ReviewsJtag Cable

Micro IC Pins Programming Clip for ISP program SOP/SOIC/TSSOP/TSOP/SSOP/MSOP/PLCC/QFP/TQFP/LQFP/SMD IC chip test pin mini chip adapter socket

The ST-LINK/V2 is an in-circuit debugger and programmer for the STM8 and STM32 microcontroller families.
The single wire interface module (SWIM) and JTAG/serial wire debugging (SWD) interfaces are used to communicate with any STM8 or STM32 microcontroller located on an application board.
STM8 applications use the USB full-speed interface to communicate with the ST Visual Develop (STVD) or ST Visual Program (STVP) software..
STM32 applications use the USB full-speed interface to communicate with Atollic, IAR, Keilor TASKING integrated development environments..

Complete new professional design with own robust enclosure and 40pin ZIF socket.
Fully automatic & no manual set-up needed (eliminate all jumpers & DIP-switches).
Fast mode SPI programming & JTAG support wider the application.
True USB data transfer interface with PC/LapTop for newer laptop use as well as portable application.
Working with the adapters further expands the supported devcices list.

Fast NAND programming and for XILINX CR JTAG programming, good performance, easy to use..
Compatible with all for CoolRunners inc, Phat and Slim, and compatible with all NAND X QSB..
Support for complete late monitoring, equipped with LED light for power and data indicator..
Easy installation system, including for KIOSK option for remote opening, built in programmer for future firmware upgrades..
Designed for J Runner application (Build 283 +), tested by professional team, reliable to use..

snickerdoodle Single-Board-Computer Baseboard.
HDMI Type A Input and Output up to WUXGA (1920 x 1200p) at 60Hz and 8-ch., 32-bit/192kHz HDMI Audio.
Dual FPGA-Connected Gigabit Ethernet RJ45 Jacks with PHY Support for Time-Sensitive Networking (TSN).
Stereo Audio Line Input, Output, and Headset (Mono Mic) via 3.5mm Jack with Dedicated 96kHz CODEC.
Four USB 2.0 Hi-Speed Standard-A Host Receptacles, 25 Reconfigurable FPGA I/O Pins, Xilinx JTAG.

FCC/IC/CE Certified 8/16/2019 (ID Number 2ASW8-ART3MIS) on the world’s first open-source, US manufactured, BLE module.
1M Flash / 384k RAM gives you plenty of room for your sketches. 48MHz / 96MHz turbo available.
Includes 48 GPIO pins - all interrupt capable. 31 PWM channels. Built in technology compatible with Bluetooth low energy 4.0 radio.
Features 10 ADC channels with 14-bit precision, 2 UARTs, 6 I2C buses, 6 SPI buses, PDM Interface.
Exposed JTAG connector for more advanced users to use the power and speed of professional tools.

The Artemis module has the FCC/IC/CE Certification 8/16/2019 (ID Number 2ASW8-ART3MIS) on the world’s first open-source, US manufactured, BLE module.
1M Flash / 384k RAM gives you plenty of room for your sketches. 48MHz / 96MHz turbo available.
Includes 24 GPIO pins - all interrupt capable. 21 PWM channels. Built in technology compatible with Bluetooth low energy 4.0 radio.
Features 10 ADC channels with 14-bit precision, 2 UARTs, 6 I2C buses, 4 SPI buses, PDM Interface.
Exposed JTAG connector for more advanced users to use the power and speed of professional tools.

The STLINK-V3SET is a modular stand-alone debugging and programming probe for the STM8 and STM32 microcontrollers. It is composed of a main module and....
The SWIM and JTAG/SWD interfaces are used to communicate with any STM8 or STM32 microcontroller located on an application board..
The STLINK-V3SET also provides a Virtual COM port interface allowing the host PC to communicate with the target microcontroller through one UART, and....
The modular architecture of STLINK-V3SET enables to extend its main features through additional modules such as the adapter board..

FCC/IC/CE Certification 8/16/2019 (ID Number 2ASW8-ART3MIS) on the world’s first open-source, US manufactured, BLE module.
1M Flash / 384k RAM gives you plenty of room for your sketches. 48MHz / 96MHz turbo available.
Includes 21 GPIO pins - all interrupt capable. 21 PWM channels. Built in technology compatible with Bluetooth low energy 4.0 radio.
Features 8 ADC channels with 14-bit precision, 2 I2C buses, 1 SPI bus, PDM Digital Microphone.
Exposed JTAG pin holes for more advanced users to use the power and speed of professional tools.

LA2016 is a high-performance logic analyzer with 16 full channels and 200MHz sampling rate..
It is composed of two parts: software on personal computer and hardware equipment. It has the advantages of high sampling rate, large sampling depth, easy to use, etc..
LA2016 can sample 16 digital signal at same time. Then the sampled data can be displayed, analyzed, exported and saved on the computer. Software can also decode the data if it conform to the standard protocol of the software supported. Then the decoded data can be displayed, exported and saved..
Supported standard protocols: UART/RS-232/485, I2C, SPI, CAN, DMX512, HDMI CEC, I2S/PCM, JTAG, LIN, Manchester, Modbus, 1-Wire, UNI/O, SDIO, SMBus, USB1.1, PS/2, NEC InfraRed, Parallel, etc....
Supported OS: MAC OS,Linux,Windows XP, Vista, Windows 7/8/10(32/64bit).

LA5016 is a high-performance logic analyzer with 16 channels and 500M max sampling rate..
Composed of two parts: software on personal computer and hardware equipment. It has the advantages of high sampling rate, large sampling depth, easy to use, etc..
LA5016 can sample 16 digital signal at same time. Then the sampled data can be displayed, analyzed, exported and saved on the computer. Software can also decode the data if it conform to the standard protocol of the software supported. Then the decoded data can be displayed, exported and saved..
Supported standard protocols: UART/RS-232/485, I2C, SPI, CAN, DMX512, HDMI CEC, I2S/PCM, JTAG, LIN, Manchester, Modbus, 1-Wire, UNI/O, SDIO, SMBus, USB1.1, PS/2, NEC InfraRed, Parallel, etc….
Support OS: Support Windows (32bit/64bit),Mac OS,Linux.