ReviewsKuman Pinpointers

kuman Breadboard Jumper Wires 40pin Male to Female Ribbon GPIO Cable for Connection Raspberry Pi 4B 3 2 Model B B+ w/ 3.5” 5 inch Touch TFT Screen LCD display K70

  • IDC 40pin Male to Female Ribbon Cables Kit flat GPIO Cable 40pin Rainbow flat cable.
  • Cable for PI board and kuman SC06 SC5A 3.5 inch 5 inch LCD Panel.Upgraded for Raspberry Pi 3 2 B B+ rpi 1 B Model B+.
  • Each cable length: about 20cm /8-inch. standard 0.1"(2.54mm).
  • The cables can be separated to form an assembly containing the number of wires you require for your connection and to support non-standard odd-spaced headers..
  • Made of high-grade copper wire material for safe and durable to use..
Check Stock

kuman Raspberry Pi 4 B Holder Breadboard Kit, 7 in 1 RAB Holder kit Compatible for Arduino, Mega 2560 & Raspberry Pi 3 Model B, 2 Model B,1 Model B+ RPI Zero and Zero W

  • This 7 in 1 RAB Holder kit is designed by Kuman for the Raspberry Pi and for Arduino hobbyists, the holder is large enough for a Raspberry Pi 3B/ 2B/ 1B+/ Zero/ Zero W, for Arduino or Mega 2560, and a 400 hole or 830 hole Circuit Board breadboard(for Arduino rapsberrry pi motherboard and 400 breadboard are not included)..
  • Gift: GPIO 40 pin Table Card for wiring Pi and BCM codes for all RPI motherboard..
  • Including RPi GPIO Breakout Expansion Board and Ribbon Cable, which are special for Raspberry Pi 3 Model B, 2 Model B, 1 Model B+ and zero/ zero W..
  • This 830-tie/point breadboard includes an IC area of 630 points, plus two 100-point distribution strips, providing 4 power rails..
  • Comes with male-to-male 65pcs jumper wires, red, green, and yellow LEDs (three for each color), ten 1k resistors, a screwdriver, and some screws..
Check Stock