ReviewsHigh Voltage System

Amrex 2\x2\ Sponge Insert Replacements From Caputron (10 Inserts/Pack)

  • Design The Output Contact Adopts Relay, Which Can Withstand Large Output Current, And Can Set System Parameters According To The Button, So As To Meet The Application Of Different Occasions..
  • Characteristics Dc20D Is One Module Used For Diesel Engine Or Generator. The Status Of The Engine And Generator Can Be Checked Conveniently..
  • MultiFunctional It Is With The Functions Of Auto Start/Stop, Protection And Alarm Indication. Dc Power And Running Situation Is Indicated On The Front Panel..
  • Easy To Use Add Current, Speed Measurement Display Function, Add Rs485 Interface, Can Be Connected To The Computer..
  • Good Effects Over Frequency, Low Frequency, Over Voltage, Under Voltage, Low Oil Pressure, High Temperature, Low Water Level, Low Oil Level, Charge Failure, OverTime Stop, Emergency Stop Alarm System As Well As Low Battery Voltage Can Be Indicated In Time..
Check Stock

Hoodman Drone Tripod Mount for DJI Cendence Remote Controller

  • 600TVL perfect picture quality, specially designed for outdoor flying..
  • Low Power Consumption and Low illumination, 1/3" SONY SUPER HAD II CCD,Nextchip 2040 DSP.
  • VTX 5V Out for Cam, Operating Voltage: 7-20 V Output Voltage(VOUT): 5 V,use 2S-4S battery,can not 6S battery.
  • A ready to fly vtx+cam fpv system. High Picture Quality NTSC CCD Camera.Easy to use 2 buttons and 2 LED display to change channels and frequencies..
  • Low power consumption most affordable fpv system, suitable for all quadcopter and drones..
Check Stock

Amprobe AT-8020 Advanced Industrial Wire Tracer Kit

  • 【FUNCTION UPGRADE】 KZYEE KM50 Circuit Tester Kit is an upgraded version of KM10, which performs each type of testing modes, like DC Voltage, AC Voltage, Signal Frequency, Duty Cycle, Fuel Injection, Resistance, and Diode.
  • 【QUICK DIAGNOSIS】Quicker troubleshoot and diagnose circuit conditions by switching waveform display from the digital display for AC Voltage, Frequency, Duty Cycle, and Fuel Inject testings by long-pressing the mode button for 3 seconds.
  • 【WIDELY APPLICATION】Works on 12V 100-2000CCA lead acid batteries , including Regular Flooded, AGM Flat Plate, AGM Spiral, GEL and EFB. Also, it is suitable for cars, motorcycles, trucks, ATVs, SUVs, boats, yachts, mowers, and even golf carts and lawn tractors batteries.
  • 【CRANKING & CHARGING SYSTEM TEST】Presents you with the test results (actual cranking voltage & cranking time) of the starter system in milliseconds to indicate if the cranking system is working as expected. Also, the battery load tester conducts a throughout check on the 12V charging system to make sure a normal generator output,perfectly working rectifier diode and under controlled charging current.
  • 【SAFE PROTECTION DESIGN】The battery tester doesn’t emit light, heat or spark, and won’t discharge the battery. It ....
Check Stock

PowMr MPPT Charge Controller 60 amp 48V 36V 24V 12V Auto - Max 160VDC Input LCD Backlight Solar Charge for Vented Sealed Gel NiCd Lithium Battery【Software Update Version】(MPPT-60A)

  • ❶【Software Update Version】100% MPPT 60A solar charge controller Intelligent, Max efficiency ≥98.1%, PV utilization ≥99%.Built-in DSP controller with high performance Automatic battery voltage detection 12V/24V/36V/48V, Make sure batteries' voltage more than 12V to boost controller and make sure battery has enough power to Self-detection when connected to the controller..
  • ❷Fit for USER(can be set Lithium, Lifepo4, Li(NiCoMn)O2)/Vented/Flooded/Sealed/Gel/NiCd battery.User programmable for absorption voltage/Floating voltage/Low voltage disconnect./Load Timer. Real-time energy recording..
  • ❸Blacklight LCD Dispaly PV voltage/output power/Battery voltage/charging current/working mode/Temperature, ☀ TROUBLESHOOTING function and LCD display and can help users not only check the whole system operating data and statuses but also quickly identify system faults and modify parameters..
  • ❹Intelligence Fan-on temperature 003e45℃ and off 003c 40℃,Porous heat dissipation.and fan use BEARING technologies increase life UP TO 5000hrs in normal use..
  • ❺【What You Get】we consider that the larger diameter of the wire will be greater cost for customers, so we designed two connectors for each pos and negs on solar and batteries connectors. copper wires:9....
Check Stock

Hotcoat PCS-250 Powder Coating System | Innovative Dual Voltage with Minimal Overspray and Larger Ground Clamp | Powder Coating Machine with Clear Bottle

  • POWDER COATING SYSTEM: Eeastwood’s PCS-250 dual-voltage powder coating system is a breakthrough refinishing system for the home hobbyist providing professional performance at a fraction of the cost of industrial equipment. The cured finish resists most chemicals, fuels, acids, thinners, brake fluid, UV light, and is much more durable than liquid coatings (up to ten times)..
  • BEST USE: Powder coating is a very popular type of finishing for steel and other metallic products. It protects the surface from scratches, chipping and corrosion. Additionally, it is the most durable finish available today because it offers a high scratch resistance as well as weatherproofing to prevent corrosion..
  • EASTWOOD QUALITY: Eastwood offers solutions which combines our 4,000+ unique products with the know-how to “Do The Job Right”. With an In-house product design, development and testing and a strong track record of high-quality, innovative products. Used and trusted by top builders to beginners and also provides a Lifetime Tech Support..
  • WHAT’S IN THE PACKAGE: PCS-250 Dual-Voltage HotCoat Powder Coating Gun, dual-voltage power supply, activation switch, ground clamp and cable, and an empty 8-oz. clear bottle..
  • WARRANTY: Comes with a 1-year limited warranty and 90-day....
Check Stock

ANCEL PB100 Automotive 12/24V Power Circuit Tester Probe with ANCEL BA201 Car 12V 100-2000 CCA Battery Load Tester

  • Includes: 1 x PB100 Circuit Tester, 1x BA201 Battery Tester.
  • A MUST-HAVE TOOL - Designed for voltage & polarity testing, continuity testing, signal circuit testing, supply power/activating components, trailer lights & connections testing. It features red/green polarity indicators, follows & locates short circuits, and checks bad Ground contacts..
  • 4 WORKING MODES - DC Voltage mode for reading the DC voltage with a resolution of 0.1 volts.
  • AC Voltage mode for reading the Max. voltage, the Min. voltage, and frequency.
  • Resistance mode for reading the resistance between the tip and auxiliary ground lead.
  • Diode mode for checking forward bias or reverse bias..
  • Easy to check the cranking and charging system condition. Cranking test displays cranking time, voltage and status, which helps you test and analyze the starting motor to check it works properly or not. Charging test displays load voltage, unloaded voltage, ripple status, charging system status to avoid damaging the battery and shortening its life greatly due to overcharging or incomplete charging..
  • Monitors the real-time voltage through the Waveform graph, displays current voltage, maximum and minimum voltage during ignition. According to analyze the values of discharge voltage, starting voltage, and cha....
Check Stock

Thermaltake Dr. Power II Automated Power Supply Tester Oversized LCD for All Power Supplies - AC0015

  • Supports all ATX power supply up to ATX12V 2.3.
  • Oversized LCD panel shows all voltages within 1/10th volt for quick and easy troubleshooting.
  • Voltage reading for all rails (+12V/5V/+3.3V/5VSB/ 12V).
  • Built in output connectors diagnostic system, low voltage, high voltage, no voltage, PG alarms.
  • Built in alarm to notify user of unstable or abnormal power supply activity.
Check Stock

Solaroxy 300W Outdoor Low Voltage Landscape Lighting Transformer with Digital Timer and Photocell, Weatherproof Light Transformer for Garden Lights, Lawn Lights, Pathway Lights

  • Built-in timer and photocell: Built in photocell, this low voltage lighting transformer will turn on at dusk and off at dawn automatically at "Auto" mode. The transformer also features astronomic timer system, which uses geographical location to get your local sunset and sunrise time to help you to use energy with high efficiency. With astronomic timer system, you can install the transformer indoor to prolong its lifetime..
  • Durable & Weatherproof: Made with metal housing, this landscape transformer can still work in terrible weather. Removable door design for easy access. A transparent window allows you checking the setting situation without opening the door. Waterproof feature makes the transformer safe to use outdoors..
  • Overload protection: Maximum output of this outdoor lighting transformer is 300 watts. It is recommended not to exceed 80% of the total rated watts of the transformer.If the transformer is overloaded or there is a short circuit in the lighting system, it will shut off the low voltage output of the power in case of danger..
  • Easy to use & install: Just press 4 buttons to select the modes you want, easy and convenient. This landscape light transformer is able to remain the working mode you selected before when power off. You just need to ....
Check Stock

Step Down DC Voltage Converter for DeWalt 20V to 12V Battery Dock Power 180W Inverter, Connector DIY Adapter Automatic Buck Boost Converter Regulator with Upgraded Low Voltage Protection

  • Mellif voltage converters built in over low voltage protection, auto shut off if the battery voltage is lower than 14.4v, protect your 12V devices from over power. Max output current 12V/15A.
  • Compatibility: Mellif step down DC voltage converter works with DeWalt 20V MAX XR battery (Battery NOT Included). We focus on providing reliable tools. You can save money on the battery and charger if you already have them before.
  • Up to 95% Power Conversion Efficiency: Adopt Synchronous Rectification Technology to improve conversion efficiency, Maximum Efficiency:≥95%.
  • High quality material & Safe to use: The voltage regulator is made of high quality chip and high quality plastic, stable and safe. Mellif voltage regulator provides over/under voltage input, overload, overhead, and short circuit full protection..
  • Widely Application: power 180w, widely used in motor, dashcam, car truck, vehicle, golf cart, led strip light, electric fan, camera, light ,screen, monitoring system, solar pad and DIY etc..
Check Stock

Square D Homeline HOM250 Miniature Circuit Breaker, 120/240 VAC, 50 A, 10 kA, 2 Poles, Thermal Magnetic Trip

  • 【Powerful Protection】 Fast trip to ensure reliable operation of the load and prolong the life of dc circuit breakers..
  • 【ARC EXTINGUISHING】DC breaker is more powerful than AC breaker to extinguish arcs. It means that our low-voltage breaker can be used at the same level voltage of DC and AC circuit system.
  • 【APPLICATION】Used in DC power system, ship electric power system, solar photovoltaic system, or other DC system..
  • 【INSTALLATION】 Screw clamp wires, 35mm DIN rail mount..
Check Stock

ANCEL PB100 Automotive 12/24V Power Circuit Tester Probe with ANCEL BA301 6V 12V Battery Load Tester Car Cranking Charging System Test Tool

  • Includes: 1 x PB100 Circuit Tester, 1x BA301 Battery Tester.
  • A MUST-HAVE TOOL - Designed for voltage & polarity testing, continuity testing, signal circuit testing, supply power/activating components, trailer lights & connections testing. It features red/green polarity indicators, follows & locates short circuits, and checks bad Ground contacts..
  • 4 WORKING MODES - DC Voltage mode for reading the DC voltage with a resolution of 0.1 volts.
  • AC Voltage mode for reading the Max. voltage, the Min. voltage, and frequency.
  • Resistance mode for reading the resistance between the tip and auxiliary ground lead.
  • Diode mode for checking forward bias or reverse bias..
  • Works on all 6V & 12V 100 - 2000 CCA lead-acid batteries, analyzes starter cranking and alternator charging condition. Cranking test to test and analyze the starting motor (cranking time, voltage, and status), and the charging test to check and analyze the charging system (load voltage, unloaded voltage, ripple status, charging system status)..
  • Features one-click "waveform" to record the voltage changes (current voltage, maximum and minimum voltage) in a graph during ignition. You'll know if the battery needs to be replaced or not through analyzing the values of discharge voltage, starting voltage, and ch....
Check Stock