ReviewsIr Emitter Cable Extension

Gone in 60 Seconds

• ➤Works with all 38-56kHz IR remote control and devices with an IR input port..
• ➤Low current drive, low power consumption, long launch distance, small size installed..
• ➤Applied to infrared forwarding equipment, audio and video transmission equipment, IR remote wireless transceiver, centralized control equipment, etc..
• ➤Please note that the infrared emitter head is glued to the side of the infrared receiver tube, do not cover it, otherwise the device will not be used, and it will be insensitive to remote control by remote control ..

St !GIANTMAN IR Infrared Emitter Extender Cable Extension Single HeadEye 3.5mm Jack Infrared Red Transmitter Blaster Eye Wire Cord Compatible with IR Repeater Extender System (IR-1.5m)

• Single IR Emitter Extension Cable compatible with devices in 38khz.
• 20-25 ft range from remote control to IR receiver. High Immunity to ambient light and noise.
• Highly Reliable with high sensitivity for wide range..
• 5 ft shielded cable, 3.5 mini plated stereo plug. Tip-VCC 5V, Center-Data,Lower-Ground, Lower-Ground.

OBVIS IR Infrared Remote Control Extender Repeater Cable (10 Feet) - IR Signal Receiver & IR Emitter Blaster Extension Cable Wire Cord USB Powered System Kit - Black

• This Infrared Repeater Cable applies to all remote control devices from 38 to 56 khz.
• IR Repeater Extension controls Audio Video Components in Entertainment Cabinets or Equipment Closets using Existing IR Remote Controls.
• Come with adhesive backing sticks directly onto different devices.
• 1 Receiver, 1 Emitter, Connects to USB port on TV or home theater device for power.

Sewell SW-32988 Direct BlastIR Wireless Pro IR Repeater, Remote Control Extender Kit (IR Emitter and Receiver),Black

• Note Some devices use RF instead of IR for remote control. The Blast IR Wireless Pro only works with IR devices. Please check the signal type of your remote to ensure it is IR before ordering. .Wireless Distance: 200m (650 ft.), distance may vary due to obstacles, IR Receiver Distance: 7m (30 ft.)Incompatibility : Yamaha HTR 6140, Arris DCX 3520E-M, OSD ATM-7 Speaker Selector.
• BlastIR Pro receivers are directional and require facing the receiver towards where you will be using the remote. To improve reception and widen the angle of control, we recommend using the included IR receiver cable connected to the main receiver unit..
• BlastIR Pro Emitters work best when placed within a few inches of the devices you want to control. For best results we recommend attaching the included optional IR emitter cables so that the emitter is directly over the IR receiver of up to two devices. These are designed to stick directly to the devices that you are trying to control rather than sitting in front of them..
• Included USB and AC power cables, extra IR cables, mounting adhesive, and rubber feet..
• Wireless Distance: 200m (650 ft.), distance may vary due to obstacles, IR Receiver Distance: 7m (30 ft.).

uxcell IR Infrared Emitter Extension Cable 4.9ft Long 45 Degree Emission Angle 3.5mm Jack Single Red Head 2pcs

• Works with all 38-56kHz IR remote control and devices with an IR input port..
• Low current drive, low power consumption, long launch distance, small size installed..
• Applied to infrared forwarding equipment, audio and video transmission equipment, IR remote wireless transceiver, centralized control equipment, etc..
• Please note that the infrared emitter head is glued to the side of the infrared receiver tube, do not cover it, otherwise the device will not be used, and it will be insensitive to remote control by remote control..

WenkeDigi IR Infrared Repeater System kit, IR Repeater Extender, Max 100 Feet Efficient Receiver Range - IR Remote Control Hidden Devices -10 Feet IR Receiver Cable (Can Run 400 Feet by Your Cat5e)

• This IR kit is a device that only passes on the infrared signal . It is used to control Four (4) IR devices out of sight that are kept in a closed cabinet or in anther room ( expandable up to 18, and 4 x single emitter provided in the package , Additional IR Emitters sold separately, One emitter one device ) . Strong Compatibly , It is compatible with almost all the IR electronic appliances like SKY STB and CISCO DVD player , SONY receivers ,Amplifier, Xbox, TV , Blu-ray player,etc with its wide frequency range 20 KHz to 60KHz ..
• Mini Block Size , Dual Sensors Mini Bar IR receiver , One Sensor 38KHz , the Other 56KHz, with long effective remote control distance up to 100 FEET @38KHz and 23 FEET at 56KHz , High sensitivity, Real time transmission without any delay . It allows you to control your home theater with your existing IR remote controller. NOTE : NOT support RF and Bluetooth Remote Control ..
• This IR Repeater system kit supplies with an ideal solution for those who want to conceal their A/V components equipment inside a entertainment system cabinet or closet door for a clean, stylish look. It makes it possible to control multiple IR devices while these are in a closed cupboard or in a remote location out of sight ..

USB Powered Infrared Repeater Hide Your Set top Box

Nextgen IR Extender - Infrared Remote Control Distance Extender Kit - IR Repeater Kit with IR Emitter - IR Receiver Extender Controls All Your Home’s Remote Signal Devices - Hide Cable Box and Wires

• ...e and voice remote pro) control TV, cable box, , receiver, amp, Blu-ray player, and controlling various IR-controlled devices to extend distance and versatility..
• KIT INCLUDES - 1 x IR receiver extender with built in power cell charger. 1 x Power adapter. 1 x Single eye IR emitter. 1 x Transmitter. 1 x Transmitter adapter for AA compartments. 2 x power rechargeable power cells..
• MORE CONTROL FOR TV - Wield greater control over your TV volume and channel changing ability. Use it as a wireless cable TV extender to change the channel or adjust the volume from any room, including downstairs to upstairs. Works with all AA and AAA remotes..
• 100 FT. RANGE THROUGH WALLS - IR remote control extender transmits your remote's signal up to 100 feet through walls, floors, windows, and doors offering limitless control, even from outdoors. Serious performance with zero lag and impressive user-friendly functionality..
• EASY TO INSTALL - Place the receiver in front of the component you wish to control or attach the bright eye emitter to it. Then simply replace one of the AA or AAA batteries....

Xantech DL95K Universal Dinky Link Extended Range IR Kit

• Low profile and easy to hide, it works with all types of cable boxes, satellite boxes, and TVs.
• Proprietary ambient noise-suppression technology for reliable operation in any lighting environment including compact fluorescents.
• IR modulation frequency bandwidth: 25-60kHz.
• Reception range: up to 120 ft (36m) depending on conditions.
• Color-coded connectors for fast, easy installation.
• Kit includes DL95 IR receiver, Model 789-44 connecting block that connects one IR receiver to four IR emitter ports (can drive up to four dual....

TNP IR Emitter Extender Extension Cable (10 Feet) - Triple 3 Head 3.5mm Jack Infrared Red Transmitter Blaster Blink Eye Wire Cord Compatible with IR Repeater Extender System Kit, Xbox One

• Passes IR communication: Used with an IR Repeater kit to control a device.
• Extend remote control ability to any room in the house.
• Adhesive backing allows the emitter to be attached to the IR eye of a device.
• Triple Heads allow you to control multiple pieces of equipment with only one IR output.
• For use with IR extender extension system, Xbox One, IR Connecting Blocks and Home Automation controllers.

Obvis USB IR Repeater - Infrared Extender Repeater Hidden IR Repeater System with 1 Emitters 1 Receiver

• IR Repeater compatible with all remote control devices with frequency range between 38 to 56khz.
• Control Audio Video Components in Entertainment Cabinets or Equipment Closets using Existing IR Remote Controls.
• Infrared Repeater comes with adhesive backing sticks directly onto different devices.
• Cable Length From USB To Receiver: Approx. 4 Feet.
• Cable Length From Receiver To Emitter: Approx. 6.5 Feet.