analog Switch/Analog Multiplexer Single 16:1 24-Pin TSSOP Bulk (100 Items)

  • Because the multiplexer can also process digital signals, you can use it to transfer TTL-level serial data to multiple devices through pipe or transfer from multiple devices..
  • This is a very convenient 16 channel CD74HC4067 analog/digital multiplexer/demultiplexer..
  • The internal switch is bidirectional, with a low on resistance and off leakage, and to prevent talk, please turn off the switch first and then on..
  • It is suitable for digital and analog signals (voltage cannot be higher than VCC) and can be connected in either direction. To control this, please connect the four digital outputs to the address selection pin of the chip (SO-S3) and send it the binary address of the desired channel..
  • Drive it to a high level, and it will completely disconnect the common pins (all switches are disconnected)..
Check Stock

Alto Saxophones Mouthpieces, Saxophone Mouthpiece Kit with Metal Ligature, Saxophone Strength 2.5 One Reed, Cushions and Plastic Cap Black

  • ✅ ALL IN ONE. Include alto saxophone mouthpiece, metal ligature, plastic cap, 8 Pcs mouthpiece pads and 10 Pcs 2.5 reeds. Everything you need for your tenor saxophones..
  • ✅ EASE TO PLAY. The sax mouthpiece is made of ABS which combine perfect pitch and high-quality properties. In addition, our alto sax reeds feature a thinner vamp and unfiled cut design, offers a rich tone and allow you enjoy playing sax..
  • ✅ PERFECT PROTECTION. The alto sax mouthpiece pad can protect mouthpiece and your teeth. Also comes with a plastic cap to keep mouthpiece clean and from damage, and a metal buckle to fasten reed..
  • ✅ TOP QUALITY SAX MOUTHPIECE KIT. Our alto Sax Mouthpiece is made of eco and fresh ABS material, sax reeds are made of grown-up premium quality reed and UV disinfection for safety use, and mouthpiece pads are made from food grade silicone. All are special designed for your best experience..
  • ✅ WIDELY USE. Our alto saxophone mouthpiece kit is easy to install, use and remove, are ideal choice for professional musicians or students, educators and saxophone beginners..
Check Stock

CP2102 6 in 1 USB to TTL Serial Adapter Module USB to TTL 485 232,TTL to 232 485,RS232 to 485 + 4P Dupont Cable Jumper Wire Female to Female for Nextion Display Beitian GPS Arduino Windows

  • -cp2102 serial adapter module supports usb to ttl, usb to rs232, usb to rs485, ttl to 232, ttl to 485, 232 to 485..
  • -USB specification 2.0 not 3.0, compatible with arduino,Windows XP/7/8/10 32bits/ 64bits, Linux etc..
  • -You need to set the dip switches for different conversion purpose..
  • -Before make 6 in 1 usb to ttl module work, you need to install cp2102 driver..
  • -cp2102 usb to ttl adapter widely used with nextion display, beitian gps, esp-01s adapter, sim7000a board etc..
Check Stock

Yoklili 30 Pcs Alto Saxophone Reeds - Strength 2.5 - Bundle Pack

  • ✅ PACKAGE INCLUDES. 30 Pcs alto saxophone reeds, 0.6” x 2.75” (W x L), 2.5 in strength.
  • 16 Pcs of 0.8mm thickness saxophone and clarinet mouthpiece pads..
  • ✅ PERFECT SOUND. Alto saxophone reeds feature a thinner vamp and unfiled cut design which maintaining a richness of tone that gives body and clarity to the sound..
  • ✅ TOP QUALITY. Made of grown-up high-quality reeds and produced by digital reed-making technology for excellent flexibility. All of our alto sax reeds are UV disinfection for great safety..
  • ✅ PERFECT PROTECTION MOUTHPIECE PAD. The saxophone mouthpiece pad protects mouthpiece and teeth, as well prevents teeth from sliding. Also helps ensure maximum safety and comfort for every musician..
  • ✅ WIDELY USE. From beginners to professionals, students to teachers, classical music to jazz, the alto saxophone reeds are your ideal choice..
Check Stock

12Pcs CD74HC4067 16-Channel Analog Digital Multiplexer MUX Breakout Board Module CD74HC4067 CMOS Precise Module Compatible with DIY

  • To control it, connect 4 digital outputs to the chip’s address select pins (S0-S3), and send it the binary address of the channel you want. This allows you to connect up to 16 sensors to your system using only 5 pins..
  • Since the mux/demux also works with digital signals, you can use it to pipe TTL level serial data to or from multiple devices. For example, you could use it to connect the TX pins of 16 devices to one RX pin on your microcontroller. You can then select any one of those 16 devices to listen to..
Check Stock