ReviewsHqqe Mechanical Seal

Sterling Seal & Supply (STCC) White Virgin Teflon 7530 Sheet, 1/32\ Thick, 6\ x 6\ Square (QTY 1)

  • Sterling Seal & Supply 7530 is the most chemically inert of all plastics which complies with USFDA legislation for safe use with food and is one of the most versatile plastics known to man.
  • Sterling Seal & Supply 7530 has excellent thermal insulation and electrical reliability. This is true at high radio frequencies, making it suitable for use as an insulator in cables and connector assemblies.
  • Sterling Seal & Supply 7530 has a wide thermal range with a maximum temperature limit of 500 Degrees F and minimum of 328 Degrees F. PTFE will insulate to 500 volts per mil.
  • Sterling Seal & Supply 7530 has exceptional mechanical toughness with superior anti-stick, low frictional properties, and long term weather ability. PTFE is both high impact and tearing resistant.
  • PTFE is unaffected by most corrosive liquids, vapors and gases, and conforms to both FDA and AMS specifications.
Check Stock

Othmro Mechanical Shaft Seal Replacement 301-12 for Pump Shaft Water Pumps Shaft Mechanical Sealing Alloy Plastic 3pcs

  • Can work in water, oil, and other weakly corrosive media..
  • Mechanical Shaft Seal Replacement,Product Included:3 X Mechanical Sealing..
  • Sealed Chamber Temperature (°C): -20 ~ 80.
  • Includes two seals made of ceramic and graphite ,Use for pools and spa pumps..
Check Stock

Myers HJ100S Shallow Well Jet Pump 1 HP - Body Construction: Cast Iron

  • Durable machined heavy-duty construction pump body provides long product life.
  • Precision molded impellers and diffuser provide smooth, balanced performance and efficiency.
  • High quality proven pressure switch with adjustable on/off pressure settings.  20 PSI differential.
  • Heavy-duty motor with double ball bearing design and voltage selection device.
  • Mechanical shaft seal with ceramic face and stainless steel construction for long seal life.
Check Stock

Athena Parts Water Pump Gasket Kit with Bearings for KAWASAKI KX 250 F 2004-2008, SUZUKI RMZ 250 2004-2006, black

  • Includes every gasket, O-ring, bearing, and seal required to rebuild a water pump..
  • Typical kit includes the following -Bearings where applicable. -Rubber Seals. -Mechanical Water pump seal where applicable. -Side cover gasket. -Water pump gasket. -Snap rings located on water pump shaft. -Copper drain washers..
Check Stock

303-1510 6.7L Power Stroke Front Crankshaft Seal Remover Alt ST-152 Fit for 2011-2019 Ford Super Duty F-250, F-350, F-450 and F-550, 2016-2019 Ford Super Duty F-650 F-750

  • Fitment: 6.7L Power Stroke Diesel Front Crankshaft Seal Remover fits for 2011-2019 Ford Super Duty F-250, F-350, F-450 and F-550, 2016-2019 Ford Super Duty F-650 F-750.
  • High Quality: Machined from heavy duty steel with excellent mechanical and physical properties, this removal tool is good in corrosion resistance and durability.
  • Application: Used for the removal of front crankshaft seal without damaging the seal, it credibly prevents the seal from leaking.
  • Features: Simple to use, impossible to mess up, and well built. Recommend to anyone in the service industry (Directly replace part numbers 303-1510).
  • 100% SATISFACTION GUARANTEE: If you're not 100% satisfied with Sunluway Front Crankshaft Seal Remover, simply return it for a full refund in 30 days. Premium Support & 12-Month Warranty.
Check Stock

GSSI Sealants Butyl Tape 1/8\ x 1\ x 50' Black

  • Makes construction jobs move smoothly and quickly.
  • Superior adhesion. Stronger than standard putty tapes. Easily trimmed with blunt tool. Awled quickly and cleanly. Provides watertight seal. Easy application. Excellent adhesion to sidewalls. No discoloration..
  • To purchase a quantity of 2 (100ft) see ASIN: B072N1P4NG. To purchase a quantity of 8 (400ft) see ASIN: B01D98QHB0..
  • For best results, apply in dry conditions above 40°F (4°C)..
  • NOTE: MH-19 is a sealant and not a structural adhesive. Its tacky surface allows the tape to adhere to various substrates to obtain a good seal, but it’s not intended to be the sole structural component. Mechanical fasteners may be needed..
Check Stock

NorthStar Self-Priming Semi-Trash Water Pump - 4in. Ports, 23,040 GPH, 3/4in. Solids Capacity, 270cc Honda GX270 Engine

  • Long-life silicon carbide mechanical seal resists corrosion, wear and heat better than a standard seal.
  • Cast iron impeller and volute last longer for semi-trash operations.
  • Silicon carbide seals are 2 times harder, 15% tougher, and 50% stronger than common aluminum oxide seals.
Check Stock

Little Giant WRS-6 1/3HP Water Removal System - 115V- Integral- 7-10\ On Level

  • BUILT TO LAST: Rugged epoxy-coated cast iron housing and volute, thermoplastic elastomer vortex-style impeller, Nitrile with carbon/ceramic faced mechanical shaft seal.
  • handles solids up to 2-inches in diameter.
  • AUTOMATIC OPERATION: Piggy-back mechanical float switch activates the pump when liquid reaches 16 to 19 inches and turns the pump off when liquid reaches 9 to 11 inches.
  • PUMP SPECIFICATIONS: 7200 GPH at 5-foot lift.
  • maximum water temperature of 140 degrees F, 20-ft. cord, 2-inch FNPT discharge.
Check Stock

O Rings 270 Pieces Seal Gasket Washer O Ring Assortment Set Kit 18 Sizes, Replacement O-Ring Kit Grommets Heavy Duty Professional for A/C Automotive, Mechanic,Tools & Home Repairs with Case - COPACHI

  • ... a sturdy plastic case with a size key to help identify which “O” ring is needed.
  • Save time and effort by keeping your workbench organized.
  • High-resistance Material: The O rings are made of Nitrile-butadiene rubber (NBR), offering great resistance to heat, powerful, durable and elastic.
  • These round cross-section mechanical gaskets ensure high protection against oils, fats, hydrocarbons, diluted acids.
  • Working Temperature Range: Used in every field of industry including aerospace, hydraulic, automotive or general engineering, these rings are wear-resistant with efficient mechanical qualities.
  • The rubber o rings are made of high quality nitrile rubber (NBR ), so assortment can resist -40°C (-40°F) to 120°C (248°F), to avoid leakness..
  • Cost-effective: There are 790 Pcs of various sizes both metric and imperial sizes with high-quality finishes.
  • 19 Different sizes provide a great choice for your needs.
  • Efficient and economical set will help you seal all liquid and gaseous media.
  • Endless Application: These doughnut-shaped faucets are highly useful in a huge range of applications, from appliances found around the home, cars, cameras, plumbing, scuba gear, paintball, pressure gauge, to gigantic machines used in manufacturing and even in the space shuttle....
Check Stock

WAYNE CWS75 - 3/4 HP Cast Iron Convertible Jet Well Pump - Up to 462 Gallons Per Hour - Heavy Duty Jet Well Pump

  • Durable machined heavy-duty construction pump body provides long product life.
  • High quality proven pressure switch with adjustable on/off pressure settings. 20 PSI differential..
  • Heavy-duty motor with double ball bearing design and voltage selection device.
  • Mechanical shaft seal with ceramic face and stainless steel construction for long seal life, Pressure regulator included..
  • Pumps are manufacturer tested and may contain water inside from such testing.
Check Stock

Camco Suction Cup Utensil Holder - Prevents Your Utensils from Moving Around During Travel, Perfect for RV, Boats, Fits Into Compact Spaces (43816) , Gray

  • Suctions securely to your counter during travel.
  • Designed for compact spaces—perfect for RVs and boats.
  • Features a super strong mechanical suction cup.
  • Suction cups may not work on porous surfaces, even glass. If the glass is textures the cup will not seal. If the surface is porous, the cups will lose seal..
Check Stock