ReviewsFrsky R9m Module

SAUJNN Jumper T8SG Plus V2.0 Hall Gimbal OLED Display Advanced Multi-protocal Transmitter JR/FrSKY Compatible Module

High Quality Universal RC Controller Carrying Case Bag for Jumper WFLY RadioLink FrSky Transmitter.
Durable, portable and lightweight, fit for most RC radio transmitter, like Jumper T8SG Plus V3, T12 Pro,T16 Pro Hall V2, T18 T18 Pro, T18 Lite, WFLY WFT07, WFT09, ET07, WFT07, RadioLink AT9, AT9S, AT10 and FrSky X9D.
Two-way z1pper design and rubber handle , well protect your device from bumps dents and scratches.
High-density foam interior with pre-cut compartments for the transmitter and accessories.
Note: Some transmitter might require trimming of the foam insert to fit properly.

Flight controller: CRAZYBEE F4 Lite Firmware target: Frsky SPI RX version is CrazybeeF4FR.
Flysky version is Crazybee F4FS. Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready. Built-in Betaflight OSD(SPI Control). Built-in 5.8G VTX. Built-in SPI Frsky/Flysky receiver. Built-in 5V 1A BEC. Built-in voltage detection..
Onboard 4in1 ESC: MCU upgraded to EFM8BB21 Power supply: 1S LiPo/LiPo HV Current: 5A continuous peak 6A (3 seconds) Support BLHeliSuite programmable Factory firmware: O_H_5_REV16_7.HEX Default protocol: DSHOT600.
Runcam Nano3: Horizontal Resolution: 800TVL Lens : 2.1mm(M8) FOV 160° Signal System: PAL/NTSC Non Switchable Day/Night: Color.
Onboard 5.8g 40-CH 25mw VTX: Input voltage: 3.3V 5.5V Current consumption: 300mA(type) Frequency: 5.8GHz 5bands 40 channels Smartaudio ready.

The 12V 400mA-700mA NiMH battery charger can charge NiMH/NiCd battery packs that are 4.8V, 6V, 7.2V, 8.4V, 9.6V 12.0v (2-8 cells). NOTE: This charger is only for recharging NiMH/NiCd batteries pack, DO NOT charge LiPo batteries, li-Ion battery or any type of lithium battery.
AC to Dc power adapter charger with terminal barrel plug 55mm (outer diameter) x 21mm (inner diameter) can be used to charger FrSky Taranis X9DP/X9E transmitter battery and other device.
RC Car Battery Charger for NimH NiCd battery pack froAC to Dc power adapter charger with terminal barrel plug 55mm (outer diameter) x 21mm (inner diameter) can be used to charger FrSky Taranis X9DP/X9E transmitter battery and other device.
There is light indicator on the charger and tells charging status. Solid red light means charging is processing, green light means charging finised. If you see flash red light means the polarity of battery is reversed or charger cannot charge your battery.
ADVANCED PROTECTIONS - Charger has built-in safety protections against reverse polarity, short circuit, and over-current protection. The universal 100-240V AC input enables this charger to be used anywhere. Buy with confidence under 12-month warranty..

Pay attention:they are not AA or AAA size batteries,also they are not 18650 batteries,the batteries size are 0.71*1.97 inch,also Positive terminal....
More than 500 times Long cycle life,bring you high quality experience..
Model:ICR18500 Li-Ion Rechargeable battery,pls make sure what size do you need before you placed an order.
Appliations:Frsky x-Lite pro controller ,Garden Lights , Security System Panels, Landscape Lighting..

..., the lightest F4 1S 5A FC (2022), new 0802SE 19500KV motors, and a C03 FPV camera. With the combination of those electronics and parts, it reaches the best balance between performance, weight, durability, and premium build design..
【F4 1S 5A FC】The flight controller of Meteor65 has been upgraded to F4 1S 5A SPI Frsky V3.0. with a high-quality BMI270 gyro and BB51 ESC hardware. Reserve two UART ports, frsky version also can be used as the PNP version. Therefore, pilots can connect the external receiver to it..
【Power System】By using the latest 0802SE 19500KV motors and 31mm 3-blade props, this equipment ensures excellent performance of power and thrust. Makes the perfect dynamic balance, which gives the drone more flexibility and longer flying time..
【Camera&Canopy】Built-in 1.52g ultralight weight C03 camera, offer a high-quality, clear and sharper images to pilots. Adopted with a injection molding canopy which only 1.60g, more durable, anti-ruin, and heat-resitant, gives your whoop drone a good protection..
【BT2.0 Connector】BT2.0 connector has decreased internal resistance of connector effectively allowing more current to be transferred, which means it supports 9A continuous current (15A burst). Pilots can enjoy more flight time without....