ReviewsInternal Vent Valve

Advantec 353130 Vacuum Filtration Manifold Stainless Steel 3-Branch with 3-Way Valves

  • Three-way valve enables you to vent the branch to atmosphere without breaking the vacuum connection|three-way valve vent is a female luer slip connection to accept a standard syringe filter.
  • Two- and three-way valves feature ptfe stopcocks for smooth control|valves provide independent control at each branch for vacuum and venting|connect three or six filter holders to one vacuum source.
Check Stock

Blackhawk B6350 Black/Red Fast Lift Service Jack - 3.5 Ton Capacity, 28 1/2\ L x 13 3/4\ W x 6 1/2\ H

  • Built-in internal safety valve and vent plug ensures safe operation.
  • Swivel saddle provides easy jack positioning and user safety.Saddle Diameter: 4 inch.
  • Jack Size: 28 1/2" L x 13 3/4" W x 6 1/2" H.
  • Rugged universal joint for precise load control.
  • Great for working in the garage and other outdoor activities such as picnics or ball games.
  • Note: The hydraulic jack is designed to lift, not to support the object. Immediately after lifting, loads must be supported by a pair of appropriately rated jack stands.
Check Stock

Part# 06H145710D Turbo Diverter Valve For A3 A4 TT Quattro Volkswagen Jetta Passat Beetle CC Eos GTI - Replace Part Number 06F145710G

  • The diverter valve is usually located on the side of the turbocharger. The purpose of the diverter valve is to vent excess boost when the throttle is closed (you lift off the accelerator or change gear). Without venting this excess pressure, the turbo experiences surge which is actually damaging to the turbo..
  • By the same token, when the throttle is open and you are building boost, this valve must stay shut and not vent boost from the high pressure side to the low pressure side. Venting this boost under wide open throttle causes a boost leak and a drop in power..
  • This Turbo Drivter Valve fits for 2006 - 2011 A3, 2010 - 2013 A3 Quattro, 2005 - 2013 A4 , 2005 - 2013 A4 Quattro, 2008 - 2009 TT, 2009 - 2011 TT Quattro, 2009 - 2011 Volkswagen CC 2.0L L4, 2007 - 2011 Volkswagen Eos, 2006 - 2011 Volkswagen GTI, 2006 - 2010 Volkswagen Jetta, 2006 - 2010 Volkswagen Passat, 2012 Volkswagen Beetle 2.0L..
  • Customers also can find the product you need accurately according to the OE number. OEM Number: 06H 145 710 D, 06F 145 710 G, 06F 145 710 C, 06F 145 710 B, 06H145710D, 06F145710G, 06F145710B, 06F145710C..
  • If the valve is defective or inadequate, you will get a loss of boost, extended lag or a throttle response that is sluggish, the turbo charger will wear out soon ....
Check Stock

Class A Customs 40 Gallon RV Waste Black Water Holding Tank WT-4000

  • 40 Gallon RV Waste Water Holding Tank MADE IN THE USA by Class A Customs using Medium Density Polyethylene (MDPE) Resin TANK NOT FOR FRESH OR DRINKING WATER USE – WASTE/GRAY WATER USE ONLY – Used in RV’s Campers, Trailers, Motorhomes and Tiny Houses.
  • INSTALLED OUTLET 3” ABS Female Pipe - outlet can not be moved DO NOT over-tighten fittings damage will occur Dump valves do not hook directly to the 3" ABS fitting, from the outlet run PVC or ABS piping (not included), dump valve (not included) is added to the piping..
  • INLET & VENT INSTALLATION Class A Customs Black Water Tanks only come with the outlet the end user will determine where the inlet and vent will need to be placed and install, hardware NOT included. TANK MUST BE VENTED allowing air in and out when in use. *DO NOT PRESSURIZE TANK* DO NOT over-tighten fittings damage will occur..
  • NOT INCLUDED Inlet and Vent Fittings / Additional Fittings / Hardware / Mounting Hardware / Dump Valve / Piping NOT INCLUDED.
Check Stock

Class A Customs 27 Gallon RV Waste Black Water Holding Tank WT-2700

  • 27 Gallon RV Waste Water Holding Tank MADE IN THE USA by Class A Customs using Medium Density Polyethylene (MDPE) Resin TANK NOT FOR FRESH OR DRINKING WATER USE – WASTE/GRAY WATER USE ONLY – Used in RV’s Campers, Trailers, Motorhomes and Tiny Houses.
  • INSTALLED OUTLET 3” ABS Female Pipe - outlet can not be moved DO NOT over-tighten fittings damage will occur Dump valves do not hook directly to the 3" ABS fitting, from the outlet run PVC or ABS piping (not included), dump valve (not included) is added to the piping..
  • INLET & VENT INSTALLATION Class A Customs Black Water Tanks only come with the outlet the end user will determine where the inlet and vent will need to be placed and install, hardware NOT included. TANK MUST BE VENTED allowing air in and out when in use. *DO NOT PRESSURIZE TANK* DO NOT over-tighten fittings damage will occur..
  • NOT INCLUDED Inlet and Vent Fittings / Additional Fittings / Hardware / Mounting Hardware / Dump Valve / Piping NOT INCLUDED.
Check Stock

Class A Customs 14 Gallon RV Waste Black Water Holding Tank WT-1400

  • 14 Gallon RV Waste Water Holding Tank MADE IN THE USA by Class A Customs using Medium Density Polyethylene (MDPE) Resin TANK NOT FOR FRESH OR DRINKING WATER USE – WASTE/GRAY WATER USE ONLY – Used in RV’s Campers, Trailers, Motorhomes and Tiny Houses.
  • INSTALLED OUTLET 3” ABS Female Pipe - outlet can not be moved DO NOT over-tighten fittings damage will occur Dump valves do not hook directly to the 3" ABS fitting, from the outlet run PVC or ABS piping (not included), dump valve (not included) is added to the piping..
  • INLET & VENT INSTALLATION Class A Customs Black Water Tanks only come with the outlet the end user will determine where the inlet and vent will need to be placed and install, hardware NOT included. TANK MUST BE VENTED allowing air in and out when in use. *DO NOT PRESSURIZE TANK* DO NOT over-tighten fittings damage will occur..
  • NOT INCLUDED Inlet and Vent Fittings / Additional Fittings / Hardware / Mounting Hardware / Dump Valve / Piping NOT INCLUDED.
Check Stock

Class A Customs 31 Gallon RV Waste Black Water Holding Tank WT-3100

  • 31 Gallon RV Waste Water Holding Tank MADE IN THE USA by Class A Customs using Medium Density Polyethylene (MDPE) Resin TANK NOT FOR FRESH OR DRINKING WATER USE – WASTE/GRAY WATER USE ONLY – Used in RV’s Campers, Trailers, Motorhomes and Tiny Houses.
  • INSTALLED OUTLET 3” ABS Female Pipe - outlet can not be moved DO NOT over-tighten fittings damage will occur Dump valves do not hook directly to the 3" ABS fitting, from the outlet run PVC or ABS piping (not included), dump valve (not included) is added to the piping..
  • INLET & VENT INSTALLATION Class A Customs Black Water Tanks only come with the outlet the end user will determine where the inlet and vent will need to be placed and install, hardware NOT included. TANK MUST BE VENTED allowing air in and out when in use. *DO NOT PRESSURIZE TANK* DO NOT over-tighten fittings damage will occur..
  • NOT INCLUDED Inlet and Vent Fittings / Additional Fittings / Hardware / Mounting Hardware / Dump Valve / Piping NOT INCLUDED.
Check Stock

Class A Customs 30 Gallon RV Waste Black Water Holding Tank WT-3000

  • 30 Gallon RV Waste Water Holding Tank MADE IN THE USA by Class A Customs using Medium Density Polyethylene (MDPE) Resin TANK NOT FOR FRESH OR DRINKING WATER USE – WASTE/GRAY WATER USE ONLY – Used in RV’s Campers, Trailers, Motorhomes and Tiny Houses.
  • INSTALLED OUTLET 3” ABS Female Pipe - outlet can not be moved DO NOT over-tighten fittings damage will occur Dump valves do not hook directly to the 3" ABS fitting, from the outlet run PVC or ABS piping (not included), dump valve (not included) is added to the piping..
  • INLET & VENT INSTALLATION Class A Customs Black Water Tanks only come with the outlet the end user will determine where the inlet and vent will need to be placed and install, hardware NOT included. TANK MUST BE VENTED allowing air in and out when in use. *DO NOT PRESSURIZE TANK* DO NOT over-tighten fittings damage will occur..
  • NOT INCLUDED Inlet and Vent Fittings / Additional Fittings / Hardware / Mounting Hardware / Dump Valve / Piping NOT INCLUDED.
Check Stock

Class A Customs 24 Gallon RV Waste Black Water Holding Tank WT-2400

  • 24 Gallon RV Waste Water Holding Tank MADE IN THE USA by Class A Customs using Medium Density Polyethylene (MDPE) Resin TANK NOT FOR FRESH OR DRINKING WATER USE – WASTE/GRAY WATER USE ONLY – Used in RV’s Campers, Trailers, Motorhomes and Tiny Houses.
  • INSTALLED OUTLET 3” ABS Female Pipe - outlet can not be moved DO NOT over-tighten fittings damage will occur Dump valves do not hook directly to the 3" ABS fitting, from the outlet run PVC or ABS piping (not included), dump valve (not included) is added to the piping..
  • INLET & VENT INSTALLATION Class A Customs Black Water Tanks only come with the outlet the end user will determine where the inlet and vent will need to be placed and install, hardware NOT included. TANK MUST BE VENTED allowing air in and out when in use. *DO NOT PRESSURIZE TANK* DO NOT over-tighten fittings damage will occur..
  • NOT INCLUDED Inlet and Vent Fittings / Additional Fittings / Hardware / Mounting Hardware / Dump Valve / Piping NOT INCLUDED.
Check Stock

Class A Customs 38 Gallon RV Waste Black Water Holding Tank WT-3800

  • 38 Gallon RV Waste Water Holding Tank MADE IN THE USA by Class A Customs using Medium Density Polyethylene (MDPE) Resin TANK NOT FOR FRESH OR DRINKING WATER USE – WASTE/GRAY WATER USE ONLY – Used in RV’s Campers, Trailers, Motorhomes and Tiny Houses.
  • INSTALLED OUTLET 3” ABS Female Pipe - outlet can not be moved DO NOT over-tighten fittings damage will occur Dump valves do not hook directly to the 3" ABS fitting, from the outlet run PVC or ABS piping (not included), dump valve (not included) is added to the piping..
  • INLET & VENT INSTALLATION Class A Customs Black Water Tanks only come with the outlet the end user will determine where the inlet and vent will need to be placed and install, hardware NOT included. TANK MUST BE VENTED allowing air in and out when in use. *DO NOT PRESSURIZE TANK* DO NOT over-tighten fittings damage will occur..
  • NOT INCLUDED Inlet and Vent Fittings / Additional Fittings / Hardware / Mounting Hardware / Dump Valve / Piping NOT INCLUDED.
Check Stock

Class A Customs 28 Gallon RV Waste Black Water Holding Tank WT-2800

  • 28 Gallon RV Waste Water Holding Tank MADE IN THE USA by Class A Customs using Medium Density Polyethylene (MDPE) Resin TANK NOT FOR FRESH OR DRINKING WATER USE – WASTE/GRAY WATER USE ONLY – Used in RV’s Campers, Trailers, Motorhomes and Tiny Houses.
  • INSTALLED OUTLET 3” ABS Female Pipe - outlet can not be moved DO NOT over-tighten fittings damage will occur Dump valves do not hook directly to the 3" ABS fitting, from the outlet run PVC or ABS piping (not included), dump valve (not included) is added to the piping..
  • INLET & VENT INSTALLATION Class A Customs Black Water Tanks only come with the outlet the end user will determine where the inlet and vent will need to be placed and install, hardware NOT included. TANK MUST BE VENTED allowing air in and out when in use. *DO NOT PRESSURIZE TANK* DO NOT over-tighten fittings damage will occur..
  • NOT INCLUDED Inlet and Vent Fittings / Additional Fittings / Hardware / Mounting Hardware / Dump Valve / Piping NOT INCLUDED.
Check Stock