ReviewsLever Switch

[Upgrade 2021 Version] DIY Racing Simulator Steering Wheel Turn Signal Wiper Lever Switch For Logitech G27/G29/ Thrustmaster T300/T300 RS GT,only for PC (For G920/G923 Basic Modification Kit)

  • Product Features -- ETS2 ATS Steering Wheel Turn Signal Wiper Lever Switch for Logitech G920/G923.
  • racing wheel adaptor Turning light Wiper truck Simulator kit for Euro truck simulator2 /American truck simulator..
  • Product Details -- Supported steering wheel Type:For Logitech G920/G923 steering wheel.
  • For Thrustmaster T300/T300RS/T300 RS/GT.No need to install drivers-plug and play..
  • Product Fuctions -- meter/Low beam switch,High beam/light switch.
  • Three-speed variable wiper/one button start switch/retarder/auto cruise switch..
  • Product Technology -- Support game Auto-Sync(No need to pause the game to adjust the position of the lever position when entering the game.).
  • Support two key Modes(ETS/ATS model[Hardware built-in key execution script])(Normal mode[All available switches are independent keys])..
Check Stock

Outboard Remote Control Box Side Mount Push Open Outboard Motor,Boat Throttle Control for Mercury Outboard Engine 881170A15

  • Easy & Smooth Operation: Exceptionally smooth operation is delivered, To shift into forward and reverse, rotate the control lever downward, further rotated downward, the throttle opens..
  • Shut-Off Lanyard & Clip: The cord can secure the operation by being attached to the operator's clothing, or arm, or leg. Should operators fall or leave the helm, the cord will pull out the clip, stopping ignition..
  • 15' Harness with 8 Pin Connector: A handle mounted trim switch and a 15' harness with 8 pin Deutsche connector..
  • Thumb-Operated Trim/Tilt Switch: The power trim and tilt switch are attached to the control lever grip. Pushing it UP trims up and tilts up the engine and vice versa..
  • Fits All Current Mercury/Mariner: Suit for all current Mercury/Mariner outboards with integral power trim..
Check Stock

AlveyTech Right Brake Lever Assembly for Razor MX500 MX650 RSF650 SX500 & Pocket Mod Bellezza

  • Right brake lever assembly for the Razor MX500, MX650, & SX500 Dirt Rocket electric dirt bikes..
  • It is also the lever used on the RSF650 Electric Street Bike and the Pocket Mod Bellezza..
  • This version of the electric scooter brake lever and is commonly used on Razor electric scooters. However, it can be used to replace most brake levers....
Check Stock

DJC Components Extended Longer Dropper Post Remote Lever Shifter with Cable and Hose for 22.2mm MTB Handlebar

  • Extended Length Lever- The lever 10mm longer than standard size lever, save 22% push force and easy to operate. Lever length 55mm. This shifter set compatible to 95% dropper post on market..
  • Compatible to 1x System- It is southpaw, need to install at your handlebar left side. You need to confirm your bike is 1x, there is no front chainring shifter..
  • Low Resistance & Durable Lifespan- Resistance almost zero. Simple design make it easy to use and maintain.Material aluminum 7075, cable and hose from Jagwire. Cable length 160mm. Inner steel cable hold by integrated bolt, neat looking and rugged..
  • Horizontal Angle Adjustable - Ingenious design, it is easy to adjust horizontal angle to fit different handlebar and user habit. Cable tight is also adjustable with the attached cable adjuster..
  • 1 Year Warranty & What You Get - 1x switch lever, 1x cable, 1x hose, 1x cable tight adjuster, 1x aluminum cable end cap. It is a fullset shifter and cableset. Just install and play..
Check Stock

Lever Chain Hoist, 0.25T Manual Lever Block Chain Hoist Heavy Duty Alloy Steel Chain Ratchet Lever Hoist Lifting Puller with Hook for Warehouse Garages

  • ...Design】: The cover on the handle provides a comfortable grip and prevents hand injuries.
  • The chain anti-drop ring prevents the chain from being pulled out when the chain is pulled at will to adjust the position of the hook, making the lever chain hoist more easy to operate.
  • 【Easy To Use】: Adjust up & down switch to corresponding position and rotate hand wheel to the right till chain is in tension, then start to work.
  • When the up & down switch is in the middle, the chain can be pulled freely to adjust position of hook.
  • 【Wide Use】: This heavy duty lever hoist lifting puller can lift heavy loads up to 0.25T weight, great for commercial building sites and constrcution workplaces, widely used at construction site, garage, warehouse, dock, factory, shipbuilding, power plant.
  • 【Durable Material】: This chain ratchet lever hoist is composed of alloy steel chain and hot-forged hooks. It has high strength, high toughness, durability, stability and large load carrying capacity.
  • fast shipping from the United States, if you have any questions please feel free to contact us, we will quickly help you solve it.
Check Stock

Top Post Battery Disconnect Switch for Auto Car RV Marine Boat Truck Vehicle, 12V 24V Doctor Knife Switch for Negative Post, Battery Cutoff Shut Off Switch, Battery Saver (Horizontal and Vertical)

  • 【COMPATIBLE】This knife blade battery disconnect switch works well for RVs, marine, cars, boats or UTV- all standard car electric system as long as the battery has 15-17mm cone/tapering battery negative post. Only mount on NEGATIVE POST.
  • 【TOP MOUNT】Fit for top post terminal with 15-17mm cone, DC 12V-24V system, 250A continuous and 750A crank at DC 12V, on/off 2 position, operate vertically.
  • 【HIGH-QUALITY】Our battery kill switch is made of solid brass and copper. It features superior performance and good conductivity. It also can be used in marine and corrosive environments and keeps your battery far away from rust and corrosion.
  • 【EASY TO USE】Knife blade type, easy to install & simple to use. When you are not using the car or it is stored for long periods, just simply raise the lever to disconnect the battery from the car. You can adjust this battery switch through the bottom of the screw, into a vertical knife switch or a horizontal knife switch.
  • 【INSTALLATION】 Firstly, disconnect the battery cables from the battery, always disconnect the negative cable first followed by the positive cable. Attach the battery disconnect to the negative battery terminal and tighten but do not overtighten. With the lever on the switch continuously open, ....
Check Stock

Top Post Battery Disconnect Switch, Battery Terminal Link Quick Switch, Power Master Disconnect Cut Off Isolator for Boat Small Yacht RV Camper Truck Car Vehicle

  • Fitments: The knife blade battery switch can be used on car marine boat RV ATV at top post position for 12-24V battery..
  • Installation: Firstly, disconnect the cable connection on the battery. Make sure the negative cable is always disconnected, then the positive cable. Assemble the battery switch to the negative cable but do not over tighten it. Note to keep the lever is always open when you connect the negative cable and make sure the connection is good..
  • Solid Material: The knife switch is made of brass with electroplated surface, which has a good conductive performance and is totally rust and corrosion resistant..
  • Easy Usage: Just lever up the connect, then the battery will be cut off. In case your vehicle has to be stopped for a long time, you can only cut off the knife blade and it will prevent the battery from draining and improve the battery’s lifespan..
  • Warranty: We offer one year warranty for the blade switch. If you are not satisfied with it, simply contact us and get your refund..
Check Stock

LKV Motorcycle Brake Clutch Pump Lever with Hydraulic Master Cylinder Moto Accessories 7/8' 22mm Piston Universal CNC Compatible with Honda Yamaha Kawasaki Suzuki

  • 【Perfect Compatible】Universal motorcycle brake lever suitable for most 50-300cc motorcycles with 7/8″ (22 mm) handlebars..
  • 【Adjustable Levers】Bike brake clutch pump lever with 6-position button design could adjust the lever, gives you a comfortable grip..
  • 【Sophisticated Design】With mirror holder and brake clutch switch on both sides, precision machined pivot holes ensure a perfect fit..
  • 【High Quality】Machined from CNC Billet 6061-T6 Aluminum, anodized surface, durable and does not fade..
  • 【Easy to Install】 Easily installed without drilling or soldering. No instruction included. A 1-year warranty. If you have any questions about our lever, please feel free to contact us..
Check Stock

T-H Marine FCS-2-DP Sure Foot Trolling Motor Foot Switch

  • Sure Foot Trolling Motor Switch with Flip Lever for Continuous “ON”.
  • Provides the convenience of turning the motor on by simply pressing down on the switch with your foot.
  • 15 degree tilt angle for ease of operation.
Check Stock

GE WR23X10783 Genuine OEM Dispenser Switch for GE Refrigerators

  • The GE Appliances WR23X10783 Dispenser Switch is a genuine OEM (Original Equipment Manufacturer) part designed and engineered to exact specifications.
  • Replacement GE Appliances Refrigerator Dispenser Switch controls dispensing of ice or water when you press the dispenser lever.
  • GE Appliances WR23X10783 Refrigerator Dispenser Switch is also called the Micro Switch.
  • High quality GE Appliances OEM WR23X10783 Refrigerator Dispenser Switch is manufactured with premium materials for durability and exact fit, be sure....
  • Repair your appliance with confidence when you choose Genuine GE Appliances Parts & Accessories.
Check Stock

Steering Wheel for PC,Racing Wheel PXN V9 Driving Wheel 270/ 900 Degree Vibration Gaming Steering Wheel with Shifter and Pedal for PS4,PC,Xbox One,Xbox Series S/X,Nintendo Switch,PS3

  • Multi-platform Game Steering Wheel: The gaming steering wheel can be used for PC, Xbox one,PS4,PS3,Xbox series s/x, Nintendo Switch.
  • when connected to PC, it can be directly connected with a USB data cable.
  • but when connected to PS4 and Xbox one, It need to use the original controller to connect the racing wheel..
  • With 6-Speed Gear Lever：PXN V9 Racing Wheel include a six-speed gear lever ,it can be used to play truck games or practice driving. The gear lever is not supported racing games. In order not to affect your gaming experience, please do not connect the gear lever when playing racing games..
  • 270 & 900 Degree : One button to switch between 270°and 900°； 900° is suitable for playing truck games, like Euro Truck Simulator, American Truck Simulator, 270°is suitable for playing racing games , like Need for Speed, Forza Horizon..
  • Pedals With Clutch : V9 racing wheel have pressure-sensitive pedals, it can simulated real racing car.The pedals have rubber feet and a retractable carpet grip system that keeps your pedals firmly on the ground and won't tip over when you pedal..
  • 12 Months Warranty: Our products have strict quality inspection when they are made, if gaming steering wheel you received are unusable, please contact us, and we will provide y....
Check Stock