ReviewsLow Current

GoolRC 80A Brushless ESC Waterproof Electric Speed Controller for 1/10 RC Truck Off-Road Car

  • Waterproof and dustproof, perfectly fit for 1/10 RC car..
  • Strong resistant current capability and excellent heat dissipation, Easily programmed and compatible with pocket-sized program card..
  • High current capability of 80A continuous current and 480A burst current ensures a stable driving..
  • Protection function includes low voltage cut-off protection, over-heat protection, throttle signal loss protection and motor blocked protection..
  • High-frequency drive system and Low-resistance field effect tube enhances load capacity and improve the utilization rate of power source..
Check Stock

Texas Instruments LM358P Low Power Dual OP Amplifier, General Purpose, 8-Pin, -16-32 Volt, 9.81 mm L x 6.35 mm W x 4.57 mm H (Pack of 15)

  • Four independent voltage comparators that are designed to operate from a single power supply over a wide range of voltages.
  • Wide Supply Ranges Single Supply: 2 V to 36 V, Dual Supplies: ±1 V to ±18 V, Differential Input Voltage Range Equal to Maximum-Rated Supply Voltage: ±36 V, Low Input Offset Current: 3 nA (Typical).
  • Low Supply-Current Drain Independent of Supply Voltage: 0.8 mA (Typical), Low Output Saturation Voltage, Common-Mode Input Voltage Range Includes Ground.
  • Low Input Bias Current: 25 nA (Typical), Low Input Offset Voltage: 2 mV (Typical), Low Output Saturation Voltage.
  • Example Applications: Industrial, Automotive: Infotainment and Clusters, Body Control Modules, Power Supervision, Oscillators, Peak Detectors, Logic, Voltage Translation.
Check Stock

GoolRC 120A Brushless ESC Waterproof Electric Speed Controller for 1/8 1/10 RC Truck Off-Road Car

  • Waterproof and dustproof, perfectly fit for 1/10 1/8 RC car..
  • Strong resistant current capability and excellent heat dissipation, Easily programmed and compatible with pocket-sized program card..
  • High current capability of 120A continuous current and 600A burst current ensures a stable driving..
  • Protection function includes low voltage cut-off protection, over-heat protection, throttle signal loss protection and motor blocked protection..
  • High-frequency drive system and Low-resistance field effect tube enhances load capacity and improve the utilization rate of power source..
Check Stock

TEHAUX Bridge Rectifier Diode QL25A 1000V High Current Three Phase Rectifier Bridge Fast Recovery Rectifier for Combiner Electric Welding 4Pcs

  • Applications for rectifier current, industrial automatic control, digital-controlled machine and remte controller system..
  • bridge rectifiers used for conversion of alternating current input into a direct current output..
  • Well welded structure with nice temperature and power cycle ability ensures a more stable performance..
  • This bridge rectifier can be used in a wide variety of applications..
  • Single phase, full wave, Low reverse leakage current, Low power loss, high efficiency..
Check Stock

Tegg 15SQ045 Schottky 10PCS 15A Diode Axial Schottky Rectifie Blocking Diodes for Solar Cells Panel

  • Maximum Average Forward Current: 15 A MP.Forward Current (at DC10A): 0.55V..
Check Stock

Juried Engineering TL082CP IC Operational Amplifier (Pack of 3)

  • Low Power Consumption: 1.4 mA/ch Typical.
  • Wide Common-Mode and Differential Voltage Ranges.
Check Stock

Fanmusic Topping L70 Full Balanced NFCA Headphone Amplifier 4Pin XLR/4.4 Balanced/6.35mm SE Output Amp with Remote Control (Black)

  • Ultra-High Performance NFCA modules: L70 uses same NFCA (Nested Feedback Composite Amplifier) module with A90. Voltage current hybrid feedback architecture along with UHGF (Ultra High Gain Feedback) technology provide excellent DC and AC performance, ultra-low THD+N and absurdly high dynamic range of 146dB. Even more, high output current drive capability, ultra-low output impedance and the ultra-low noise of 0.3uV which is miles ahead of the competition provide sufficient guarantee for driving headphones with various characteristics, sO that high-fidelity music can be vividly performed on different headphones..
  • 4-Pin-XL R/4. 4mm balanced/6. 35mm SE: The L70 is compatible with common headphone jacks including: 4-pin XLR balanced, 4.4mm balanced, 6.35mm single ended, and 3.5mm single- ended. The built- in fully balanced amplifier circuit can not only fit well with balanced headphones, but also have perfect performance with single -ended headphones..
  • Compatible with almost all kinds of headphones: L70's output has high output voltage, high output current, low noise, low output impedance, sO no headphones that can't be dealt with. High output voltage can easily drive high impedance headphones.
  • High output current allows low-sensitivity headphones to obtain....
Check Stock

Poilee 1N4004 Diode 1A 400V DO-41 Rectifier Diode Electronic Silicon Diodes (Pack of 50pcs)

  • IN4007Data: Forward rectified current:1A,Maximum recurrent peak reverse voltage:1000V.
  • Feature:Low forward voltage/High current capability/Low leakage current/High surge capability.
  • Case:Molded plastic use UL 94V-0 recognized Flame retardant epoxy.
  • Terminals:Axial leads, solderable per MIL-STD-202.
Check Stock

BOSS Audio Systems Elite BE2500.1 Monoblock Car Amplifier - 2500 Watts, 2 4 Ohm Stable, Class AB, Mosfet Power Supply, Great For Subwoofers

  • POWER: 2500 Watts Max x 1 @2-Ohms, 1250 Watts Max x 1 @4-Ohms.
  • CLASS A/B TOPOLOGY: Class A amplifiers have enormous amount of current flowing through its output transistors with no audio signal. Class B amplifiers have no current flowing through its outputs with no audio signal.
  • MOSFET POWER SUPPLY: A MOSFET is an electrical switch that allows the flow of electrical current. It controls the output voltage and current precisely by removing the output current sensing loss & eliminating all secondary feedback circuitry.
  • VARIABLE LOW-PASS CROSSOVER: Subwoofers reproduce sound based on a number of different low-range frequencies. You can set exact sound specifications for the bass frequency reproduction.
  • SWITCHABLE BASS BOOST: Bass Boost allows you to adjust the low bass within the boost range to just the way you like it.
  • VARIABLE GAIN CONTROL: The gain control is not for adjusting volume. It simply adjusts the amount of signal that is coming from your receiver and going to your amplifier.
  • DIMENSIONS: The BE2500. 1 is 10 inches in Depth, 7 inches in Width and 2. 3 inches in Height. It weighs 4. 5 lbs..
  • : BOSS Audio Systems provides a Powerful 6 Year Platinum Online Dealer so long as the purchase is made through . We strongly encourage professional installation o....
Check Stock

E-Projects - 1N4004 Diode, DO-41, General Purpose Silicon Rectifiers, 1A, 400V (Pack of 10 pcs)

  • FR107 Data: Forward rectified current:1A,Maximum recurrent peak reverse voltage:1000V.
  • Feature:Low forward voltage/High current capability/Low leakage current/High surge capability.
  • Case:Molded plastic use UL 94V-0 recognized Flame retardant epoxy.
  • Terminals:Axial leads, solderable per MIL-STD-202.
Check Stock

SUNGOLDPOWER 2000W Peak 6000W Pure Sine Wave Power Inverter DC 12V AC 120V with Battery AC Charger Solar Wind Power Inverters LCD Display Low Frequency Solar Converter, Blue

  • 1. This LFP Series Pure Sine Wave Inverter is a combination of an inverter, battery charger and AC auto-transfer switch.GFCI socket ,low frequency,low Idle Current,BTS cable, remote control.
  • 2. Adjustable Charging Current: The max charge current can be adjusted from 0%-100% via a liner switch at the right of the battery type selector. This will be helpful if you are using our powerful charger on a small capacity battery bank.the liner switch can effectively reduce the max charging current to 20% of its peak.Choosing “0” in the battery type selector will disable charging function.
  • 3. AC/Battery Priority: Our inverter is designed with AC priority by default, when AC input is present, the battery will be charged first, and the inverter will transfer the input AC to power the load. the inverter can be easily customized to Battery priority via a DIP switch, When you choose battery priority, the inverter will invert from battery despite the AC input..
  • 4. Auto Gen Start：the inverter can be customized to start up a generator when the battery voltage goes low.When the inverter goes to low battery alarm, it can send a signal to start a generator, and turn the generator off after battery charging is finished. The auto gen start feature will only work wi....
Check Stock