ReviewsHigh Input Common Mode Range

Voltage Measurement Module, DVB01 Voltage Comparator for Voltage Measurement for Control Applications

  • The LM2903P devices consist of two independent voltage comparators that are designed to operate from a single power supply over a wide range of voltages.
  • Single-supply or dual supplies Wide range of supply voltage Maximum rating: 2 V to 36 V.
  • Low supply-current independent of supply voltage: 200 µA per comparator, Output compatible with TTL, MOS, and CMOS.
  • Common-mode input voltage range Includes Ground, Low output saturation voltage.
  • Differential input voltage range equal to maximum-rated supply voltage: ±36 V.
Check Stock

50PCS PC817 Optocoupler in-Line 2.54mm Pitch 4-pin DIP-4 Mounting Transistor Output Opticalcoupler for Computer Terminals Timers Osciallators Dual Opamps Quad Opamp

  • Feature: Integrated circuits have the advantages of small size, light weight, small solder joints, long life, high reliability, and good performance..
  • Application: PC817 photocoupler is widely used in computer terminals, timers, osciallators, dual opamps, quad opamps, comperators, audio amplifiers, echo processors, current mode controllers, darlington arrays, voltage charge pump,etc..
  • Low input: Low input bias current, low input offset voltage and offset current. Common mode input voltage range, including ground..
  • Durable material: The chip is made of metal oxide semiconductor material, which has good thermal stability and long service life..
  • Package includes: 50pcs PC817C 2.54mm pitch 4-pin DIP-4 transistor output optocoupler..
Check Stock

Juried Engineering LM393P IC Dual Differential Comparator & 8-Pin DIP Sockets with Machined Contact Pins Breadboard-Friendly (Pack of 1)

  • Wide range of supply voltage Maximum rating: 2 V to 36 V, Low input bias current, Low output saturation voltage.
  • Low supply-current independent of supply voltage: 200 µA per comparator, Low input offset voltage.
  • Common-mode input voltage range Includes Ground, Output compatible with TTL, MOS, and CMOS.
  • Differential input voltage range equal to maximum-rated supply voltage: ±36 V, Example Applications: Vacuum robot, Single phase UPS, Server PSU, Cordless power tool, Wireless Infrastructure, Appliances, Building Automation, Factory automation & control, Motor drives, Infotainment & cluster.
Check Stock

Juried Engineering LM393P LM393 IC Dual Differential Comparator & 8-Pin DIP Sockets with Machined Contact Pins Breadboard-Friendly (Pack of 10)

  • Four independent voltage comparators that are designed to operate from a single power supply over a wide range of voltages.
  • Wide Supply Ranges Single Supply: 2 V to 36 V, Dual Supplies: ±1 V to ±18 V, Differential Input Voltage Range Equal to Maximum-Rated Supply Voltage: ±36 V, Low Input Offset Current: 3 nA (Typical).
  • Low Supply-Current Drain Independent of Supply Voltage: 0.8 mA (Typical), Low Output Saturation Voltage, Common-Mode Input Voltage Range Includes Ground.
  • Low Input Bias Current: 25 nA (Typical), Low Input Offset Voltage: 2 mV (Typical), Low Output Saturation Voltage.
  • Example Applications: Industrial, Automotive: Infotainment and Clusters, Body Control Modules, Power Supervision, Oscillators, Peak Detectors, Logic, Voltage Translation.
Check Stock

CZH-LABS DIN Rail Mount 12 Amp Solid State Relay SSR Module in 4~32VDC Out 100~240VAC 1 Channel

  • MOC3043 Phototriac and BTA12-600B triac (the heatsink is electrically insulated)..
  • Input Action Voltage DC 3 to 32V. LED indication for each channel. Anti-reverse protection diode..
  • Output Load Voltage range AC 100 to 240V (50/60Hz). Maximum on-state average current: 12 Amp. Isolation: Phototriac. Zero cross: Yes..
  • Dual input terminal block, you can flexibility to configure the input control mode: Individual / Common Positive / Common Negative..
  • DIN rail mount, Taiwan DINKLE fireproof nylon material DIN rail mount carrier (not China low quality carrier), can support width 35mm / 32mm / 15mm....
Check Stock

Juried Engineering LM2903P LM2903 Dual Differential Comparator Automotive Grade Breadboard-Friendly IC DIP-8 (1 Piece)

  • The LM2903P devices consist of two independent voltage comparators that are designed to operate from a single power supply over a wide range of voltages.
  • Single-supply or dual supplies Wide range of supply voltage Maximum rating: 2 V to 36 V.
  • Low supply-current independent of supply voltage: 200 µA per comparator, Output compatible with TTL, MOS, and CMOS.
  • Common-mode input voltage range Includes Ground, Low output saturation voltage.
  • Differential input voltage range equal to maximum-rated supply voltage: ±36 V.
Check Stock

Juried Engineering TLV271IP TLV271 T271IP Single 16V, 3MHz, 550-uA/ch, Rail-to-Rail Output Operational Amplifier Op Amp Breadboard-Friendly IC DIP-8 (Pack of 2)

  • The TLC2274 are quadruple operational amplifiers from Texas Instruments. The TLC2274 devices exhibit rail-to-rail output performance for increased dynamic range in single- or split-supply applications..
  • Output Swing Includes Both Supply Rails, Low-Input Bias Current: 1-pA Typical.
  • Low Noise: 9 nV/√Hz Typical at f = 1 kHz, Fully-Specified for Both Single-Supply and Split- Supply Operation.
  • Common-Mode Input Voltage Range Includes Negative Rail, High-Gain Bandwidth: 2.2-MHz Typical.
  • High Slew Rate: 3.6-V/µs Typical, Low Input Offset Voltage: 950 µV Maximum at TA = 25°C.
Check Stock

Texas Instruments LM358P Low Power Dual OP Amplifier, General Purpose, 8-Pin, -16-32 Volt, 9.81 mm L x 6.35 mm W x 4.57 mm H (Pack of 15)

  • Four independent voltage comparators that are designed to operate from a single power supply over a wide range of voltages.
  • Wide Supply Ranges Single Supply: 2 V to 36 V, Dual Supplies: ±1 V to ±18 V, Differential Input Voltage Range Equal to Maximum-Rated Supply Voltage: ±36 V, Low Input Offset Current: 3 nA (Typical).
  • Low Supply-Current Drain Independent of Supply Voltage: 0.8 mA (Typical), Low Output Saturation Voltage, Common-Mode Input Voltage Range Includes Ground.
  • Low Input Bias Current: 25 nA (Typical), Low Input Offset Voltage: 2 mV (Typical), Low Output Saturation Voltage.
  • Example Applications: Industrial, Automotive: Infotainment and Clusters, Body Control Modules, Power Supervision, Oscillators, Peak Detectors, Logic, Voltage Translation.
Check Stock

EC Buying AD620 High Accuracy Low Power Programmable Instrumentation Amplifier Module Voltage Amplifier Module Differential Amplifier Single-Ended/Differential Small Signal/Small Amplifiers Module

  • ...20: G=1+50K/Rg, AD623: G=1+100K/Rg ✭Maximum magnification of the module: more than 2000 times (actual measurement), due to the large gain of the waveform frequency band, it is recommended to use multi-stage amplification with high gain ✭Fixed output voltage: 5V-10V (default delivery 5V).
  • ♥ Other parameters: ✭Common mode rejection ratio: AD620: 100dB (minimum, G=10).
  • AD623: 90dB (minimum, G=10) ✭Input bias current: AD620: 1.0nA (max).
  • AD623: 23nA (max) ✭Input offset voltage: AD620: 50μV (max).
  • AD623: 200μV (max) ✭Input offset offset: AD620: 0.6μV/°C (max).
  • AD623: 2μV/°C (max) ✭Input voltage noise: AD620: 9nV/√HZ (1KHZ).
  • ♥Precautions: 1. The power supply of the module is a single power supply, and the voltage cannot exceed 26V 2. Since the module is a high-precision device, to avoid unnecessary interference, it is recommended to use a linear power supply for power supply 3. It is recommended to use SMA to BNC line input and output signal for the output signal. Compared with the observation effect, poor contact or inferior wire may cause signal attenuation or excessive noise..
Check Stock

Juried Engineering NE5534P NE5534 Low-Noise High-Speed Audio Operational Amplifier IC Op-Amp DIP-8 Breadboard-Friendly (Pack of 10)

  • The TL081CP JFET-input operational amplifier family is designed to offer a wider selection than any previously developed operational amplifier family. Each of these JFET-input operational amplifiers incorporates well-matched, high-voltage JFET and bipolar transistors in a monolithic integrated circuit..
  • Equivalent Input Noise Voltage 3.5 nV/√Hz Typ and High Slew Rate 13 V/µs Typ, Unity-Gain Bandwidth 10 MHz Typ and Wide Supply-Voltage Range ±3 V to ±20 V.
  • Common-Mode Rejection Ratio 100 dB Typ and Low Harmonic Distortion.
  • High DC Voltage Gain 100 V/mV Typ and Offset Nulling Capability.
  • Peak-to-Peak Output Voltage Swing 32 V Typ With VCC± = ±18 V and RL = 600 Ω and External Compensation Capability.
Check Stock

Juried Engineering NE5534P NE5534 Low-Noise High-Speed Audio Operational Amplifier IC Op-Amp DIP-8 Breadboard-Friendly (Pack of 5)

  • The TL081CP JFET-input operational amplifier family is designed to offer a wider selection than any previously developed operational amplifier family. Each of these JFET-input operational amplifiers incorporates well-matched, high-voltage JFET and bipolar transistors in a monolithic integrated circuit..
  • Unity-Gain Bandwidth 10 MHz Typ and Wide Supply-Voltage Range ±3 V to ±20 V, Equivalent Input Noise Voltage 3.5 nV/√Hz Typ and High Slew Rate 13 V/µs Typ.
  • Common-Mode Rejection Ratio 100 dB Typ and Low Harmonic Distortion.
  • High DC Voltage Gain 100 V/mV Typ and Offset Nulling Capability.
  • Peak-to-Peak Output Voltage Swing 32 V Typ With VCC± = ±18 V and RL = 600 Ω and External Compensation Capability.
Check Stock