ReviewsLine Oscillator

Teenage Mutant Ninja Turtles Rippin' Rider

  • Side-mounted anti-Kraang Cannons fire missiles with just a flick of the finger!.
  • Vehicle also features mutant-strength mudguard, mean green high beam, ooze oscillator and all-terrain Turtletech treads!.
  • Look for the Sewer Spinnin’ Skateboard and other awesome vehicles!.
  • 2013 Viacom International Inc. All Rights Reserved. TEENAGE MUTANT NINJA TURTLES and all related titles, logos and characters are trademarks of Viacom International Inc..
  • Side-mounted anti-Kraang Cannons fire missiles with just a flick of the finger.
  • Vehicle also features mutant-strength mudguard, mean green high beam, ooze oscillator and all-terrain Turtletech treads.
  • Look for the Sewer Spinnin’ Skateboard and other awesome vehicles.
  • Compatible with most Turtle Figures (figures sold separately).
  • Teenage Mutant Ninja Turtles and all related titles, logos and characters are trademarks of Viacom International Inc.
Check Stock

SparkFun Pro RF - LoRa, 915MHz (SAMD21) - Wireless Board Easy-to-use IoT Qwiic Enabled microcontroller 915MHz ISM Band Reinforced Micro-B USB Connector Included u.FL Antenna Connector

  • A LoRa-enabled wireless board that marries a SAMD21 and a long-range RFM95W to make a compact and easy-to-use IoT board. Compatible with Arduino..
  • A short (3 inch) wire antenna is sufficient for "short" distances (up to 1 mile line-of-sight), but we've also included a u.FL antenna connector for potentially longer distances..
  • SAMD21G18A, Cortex M0+, 256KB Flash Memory, 32MHz External Oscillator, 4 Digital and 5 Analog IO Pins with exclusive GND pins.
  • Hope RFM95W LoRa modem, Point to Point Radio capabilities, LoRa Enabled, Frequency range: 915 MHz, Spread factor: 6-12, Range up to 1 mile line of sight, U.FL Antenna.
  • LiPo Battery Charger, 500mA Charge Rate. Qwiic Enabled. Power LED disconnect jumper for low power applications. PTH pins for software debug (SWD).
Check Stock

SamIdea 2 Pin 3 Pin PCB Mount Screw Terminal Block Connectors,Socket Strips 5.08mm Pitch for Arduino (Pack of 60pcs)

  • ★★★★★ REMINDS: You can separately buy 2 pin or 3 pin from our store,with ASIN: B07DQKSPWC(2PIN) and ASIN: B07DQTG6W5(3PIN). Application: Crystal Oscillator, IC Socket, DIY PCB Universal Board, Dupont Line, Digital tube, buzzer, Compatible with Arduino UNO board, PIC Programming unit, AVR ATMEL Programming unit, Connector Kit, USB to TLL Modules, Power Modules, LCD Modules, RS232 TO TLL Module.
  • ★★★★★ Rated Value : AC 300V, 16A,Pin Number :2&3(Mixed).
  • ★★★★★ Material : ABS Plastic, Electric Parts.
  • ★★★★★ Net Weight : Approx.179g.
  • Package Content : 30x 2P+30x 3p PCB Terminal Block.
  • ★★★★★ 100% satisfaction guarantee.
  • SamIdea is a Registered Trademark, can not sold without authorization..
Check Stock

Slinger Portable Tennis Ball Launcher - Ball Thrower Machine with Multi-Function Tennis Racket Bag & Ball Basket - Remote - Grand Slam Pack Comes w/Oscillator, Telescopic Ball Tube and Camera Holder

  • Slinger is a portable tennis bag that can easily transform to a Tennis Ball Launcher. Launching speed ranging from 10mph to 45mph..
  • We have created a unique Oscillator plate on which the slinger bag can sit and which allows the Slinger Bag to oscillate. The Oscillator is included in all of our Grand Slam Packs. Slinger Bag allows the user to modify ball speed, ball frequency and ball elevation independently..
  • Slinger is lightweight with a launch speed ranging from 10mph to 45mph. With a Battery life of 5 hours and a 144 tennis ball capacity. You can carry it, roll it and easily store it in the trunk of your car. Comes with a remote that controls both the Launcher and the Oscillator "ON/OFF" from across the court..
  • More than just a ball launcher, It's a Slinger Bag that holds tennis racquets and other stuffs. 3 easy steps to operate 1. Set the slinger bag down, 2. Set your Slinger Bag launch preferences 3. You can start playing. We also innovate your court tennis experience and enjoyment. So after your practice session is over, our Telescopic Ball Tube makes picking up the balls a whole lot easier! It comes with a USB port and a celphone holder which can help record your play..
  • Setting Innovation and Design. Combining a tennis bag with a ball launcher. Ma....
Check Stock

Intel/Altera Cyclone IV FPGA Development Board -- DueProLogic

  • Intel/Altera Cyclone IV FPGA includes 6,000 Logic Elements with two clock multipliers. The Cyclone IV FPGA is the perfect balance of inexpensive cost versus plentiful logic cells, 20KBytes of SRAM, and General Purpose Input/Output pins. This is a great board to learn how to program FPGA's..
  • Built in programmer cable allows configuring the FPGA with a single Micro-B cable. The DPL can be powered from the USB cable or from the Barrel Connector. A separate JTAG header can also be used to program the FPGA using a compatible USB Blaster cable..
  • 6x6 LED Array allows character and animations to be displayed at ultra fast speed. LED blocks can be individually turned on/off to allow LED signals to be used as I/O's.
  • 70 Inputs/Outputs originating at the FPGA are available at Stackable Headers organized around the edge of the board. The user can configure these I/O's using the FPGA project code..
  • The DPL contains two oscillators, 66MHz and 100MHz. The 66MHz oscillator is used to provide clocking for the EPT ActiveHost USB communications core. The 100MHz oscillator can be used by the user clocked up using one of the onboard Clock-DLL modules..
Check Stock

Ohaus 30391912 Model SHLD0415DG Digital Light Duty Orbital Shaker, 15mm Orbital, 120V

  • ✅This is a high power, high efficiency shaker with a unique heat sink base design that allows it to work for long periods of time..
  • ✅Grade: It has two levels, weak level and strong level, which can be switched at any time..
  • ✅How to use: Before power on, set the strong and weak switch to the middle O position, select strong vibration or weak vibration after power on, and put the plaster model to be shocked on the oscillator disk. Turn on the adjustment knob, clockwise adjustment for oscillation increase, counterclockwise for oscillation decrease. When the model is finished oscillating, close the knob to stop oscillating, and then remove the model to be used..
  • ✅Constituents: Oscillator is mainly composed of base and table, and equipped with a knob for adjusting the intensity of oscillation. It is very easy to control by gently turning the knob..
  • ✅Smooth and non-slip base: The base is designed with four feet, and the rubber pad is made of high quality rubber, which is flexible and elastic, and the strong vibration will not shift..
Check Stock

Abovehill S-Pixie CW QRP Transceiver Telegraph Shortwave Radio Radio 7.023Mhz 40 Meter+Case Assembled

  • S-Pixie Kit is a small and exquisite shortwave radio station, working mode is CW. Transmitting local oscillator frequency: 7023KHz.
  • receiving local oscillator frequency: about 7023-7026KHz..
  • Radio Station Power Supply Voltage is 9-13.8V (Battery or Linear Regulated Power Supply is Recommended), and the positive and Negative Poles are Not distinguished. Antenna: 50 ohm, 7MHz, standing wave ratio below 2.0..
  • Radio station receiving static current: 20mA, transmitting current: 120mA , Transmitting power: 1.2W, does not support automatic transmission, key: manual key.
  • Before powering on the radio station, please connect a dummy load to prevent accidental emission from burning..
  • After you purchase, I will send you the product manual through the platform chat window. After getting the product, please tear off the protective film on the product protective case. You will get exactly the same product as the main picture. We will provide you with quality service. Please feel free to contact me if there are any problems during the use of the product..
Check Stock

AITRIP 3 PCS STM32F401 Development Board STM32F401CCU6 STM32F4 Development Board Learning Board for Arduino and Learning Board Plate Computer Office, Electronic Accessories

  • the board Can provide a platform for beginners, in practical applications, it will not be because of insufficient computing power, I0 port function is not comprehensive and hinders development high-quality material, durable, firm and stable for us to use..
  • STM32F401CCU6 core board 64KB RAM 256KB ROM.
  • The GND is changed to 5V B9 5V GND, which can directly connect a small steering gear without additional wiring and reduce development time..
  • 25MHZ high speed crystal oscillator 32.768k low speed crystal oscillator.
Check Stock

Betus Flip Desk Clock - Mechanical Retro Style -Digital Display Battery Powered - Home & Office Décor 8 x 6.5 x 3 Inches (White)

  • Retro style - A classic minimalistic design inspired by split-flap display seen in old train stations. This clock will catch the eyes of any visitor to your home or office. A great conversation piece!.
  • Premium gift - This clock features stainless steel frame and ABS cards to guarantee its durability. Keeps time accurately thanks to the quartz oscillator. It's a great gift to your friends and beloved ones for Birthday, Chirstmas or any other occasion!.
  • Great decor - This timepiece is the best home and office decoration you will ever find. The neat style makes the clock suitable for any room. Huge numbers on the cards makes it easy to read from distance..
  • Specification - Adjust through a single knob next to the minute display. It is advised to set the time one minute ahead to compensate the clock's mechanism. 12-hour AM/PM display. 8 inches in length, 3 inches in width and 6.5 inches in height. Featuring stainless steel frame, ABS cards and quartz oscillator. Powered by 1 x D battery (Not included)..
  • Warranty - We stand behind our products! All items sold by us come with a one year warranty..
Check Stock

Glarks 40Pcs 74LSxxx and 74HCxxx Series Low-Power Logic IC Assortment Kit

  • ...Service]: ICs are made of high-quality materials, they are very durable, can serve you for a long time. And the safety and reliability are high, so you don't have to worry even if you work for a long time..
  • ♛ [Widely Application]: 74LSxxx and 74HCxxx Series ICs can be used as Bistability, register, shift register, oscillator, oscillator, divider counter, etc..
Check Stock

CW QRP Shortwave Radio Kit - CW Transceiver Shortwave Radio Kit

  • The patch device of the main control board has been pre welded and connected to the base plate in the form of stamp hole. The single chip microcomputer adopts pic16f1938, builtin PLL local oscillator, supports crystal oscillator calibration setting, and has its own frequency indication circuit (Seven Segment LED nixie tube is used, the display unit is 1kHz, the photo has color difference, and the actual color is red. The working frequency covers 7.000-7.100mhz, 1kHz or 100Hz steps )..
  • Ta2003 mixer is used for reception, and crystal filter is used for if. After ta2003 multiplication detection, the sound size is adjusted by digital potentiometer and sent to audio active filter circuit. Finally, LM386 drives speaker, and if frequency supports calibration setting..
  • Use 3 bs170 parallel outputs, class E amplification, 12V power supply, output power 5W! Relay switching is used for transceiver, with the function of transmitting delay adjustment to avoid frequent relay switching and improve the isolation of transceiver channel..
  • It has the function of automatically sending call signs, which is very convenient to use. The MCU uses the original code of our store, which can adjust the code speed, sidetone frequency and sidetone size. It can input the call sign by ....
Check Stock