ReviewsInput Voltage

High Speed Comparator High Speed Frequency Meter Front Shaping Comparator for Low-Voltage Applications Conversion Circuit

  • LOW VOLTAGE APPLICATIONS -- The input common mode range is better than the swing input, which is very suitable for low voltage applications..
  • APPLICATION -- Digital module can be used for wide voltage range and periodic signal shaping..
  • FRONT END ADJUSTMENT -- Used as a front end conditioning module in time domain measurements for frequency and phase difference..
  • PARAMETER -- The input voltage is 10 to 1000mV, the input frequency is about 200MHz DC, and the input impedance is 50 ohms..
  • RAIL TO RAIL OUTPUT -- The output level mode is rail to rail output, which can directly drive TTL / CMOS level..
Check Stock

10 Pieces DC-DC Boost Converter 2A Adjustable Module Voltage Regulator Board Input Voltage 2 Volt-24 Volt to 5 Volt-28 Volt Output Voltage (Without USB Connector)

  • Product size: 36 x 17 x 14 mm/ 1.42 x 0.67 x 0.55 inch (L x W x H).
  • Method of use: the module of the IN+ and - after 2-24V, IN adjusting the potentiometer can adjust output voltage, output voltage is greater than the input voltage.
  • Matters needing attention: 1. The input voltage should not exceed the maximum input voltage.
  • 2. The peak current output current is no more than TV university.
  • Package included: 10 x DC-DC power apply module booster power module, max output is 28Volt.
Check Stock

Ximimark 1Pcs ESP8266 Network Relay WIFI Module 220V 10A DC 7-30V 4 Layers Board TVS Input Automatic Protection

  • The ESP8266 Wifi module is designed with a 4-layer board. It is safer to use the relay PCB pin anti-climbing design. The access control server passes the TCP CLIENT mode. Controlled by the HTTP protocol..
  • Input overvoltage protection, TVS input, automatic protection will run when the voltage exceeds 33V. Single optocoupler isolated input, TVS input protection..
  • Wide voltage input, input voltage: DC 7V - DC 30V, input overcurrent protection..
  • 220V 10A relay, one normally open, one normally closed. An output status indicator, an input status indicator..
  • Board dimensions: 65 × 40 × 20mm (1mm = 0.0393inch).
Check Stock

CKT3800-150B Touch Screen Dry Block Temperature Calibrator, Dry Type Temperature Calibration Furnace Temperature Range -30℃~150℃

  • Note: This product series's input supply voltage is 220V, currently it does not support 110V input voltage, if end user's country use 110V input voltage, need to buy the 110-220V converter or regulator, buyers can buy the converter from us or buy a regulator locally. For 220V input voltage country, no need to buy the converter/regulator..
Check Stock

CKT3800-150A Touch Screen Dry Well Block Temperature Calibrator, Dry Type Temperature Calibration Furnace Temperature Range -20℃~150℃

  • Note: This product series's input supply voltage is 220V, currently it does not support 110V input voltage, if end user's country use 110V input voltage, need to buy the 110-220V converter or regulator, buyers can buy the converter from us or buy a regulator locally. For 220V input voltage country, no need to buy the converter/regulator..
Check Stock

DC Voltage Reducer Converter, DC 24V to 12V 5A Buck Converter, Automatic Car Step Down Up Voltage Regulator, Transformer Waterproof Module

  • High-quality material: Encapsulated with high-quality die-cast aluminum material shell, with good heat dissipation function, with silicone potting at the back, waterproof, dust-proof, shock-resistant, safe and reliable..
  • Power conversion efficiency: Using synchronous rectification technology and built-in smart chip, the voltage converter provides over/under voltage input, over temperature, short circuit, reverse input, waterproof, low voltage comprehensive protection..
  • Widely used: The output power is 60w, which is widely used in motors, driving recorders, car trucks, vehicles, golf carts, LED light strips, electric fans, cameras, lights, screens, monitoring systems, solar panels and DIY, etc..
  • Input rated voltage: 24V DC, accept (18V-36V DC) range.
  • Output voltage, current, power: DC 12V 5A 60W.
  • Input wiring type: red positive, black negative.
  • Output wiring type: yellow positive, black negative..
  • Adopt synchronous rectification technology, wide voltage input, improve conversion efficiency, maximum efficiency: 92%-97%.
  • If you have any questions, please feel free to contact us, We will reply within 24 hours..
Check Stock

DC 12V 30A Power Supply 360W Universal Regulated Switching AC to DC Converter AC110V/220V (SMPS) Transformer Driver Adapter for LED Strip Light, CCTV Camera Security System, Radio, Computer Project

  • Switch power supply convert AC 110V/220V to DC 12V 30A 360W: The default input voltage is 110V, Output voltage is adjustable 10% , Metal case with many holes makes heat dissipation more efficient..
  • AC 110V/220V Input Voltage: We have already adjusted the switcher to 110V/115V for our US customers, if you want to use AC220V,don't forget to adjust the switch to the 220V side before use.★AC 110V/220V.Wide voltage input adjusted automatically to SMPS Model (12V 1A-5A, 12W-60W). As for Model (12V 10A-60A 120W-600W), there is a voltage selector switch located on the side of the switcher is used to set the input voltage to the power supply to either 110V/115V or 220V/230V..
  • High Efficiency and Reliability: Smart device surge protection for Short-circuit Protection, Overload Protection, Over Voltage, Over Temperature Protection. Low Temperature Rise.★Voltage consistency:There is no voltage fluctuations to speak of at power on, during transmit, receive, or at power off.★Built-in EMI filter, low output ripple, noise, Rugged heavy duty enclosure, 100% Full load burn-in Tested. Parallel/Redundancy Operation is possible..
  • Widely used in: Wide input voltage range, steady and precise output voltage.Great power transformer for Led Lighting and CCTV Camera Securit....
Check Stock

APC Smart-UPS RT SURTD5000RMXLT3U 3500W/5000VA 208V 3U/Tower UPS System

  • Output Power Capacity: 3500 Watts / 5000 VA Max Configurable Power: 3500 Watts / 5000 VA Nominal Output Voltage: 208 V Output Voltage Note:....
  • Output Voltage Distortion: Less than 3% Output Frequency (sync to mains): 50/60 Hz +/- 3 Hz user adjustable +/- 0.1 Crest Factor: Upto 3:1 Waveform....
  • Nominal Input Voltage: 208 V Input Frequency: 50/60 Hz +/-5Hz (auto sensing) Input Connections: NEMA L6-30P Cord Length: 3.05 meters Input voltage....
  • Battery Type: Maintenance-free sealed Lead-Acid battery with suspended electrolyte - leakproof Included Battery Modules: 2 Typical recharge time: 2.5....
  • Interface Ports: Smart-Slot Pre-Installed SmartSlot Cards: AP9619 Control panel: LED status display with load and battery bar-graphs and On Line - On....
Check Stock

Aideepen 1200W 20A DC Converter Boost Car Step-up Power Supply Module Adjustable Voltage Converter 8-60V to 12-83V

  • 【Features】Input overcurrent protection.
  • 【DIY projects】It adopts 7 electrolytic capacitors and a 33MM high-power iron-silicon-aluminum magnetic ring to prevent over-temperature magnetic saturation under high current conditions. Use a piece of aluminum radiator on the back to dissipate heat ，Reserve fan mounting holes, suitable for more DIY projects..
  • 【Adjustable Voltage 】1200W 20A DC converter boost Input voltage range is DC 10-60V, Output voltage range is DC 12-80V.can be arbitrary adjustable.
  • Input current: 0.5-20A (MAX),Max output power is 1200W.(exceeds 15A, please add fan cooling）.
  • 【Output Power】Input voltage * 20A, such as: input 12V * 20A = 240W, input 24V * 20A = 480W，input 60V * 20A = 1200W Note: Do not use the short-circuit output method to adjust the current. It is recommended to use a smaller adjustment range..
  • 【Widely Application】can be used for high power solar street lamp driving, various LED lighting CV driving, vehicle-mounted and mobile device power, DIY adjustable CV CC power, solar power charging, and various batteries charging..
Check Stock

AC 110V/220V to DC 12V 15A 180W Power Supply Transformer Switch,MKASYON AC/DC Switching Adapter Converter Driver for LED Strip Light,CCTV Camera,Security System Computer Project,Radio 12V15A

  • The input voltage: AC 110V/240V, the output power: DC 12V 15A 180W.Output voltage is adjustable 10%..
  • Safety features: Shortage Protection, Overload Protection, Over-voltage Protection..
  • Wide input voltage range, steady and precise output voltage.Size:L x W x H: 7.9”x3.9”x1.6”.
  • Great for LED Strips, radio transceiver, CCTV cameras,audio amplifier, computer project, wireless router, audio/ video power supply and more..
  • NOTES:Dual input voltage: AC 110V/220V. There is a switch, Please change the switch to 110V for USA.Before power on please check input voltage....
Check Stock

Juried Engineering TL072CP TL072 IC JFET Operational Amplifier & 8-Pin DIP Sockets with Machined Contact Pins Breadboard-Friendly (Pack of 5)

  • The TL072 JFET-input operational amplifiers incorporate well-matched, high-voltage JFET and bipolar transistors in a monolithic integrated circuit. The devices feature high slew rates, low-input bias and offset currents, and low offset-voltage temperature coefficient..
  • Low Power Consumption, Wide Common-Mode and Differential Voltage Ranges, Low Input Bias and Offset Currents.
  • Output Short-Circuit Protection, Low Total Harmonic Distortion: 0.003% (Typical), Low Noise Vn = 18 nV/√Hz (Typical) at f = 1 kHz.
  • High-Input Impedance: JFET Input Stage, Internal Frequency Compensation, Latch-Up-Free Operation.
  • High Slew Rate: 13 V/µs (Typical), Common-Mode Input Voltage Range Includes VCC+, Example Applications: Motor Integrated Systems: UPS, Drives and Control Solutions: AC Inverter and VF Drives, Renewables: Solar Inverters, Pro Audio Mixers, DLP Front Projection System, Oscilloscopes.
Check Stock