ReviewsGas Shocks

East Lake Axle replacement for Rear left & right shocks Polaris Sportsman 400/500 / 600/700 / 800 1995-2006

Please verify your year, make and model in the product details before purchasing..
Heavy Duty Gas Shocks. Brand new ready for install.
OEM Replacement for the following OEM #'s 7041454.
Our shocks have 10% higher load capacity than the OEM..

Check Stock

FOX PERF. SERIES IFP SHOCKS (FRONT/REAR) compatible with JEEP WRANGLER JK 07-15 W/4-6" Lift

Set of 4 Shocks - compatible with 2WD & 4WD Vehicles 4-6" Front Lift and 4-6" Rear Lift.
Shock boots & Roost Shields sold separately..
Monotube gas charged with 2-inch aluminum seemless alloy body. Shocks are rebuildable and nitrogen gas-rechargeable..
All necessary washers, bushings, and nuts included. Factory shock mounting bolts are reused for installation..
Fox's limited one (1) year warranty protects against defects and premature failure..

Check Stock

Gas Struts,Gas Springs,Lift Support,Gas Shocks,Lid Stay,Lid Support,Gas Strut Lid Stay Support Kitchen Cabinet Door Hinge,Soft Close Lid Hinge,Gas Shocks,Toy Box Hinges,150N/33lb/15KG[2 Pack]

... cabinet door width 600mm/23.6in to achieve parallel opening and closing synchronization. , Choose the model and quantity according to the weight of the actual cabinet door panel. The choice is not soft and hard, and the small one cannot hold the cabinet door..
★Suitable for Gas Strut, Gas Spring, Lid Support, Gas Shocks, Lift Support, Lid Stay, Heavy Duty Kitchen Cabinet Doors, RV Overhead Cabinet Doors, Display Table, Cabinets, Toy Box or Storage Box etc..
★ Pressure:150N / 33lb / 15KG (Per Strut).
Length ( hole center to hole center) :9-11/16”.
Travel:3-14/25” ,Distance between ball mounts compressed: 6-1/8″. Please select the correct model strictly according to the data sheet of the detailed picture. The installation must be installed in strict accordance with the size of the installation picture, and the wrong installation size will bend the mountain-shaped hinge fittings on the cabinet door..
★ 1.The gas spring piston rod must be installed in the downward position, not upside-down, which can reduce friction and ensure the best damping....

Check Stock

Hood and Trunk Lift Support Gas Struts Fit for Chrysler 300 2005-2008 TUPARTS Automotive Replacement Shock Lift Supports

ONLY FIT - Gas lift supports for Chrysler 300 2005 2006 2007 2008.
Replace Reason - The hood or trunk won’t stay up?Some valve oil has leaked out of one of the ends?It could be old or defective, but regardless of....
Working S-mart - Get new lift supports shocks to instead of holding up your hood or trunk with one arm while trying to work on the car with the other....
Precise Technology - The TUPARTS gas spring shocks lift support are made of precise technology with durability and corrosion resistance,avoiding fuel....
Tips - Please check year/make/model of your vehicle by the part finder tool on the top left corner to confirm compatibility before purchase.Please....

Check Stock

2 Truck Upfitters 16' Gas Props (15.7' ext, 9.4' Compressed, 55 lbs of Pressure ea) Compatible with are, ATC, Snugtop, Leer Campers. Measurement REQ'D! Incl 4 Ball mounts+Angled & Straight Fittings!

... CANNOT be compressed by hand. These gas props MUST be installed in the EXTENDED / OPEN position. It is nearly impossible to install them in the CLOSED position. Please refer to the install video for guidance on how to install..
Compatible with Suspa # c16-23994 & compatible with Stabilus # 025657 These camper shell shocks are compatible with many truck canopy types, including LEER truck cap parts, ARE truck topper parts, Century parts, Snugtop replacement parts Astro tops, ATC campers, and many other fiberglass brands that utilize gas shocks / gas springs / gas lift cylinders. Compatible with many gas lift brands, including stabilus, lift o mat, and Suspa. These are OEM quality and perfect fit for your topper!.

Check Stock

Factory Spec 1515-0623 2 Front Gas Shocks Kawasaki Bayou 220 KLF220A & Kawasaki Bayou 250 KLF250A

Upgrade your old shocks to heavy duty gas shocks.
Adjustable for different ride conditions.
Rugged design has 10% stiffer springs than standard.

Check Stock

C1608054 20\ Gas Prop Spring Strut 20 inch 100 Lb Per Shock C16-08054 for Camper Shell RV Bed Tonneau Cover Storage Box Basement Door Floor Hatch Window Lift Struts (Applicable Lid Weight 85-110LBs)

✅ ARANA 20 inch Gas Struts C1608054 Lift Supports -- 2Pcs Set Force 100 Pounds 445N Gas Shocks , most SUITABLE support weight for 2 STRUTS is 85 lbs - 110 lbs, this means if your project lid is between 85 pounds and 110 pounds, this 100LB gas strut set is SUITABLE!.
✅ ARANA 20 Inch 100 Lbs Gas Spring Shocks -- Extended Length A [in]: 19.7(500mm), Compressed Length B [in]: 11.8(300mm), Interchange number: 6939, 6939S10, C1608054, C16-08054.
measurement of the supported lid weight or of your old strut pressure is required to prevent purchasing wrongly!.
✅ C16-08054 Gas Props 20inch -- Direct replacement struts for RV bed, motorhome bed, tanning bed, camper bed, travel trailer bed mattress, queen bed, etc..
Note: DO NOT compress them by hands before installing, the struts could only be compressed after installing successfully!!!.
✅ ARANA C1608054 100 lb Lift Supports -- Customer will also use them on tonneau cover, heavy camper shell roof, tv cabinet door, trailer window, compartment door, floor hatch, truck cover, bar shed window, heavy custom build lid, etc.
Very Strong, do not buy them for the lid weight less than 80 pounds.
✅100% Satisfaction Service -- 18 Months Support comes with every ARANA product.

Check Stock

23 inch 200 LB Gas Prop Struts Shocks with L Mounting Brackets 23 889 N Lift-Support Gas Springs for Heavy Duty Murphy Bed Large Outdoor Box Lid Trap Door Floor Hatch Super STRONG 2Pcs Set ARANA

✅ Qty (2) 23 Inch 200lbs Shock --Extended Length: 22.7"(577 mm), Compressed Length: 13.6"(345 mm), Package include: 2× Shocks, 4× L Mounting....
✅2 Pcs 200 Pounds Per Shock --Most suitable support weight is between 170 pounds and 220 pounds, if out of this range, we suggest you buy....
✅23 inch Gas Spring -- Super strong gas shocks can be used on heavy duty bench box lid, boat hatch or floor hatch cover, trap door or Murphy bed! If....
✅23 inch 200 Pound Gas Springs -- Super strong, couldn't be installed on window or other light-duty lid. NOTE: VERY STRONG! If the lid weight is....
✅18 Months Replacement/Refund Support--18 Months Support comes with every ARANA product.
If any questions before purchasing or dissatisfactions....

Check Stock

Bilstein 5100 Front and Rear Shock Set for 05-15 Ford F-250

Set of 4 Shocks - compatible with 4WD Vehicles w/0-2" Lift.
Shock boots included with all shocks except in cases of special fitment..
Monotube gas charged for longevity, durability, and performance..
All necessary washers, bushings, and nuts included. Factory shock mounting bolts are reused for installation..
Bilstein's Limited Lifetime manufacturer's Warranty protects against defects and premature failure..

Check Stock

Rampage Xt 1/5 Scale Gas Truck (Blue)

Powerful 2-stroke gas engine, Pull start, Large capacity fuel tank, Tuned Exhaust pipe, 4mm 6061 T6 Aluminum chassis, Aluminum body oil filled shocks, Front and rear gear differentials, Ball bearings throughout..
Easily tuned gas engine w/ choke, Tunable centrifugal clutch, Adjustable brake linkage, Adjustable ride height, Tunable suspension, Multiple shock locations, Adjustable toe angle, Adjustable camber..
Aggressive monster truck tires, Shaft driven durability, Enclosed battery box, Chrome tuned pipe, Engine enclosed in roll cage..
Powerful 30cc HY 2-Stroke Gas Engine, High torque throttle/brake servo, High torque 1/5 scale steering servo, 2.4GHz radio system..

Check Stock

NEW BILSTEIN FRONT & REAR SHOCKS FOR 99-04 JEEP GRAND CHEROKEE WJ WITH A 1.5-2' LIFT, 5100 SERIES SHOCK ABSORBERS, LAREDO LIMITED OVERLAND SPECIAL EDITION SPORT 1999 2000 2001 2002 2003 2004

Brand New Set of Bilstein 5100 Series Monotube Shock Absorbers, 2 Fronts and 2 Rear.
Includes: | * 2 - Bilstein # 24-185622 Front Shocks, 46mm | * 2 - Bilstein # 33-236957 Rear Shocks, 46mm.
Bilstein 5100 Series Shock Absorbers are high gas pressure monotube shocks designed specifically for lifted pickups, SUVs and Jeeps | * The shocks feature a 46mm digressive piston with self-adjusting deflective disc valving | * They offer super damping ability that makes them ideal for heavy hauling or occasional off-road use, while maintaining an exceptional street ride.
Specs: | * Front: | * Collapsed Length: 13.58" (345.00mm) | * Extended Length: 22.09" (561.00mm) | * Rear: | * Collapsed Length: 15.12" (384.05mm) | * Extended Length: 24.35" (618.49mm).
Fits: | * Jeep: | * 1999-2004 Grand Cherokee WJ with 1" to 2.5" of Lift, including: | * Laredo | * Limited | * Overland | * Special Edition | * Sport | *** Bilstein's old part numbers on these shocks were F4-BE5-6255-H5 on the Fronts and 33-151649 on the Rears ***.

Check Stock