ReviewsGas Pipe Production Line

60 Inch Gas Hose Connector Kit for Stove Dryer Gas Water Heater Pipe Diameter 5/8 in OD（1/2 in ID） Connector Size 1/2 FIP.1/2 MIP.3/4 MIP Stainless Steel Yellow Rind

KIT INCLUDE: 1 set bellow with yellow rind. 2 pack threaded connectors 15/16 Inch-16 UNx3/4 Inch MIP(Tapped 1/2Inch FIP ), 2 pack 15/16 Inch-16 UNx....
COMPATIBLE WITH: A stainless steel gas line hose designed mainly for gas stove, gas dryer, gas water heater. It has an outside dimension of 5/8 inch,....
DESIGNED CORRUGATED: The stainless steel gas line hose is designed with corrugation, for better use in a narrow range. The corrugated pipe has high....
EASY TO INSTALL: No need for more connectors. Only one wrench and a little bit teflon tape are all you need to install the hose. Trust me, no more....
ONE YEAR WARRANTY: Safe use is always the first goal of the product.Our products have gone through many quality checks and we never compromise on....

Check Stock

Maxitrol RV48L Natural Gas Pressure Regulator 1/2 FPT Thread 13/16 In and Out Opening 1/2 PSIG In 3 -6 WC Out

GAS TYPE & PRESSURE - Gas Type: Natural Gas (NG). Inlet gas pressure: 1/2 PSI. Outlet pressure range: 3" - 6" Water Column.
PIPE THREAD SIZE - 1/2" Inlet & 1/2" Outlet FPT GAS PIPE. Make sure you measure the gas pipe or regulator opening as close to 13/16 inches as shown in....
CAUTION - This regulator has 13/16" openings for 1/2" gas pipes. The 1/2" gas pipe means interior diameter 1/2" but outside diameter is 13/16", refer....
MARKING - Model: RV48L, Marking: 1/2 PSIG, Po 3" - 6". Inlet pressure 1/2 PSI. Adjustable outlet pressure 3"-6" Water Column..
OPERATE TEMPERATURE - 32°F - 225°F (0°C - 107°C). Do not install the regulator too close to the heating equipment or use in very cold environment.....

Check Stock

Stanbroil 3/8 X 36 Non-Whistle Flexible Flex Gas Line Connector Kit for NG or LP Fire Pit and Fireplace

Easy to installation and use, highly durable, Corrugated flexible flex gas line with feature of high temperature resistance.
3/8" OD x 1/4" ID 36 inch Stainless steel pipe coated black gas line with fittings.
3/8" Male Flare x 1/2" Male NPT fitting end, 3/8" Male Flare x 1/2" Female NPT Fitting. Brass 90 degree fitting for customer connection convenience.
CSA certified, fit for NG or LP fireplaces and .
There is a staggered pitch every 2" to Eliminate Whistling.

Check Stock

Joywayus Hex Nipple 1/2' Male x 1/2' Male Threaded Stainless Steel 304 Threaded Nipple Pipe Fittings for Brew Kit Home Piping (Pack of 5)

【Size】1/2" Male x 1/2" Male Thread. Tapered thread. Pipe fittings are components used for connecting, terminating, controlling flow, and changing the direction of pipe..
【High Quality Material &Threads】Made of quality stainless steel 304, durable and sturdy corrosion resistance, ductility at high temperatures, and low magnetic permeability. High quality and deep threads allow the fittings to bite better, tight threads, not easy to slip..
【Hex Nipple】The hex nipple fitting is a short length of pipe with threaded ends for connecting threaded pipes, and it has a hexagonal section in the middle for an increased bearing surface when adjusting the fitting with a wrench..
【Operating temperature range】Temperature rating: -65 to 250 degrees F.
【Widely Applications】Male threads for connecting to female threaded pipes, this premium pipe fitting can be used to connect various pipes, such as air pipe, fuel pipe, water pipe as well as air tools.
it can also be used with grease, fuels, LP and natural gas, refrigeration, instrumentation and hydraulic systems in low and medium pressure pipe line connections..

Check Stock

Stanbroil 3/8\ X 12\ Non-Whistle Flexible Flex Gas Line Connector Kit for NG or LP Fire Pit and Fireplace

Easy to installation and use, highly durable, Corrugated flexible flex gas line with feature of high temperature resistance.
3/8" OD x 1/4" ID 12 inch Stainless steel pipe coated black gas line with fittings.
3/8" Male Flare x 1/2" Male NPT fitting end, 3/8" Male Flare x 1/2" Female NPT Fitting. Brass 90 degree fitting for customer connection convenience.
CSA certified, fit for NG or LP fireplaces and 003c90K BTU with a 3/8" Connection Hub fire pit and fireplace burners.
There is a staggered pitch every 2" to Eliminate Whistling.

Check Stock

Gas Inline Fuel Filters, 10Pcs 1/4\and 5/16Inch Engine Filter for Kawasaki Kohler Briggs & Stratton John Deere Fuel Line, Replacement for Lawnmowers Riding Mower Garden Lawn Tractor ATV Motorcycle

SUITABLE FOR 1/4" & 5/16" - Inline Gas Fuel Filter for 6mm & 8mm 1/4" & 5/16" internal diameter pipe. These gas tapper filters are barbed, so there is no slippage from the fuel line. Easy to install and have no problems with leaking issues..
EASY TO SEE INSIDE - With this type of filter you can see if the filter is dirty and the debris that it has kept out of your gas line & carb. Installs easily and quickly. Do yourself a favor and swap out your old filter for one of these and replace it every couple of years..
CLEAN THE FUEL - If you don't use them already, these inexpensive filters are invaluable in keeping the debris that will get into your small engine fuel tank from getting to the carb. These will stop that crud from getting into the carb..
EXCELLENT FILTRATION - It cleans the fuel on the discharge side of the fuel pump before it enters the carburetor. It is clear, hi-temperature plastic and easy to see when it needs to be replaced. keeps fuel clean before entering engine, also like a little window to watch the gas..
STRONG COMPATIBILITY - 1/4" Gas In-line Fuel Filter can be used on many Small Tractors, Lawn Mowers, Snowmobiles, Garden Tillers, Snowblower, Go-kart, ATV, UTV, Dirt Bike, Motorcycle, Riding Mower, Lawn Tractor, generators with 1/....

Check Stock

Grehitk Flexible Gas Line Connector for Dryer(3/4 24inch), Gas Hose Connector Kit for Stove, Water Heater, Gas Log, Pipe Diameter 1 in. OD(3/4 in. ID), Connector Size 3/4" FIP.3/4"MIP, Stainless Steel

...ter, garage heater, fireplace, and so on. It can be used indoor or outdoor..
EASY TO INSTALL- Only one wrench and a little bit teflon tape are all you need to install the hose. Trust me, no more than 2 minutes. Note: The one side of joint connected to the yellow corrugated pipe cannot be wrapped with raw tape! Otherwise it will cause air leakage!But the other side of the joint should be wrapped..
GUARANTEE AND SERVICE- Safe use is always the first goal of the product.Our products have gone through many quality checks and we never compromise on quality. Any questions about installation and use can feel free to contact us, we are happy to serve you 24 hours..

Check Stock

Set of 4, 6 and 8 inch Bevel Pro PVC Pipe Beveling Tool for All-Purpose Schedule 40/80 Pipes, Eliminates Hand Filing for Easy and Safer Bevels, ADP161 Adapter Required for use with Drills/Hole Hogs

SAVES YOU TIME AND MONEY: By creating more consistent bevels in just 10 seconds, the Bevel Pro PVC Pipe Beveling Tool will improve safety, increase production and reduce trench time..
NO MORE HAND FILING: Bevel Pro fits snugly over pipe ends to ensure precise bevels every time. It's designed to create bevels that form a smooth join to eliminate displaced or torn gaskets..
QUICKER, SAFER OPTION: No more time-consuming hand filing or using powerful and dangerous tools in incorrect ways to get the bevels you need. Simply use Bevel Pro and in 10 seconds, the job is done..
MADE IN THE USA: Bevel Pro PVC pipe beveling tools are made in the USA with durable and high-quality U.S. steel. These pipe bevelers can be easily sharpened multiple times to increase tool life..
VERSATILE: Sized to match common pipe diameters, simply insert your Bevel Pro into a 1/2" or larger drill/grinder. A handy arbor adapter for gas-powered drills and hole hogs is available separately..

Check Stock

50 PCS 1 inch Greenhouse Clamps Clips Black ABS Snap Clamp Tube Clip Garden Buildings Tube Clip for Greenhouse Film, Sunshade Nets, Frame Shelters

... It fastens the plastic to the pipe so that you can easily build a greenhouse with these plastic clips..
Reliable Material: These tube clips are made of high quality ABS material, it has the characteristics of high temperature resistance, wind resistance, nice strength, good toughness and not easy to fracture. Seiko production, smooth surface without burr, stable structure, with better grip..
Flexible Use: The tube clip is very light and flexible, can be moved at any time and easy to install, it is the ideal choice for frequent disassembly and use. It is also designed for short term use and rearrangement..

Check Stock

Sunflower Dog: Dancing the Flathead Shuffle

Pipe Marker: it is often used to indicate the essential information, specific pipe content and directional flow. The pipe marker helps to easily identity pipe contents to keep everyone informed.
Material: it is made from vinyl with good adhesive properties. The pressure-sensitive adhesive backing helps in quick mounting on smooth, curved and irregular surfaces. The flexible sign delivers an efficient indoor/outdoor labeling performance.
Visibility: the marker has easy to read legend “Natural Gas” written in bold letters. The text is clearly written that makes it easy to identify the content of pipe.
Specification: the natural gas pipe marker features black text on yellow base. The marker measures 9 in. length and 1 in. height with maximum pipe outside diameter 2 in. and minimum pipe outside diameter is 1 ½ in. The character length is ¾ in.
Sign Muscle: this marker has NMC Sign Muscle coating to protect the text against fading, scratches, scuffing, and moisture. The UV-cured, clear coating creates a strong bond and also boosts the color and clarity.

Check Stock

1 Inch CTS Yellow Medium-Density Poly Pipe Line for Gas Distribution PE2708 100 Feet

Yellow Medium-Density poly pipe for natural gas or liquid propan distribution. Bimodel MDPE (PE2708).
Min. Wall Thicknes: 0.090 (100 Foot Length).
Outstanding strength and durability providing longer pipeline service and enhanced pipeline integrity..
Provides outstanding resistance to slow crack growth (SCG) and rapid crack propagation (RCP) which provides for a safer gas distribution system..
IMPORTANT NOTE: There are various pipe sizes described as 1". This for CTS pipe not IPS pipe. These are different pipe sizing standards with different....

Check Stock