ReviewsFsk Receiver Module

ACEIRMC Digital 38khz Ir Receiver Ir Transmitter Sensor Module Kit for Arduino Electronic Building DIY ， Pack of 6 Sets

This ir transmitter sensor module is directly launched by a single tube, it requires waveform modulation through the program..
It is suitable for infrared communication, infrared remote control, apply to a variety of platforms including for Arduino/51/AVR/ARM.
With signal indicating LED, easy to observe and debug..
Pin Definitions: (1) Output (2) Vcc (3) GND.
IR Infrared Transmitter Module Ir Digital 38khz Infrared Receiver Sensor Module For Arduino Electronic Building Block.

Check Stock

Bluetooth / 802.15.1 Development Tools Adafruit Feather M0 Bluefruit LE

Works with all of Adafruit's three basic 315MHz RF receiver modules.
Only a transmitter, no receiver module included.

Check Stock

ES100 Present DJ Mix [Explicit]

ADK (DIY Soldering Kit) for EverSet ES100 WWVB-BPSK Atomic Clock Receiver IC.
Hardware is compatible with Arduino - Atmega328P with Arduino Bootloader.
Includes all Parts to build the kit as shown in the Pictures - including 1x ES100-MOD Receiver Module and 1x ES100-MOD Carrier Board.
For Demo Program, Libraries, Documentation etc. see Manufacturer's Website.

Check Stock

MEGA 2560 Starter Kit Ultra (100% Arduino IDE Compatible) w/ Battery Holder, Sensors, Modules, Resistor kit and Components (no Supply)

...otor (5V) -Motor driver module for stepper motor ULN2003.
5V Active Buzzer -5V Passive Buzzer -LCD 1602 16 characters * 2 lines -LED Display Driver MAX7219 -LED Matrix Display of 8*8 -7 Segments Display 1 digit -7 Segments Display 4 digits -Simple Relay Module - Infrared Remote Control 38kHz - 38kHz Infrared decoder receiver (type 1838) - Infrared phototransistor (Flame sensor) - Infrared LED - Light sensor (Photoresistor).
-10 * LEDs 5mm Diffused RED -10 * LEDs 5mm Diffused GREEN -10 * LEDs 5mm Diffused YELLOW -5 * LEDs 5mm Ultrabright WHITE diffused -3 * LEDs 5mm Red / Green / Blue Diffused RGB -Shift Register (Series to Parallel IC) 74HC595 - NPN Transistor BC547 - PNP Transistor BC557 - Adjustable Knob Resistor 1kOhm (Potentiometer) - Adjustable Knob Resistor 10kOhm (Potentiometer).
- Resistor Pack 1/4W 1% accuracy, with 10pz of each value: 100, 220, 330, 470, 1K, 2K2, 4k7, 10K, 22K, 47K, 100K, 220K, 1M - 40-pin header 2.54 mm -40-pin header at right angle 2.54mm -5 * Capacitors for bypass tantalum 0.1uF -5 * Jumpers for header.

Check Stock

HC-05 Wireless Bluetooth Receiver RF Transceiver Module Serial Port Transmitter Module

RXD: the receiver, Bluetooth module receives from another device sent data.
normally connected to other devices transmitting end TXD?.
TXD: sending end, the Bluetooth module to send data to other devices.
receiving terminal is normally connected to other devices RXD.

Check Stock

HiLetgo 3pcs RXB6 433MHz Superheterodyne Wireless Receiver Module for Arduino/ARM/AVR

RXB6 433MHz Superheterodyne Wireless Receiver Module.
Power supply voltage input range: 3V-5.5V.
Low power consumption, 3.3V @ 433.92MHz, 6.0mA.

Check Stock

Bose Lifestyle 650 Home Entertainment System works with Alexa - Black

As main components, your purchase include: One Console, 4 OnmiJewel side speakers, One Omni Jewel center speaker, One Acoustimass wireless bass module, universal remote control, 2 wireless receivers, One ADAPTiQ headset and Owner’s guide.
Dimensions (”): Console – 15.98 W x 2.56 H x 10.16 D | Omni Jewel Side speakers (each) – 1.84 W x 5.77 H x 1.84 D | Omni Jewel Center speaker – 21.34 W x 1.9 H x 1.84 D | Bass module – 11.61 W x 12.8 H x 11.61 D | Wireless receivers – 6.54 W x 1.6 H x 3 D.
Wires length: 6-foot IR emitter, 5-foot optical cable, 6-foot HDMI cable, 5-foot power cord, 20-foot center speaker cable, 20-foot wireless surround speaker cable, and 20-foot front speaker cables.
Front and center speakers have a wired connection, while the 2-rear speakers connect to a wireless receiver and AC power mains. The rear speakers and bass module connect to the front module wirelessly.
Supported Audio formats - Dolby Digital, Dolby Digital Plus, Dolby TrueHD, DTS, Multichannel PCM. Video Source compatibility - Support for six 4K/60 video sources (HDMI 2.0/HDCP 2.2).

Check Stock

HTZSAFE Driveway Alarm- Driveway Alarms Wireless Outside Weatherproof Solar Motion Sensor&Detector- 1/2 Mile Long Range Driveway Alarm System- 1 Receiver + 2 Sensors

... built-in solar panels even on rainy or cloudy days. There is also a charge jack at the back of the detector which can be used to charge the solar detector by the included USB charging cord or the extra solar panel sold by HTZSAFE if you install the detectors in some areas with low light conditions..
Smart & Compact Receiver- The portable receiver has built-in rechargeable battery which can work more than 7 days even if AC power goes out. It has 35 optional melodies and 5 adjustable volume levels(includes Mute mode). Expandable up to 4 sensors and unlimited receivers for complete coverage of your property and match different melody with different motion detector to differentiate where motion is being detected(Set the melody for front door is “Doorbell Chime”,and for backyard is “Dog Barks”).
1/2 Mile Long Wireless Range- Both the solar motion detector and plug-in receiver pick up alarm signals up to 1/2 mile away(actual range will vary depending on the local terrain), it is a great solution even you have a large perimeter or property to monitor. The system adopts advanced wireless transmission technology(FSK+FHSS) to avoid the wireless signal interference from other wireless devices..
Ft Wide Motion Detection Range- The solar motion detecto....

Check Stock

DISH Solo HD Receiver (ViP 211z)

【Built-in 2.4G WIFI & Ethernet】The V9 Prime satellite receiver allows multiple ways to connect to the network. Built-in 2.4G WIFI module, support IEEE 802.1.1b/g/n and 3G/4G USB dongle, can also connect to wired network through Ethernet port, support network sharing..
【DVB-S/S2/S2X】1080P satellite receiver Compatible with DVB-S/S2/S2X signals, it is a satellite TV receiver. Compared with DVB-S/S2, DVB-S2X has higher spectral efficiency and higher access speed..
【No CA card required to decrypt】The firmware in the Satellite receiver will be updated from time to time. After you can upgrade via USB port or FTP, the decoder can decrypt satellite channels directly without inserting a CA card..
【Sat to IP】This receiver supports to transmit your satellite TV program to your mobile phone, tablet and other device via GTShare APP. This TV SAT decoder also supports DLNA function..
【USB 2.0 Port】USB port is compatible with FAT/FAT32/NTFS big capacity hard disk. And USB port can also be used for personal video recorder (PVR), TIMESHIFT and media files playback. This USB port supports multiple media, audio, photo formats..

Check Stock

Driveway Alarm System- Solar Driveway Alarms- 3 Adjustable Sensitivities-Fully Weatherproof Outdoor Motion Sensor&Detector DIY Security Alert System-1 Receiver and 3 Sensors KIT

...y, front porch, gate,pool,garage,shed and etc. Great for home, business,and office.The sensor will work properly at all the seasons. Working temperature range from -30 to 150 degree Fahrenheit..
1/2 MILE LONG WIRELESS TRANSMISSION RANGE : Both the motion sensor and plug-in receiver pick up alarm signals up to 1/2 mile away(actual range will vary depending on the local terrain), it is a great solution even you have a large perimeter or property to monitor. The system adopts improved wireless transmission technology(FSK+FHSS) to avoid the wireless signal interference from other devices..
50-FT WIDE MOTION DETECTION RANGE : The motion sensor will detect moving people or vehicles from 35 feet to 50 feet in front of it. Improved motion detection chip and detection angle to reduce the false alarms from dead leaves/small animals/sunlight/wind/temperature changes and etc. It has 2 adjustable sensitivities( Low=35ft.
High=50ft), ideal for driveways, walking paths,yard,garage,gate,pool and anywhere of your outdoor/indoor property you want to be alerted..
PLUG&PLAY,SUPER EASY TO INSTALL : Power on the motion sensor by 3pcs AA....

Check Stock

Traxxas 6528 TQi Traxxas-Link Enabled 2.4GHz High-Output 2-Channel Transmitter

FEATURES: Can be equipped with the Traxxas Link Wireless Module (TRAC6511) and used with the iPhone, iPad or iPod touch* to create a graphical user in.
INCLUDES: Traxxas TQI 2-Channel 2.4GHz Transmitter.
REQUIRES: AA Batteries: Four for transmitter Servos and receiver of modeler's choice COMMENTS: * Traxxas Link Wireless Module is not included and must.

Check Stock