ReviewsLow Level

Planet Audio P10AW Amplified Car Subwoofer - 1000 Watts Low Profile 10 Inch Subwoofer Remote Subwoofer Control Great for Vehicles That Need Bass But Have Limited Space

Built-in Amplifier - A built-in 1000 Max watt amplifier powers the subwoofer.
Mosfet Power Supply - With a MOSFET power supply you get improved switching speeds, better performance with less power from the driver, lower....
Variable Low-Pass Filter - A low-pass filter is an electronic circuit that removes all the notes below the filter's frequency setting. You will use....
High Level Inputs - Speaker level inputs are commonly referred to as high-level inputs. It will be used to connect the P10AW to your factory radio or....
Low Level Inputs - Line level inputs, also known as RCA inputs or low-level inputs, use RCA interconnect cables to link the P10AW with the source....

Check Stock

Taidacent Non Contact Water Level Sensor Flow Sensor Float Switch Water Level Switch High and Low Level Output

The intelligent non-contact liquid level sensor uses advanced signal processing technology and high-speed signal processing chip to break through the influence of the wall thickness of the container and realize the true non-contact detection of the liquid level in the closed container..
The liquid level sensor (probe) is installed above and below the outer wall of the container to be tested (the high and low positions of the liquid level). The non-metallic container does not need to be opened, and the installation is simple and does not affect the production..
The liquid level of various toxic substances, strong acids, strong alkalis and various liquids in the high-pressure closed container can be detected..
The liquid to be tested is required to be electrically conductive, the contact surface is non-metal, and the pipe is easy to install and can be widely used..
High and low level output: If there is induction, the output is high level.
no induction, the output is low level. Specially designed for non-metallic pipe liquid level detection.

Check Stock

BOSS Audio Systems R1002 Car Amplifier - 2 Channel, 200 Watts Max Power, 2 4 Ohm Stable, Class AB, Full Range

POWER: Maximum Power output of 200 Watts at 2 Ohms into two channels. Maximum power output of 100 Watts at 4 Ohms into two channels.
HIGH LEVEL INPUTS: Speaker level inputs are commonly referred to as high-level inputs. Speaker level inputs will be used to connect the R1002 to your factory radio or an aftermarket radio that does not have low-level (RCA) inputs.
LOW LEVEL INPUTS: Line level inputs, also known as RCA inputs or low-level inputs, use RCA interconnect cables to link the R1002 with the source unit. Most aftermarket radios have multiple pairs of RCA outputs that can connect to multiple amplifiers.
VARIABLE INPUT GAIN CONTROL: The Variable Input Control allows the amplifier input to match the output signal from the head unit to achieve optimum performance when adjusted properly..
WARRANTY: BOSS Audio Systems provides a Powerful 6 Year Platinum Online Dealer Warranty so long as the purchase is made through Amazon Dot Com.

Check Stock

BOSS Audio Systems BAB10 Amplified Car Subwoofer - 1200 Watts Max Power Low Profile 10 Inch Subwoofer Remote Subwoofer Control Great for Vehicles That Need Bass But Have Limited Space

BUILT-IN AMPLIFIER: A built-in 1200 Max watt amplifier powers the subwoofer.
PULSE WIDTH MODULATED: This design controls the output voltage and current precisely by not only removing the output current sensing loss, but also....
VARIABLE LOW-PASS FILTER: A low-pass filter is an electronic circuit that removes all the notes below the filter's frequency setting. You will use the....
HIGH LEVEL INPUTS: Speaker level inputs are commonly referred to as high-level inputs. It will be used to connect the BAB10 to your factory radio or....
LOW LEVEL INPUTS: Line level inputs, also known as RCA inputs or low-level inputs, use RCA interconnect cables to link the BAB10 with the source unit.....

Check Stock

BOSS Audio Systems BASS8 8 Inch Under Seat Powered Car Subwoofer – 800 High Output, Low Profile, Built in Amplifier, for Truck, Boxes and Enclosures, Remote Subwoofer Control

... but also eliminating all secondary feedback circuitry. Efficiency. Increased reliability.
Variable Low-Pass Filter - A low-pass filter is an electronic circuit that removes all the notes below the filter's frequency setting. You will use the Low-pass filter to primarily keep high notes out of your subwoofer(s).
High Level Inputs - Speaker level inputs are commonly referred to as high-level inputs. It will be used to connect the BASS8 to your factory radio or an aftermarket radio that does not have low-level (RCA) inputs.
Low Level Inputs - Line level inputs, also known as RCA inputs or low-level inputs, use RCA interconnect cables to link the BASS8 with the source unit. Most aftermarket radios have multiple pairs of RCA outputs that can connect to multiple amplifiers.
Variable Bass Boost - Variable Bass Boost allows you to adjust the low bass within the boost range to just the way you like it.
Phase Control - Phase control lets you adjust the speaker phase with the amplifier if your speakers or subwoofer are hooked up “out of phase”.
Specs - Dimensions: 12.20” x 8.86” x 2.95”, Weight: 8.82 lbs. LED status indicator. Thermal, Short and Overload Protection Circuits. High Performance Voice Coil. Rubber Surround. Aluminum Cone, Remote Subwoofer Cont....

Check Stock

Low Profile Marine Subwoofer System - 1000 Watt 8 Inch Slim Active Waterproof Amplified Bass Speaker - Underseat Mount Audio Sound Amplifier Box For Small Boat, Marine Vehicles - Lanzar AQTB8 (White)

8'' Slim Marine Woofer - Phase Shift Switch : 0 or 180° - Thermal , Short and Overload Protection Circuits - Dimension : 14.5''(D) x 9.5''(W) x 3''(H).
RCA Low Level Input - Adjustable Input Sensitivity : 0.2V-3V - Fuse : 2 x 15A - Weight : 10.5 LBS.
High Level Input - 0 to +12Db Variable Bass Boost (@ 45Hz) - Max Power : 1000 Watts.
Green and Red LED Power Status Indicator - Low Pass Filter (50-150 Hz) - RMS Power : 300 Watts.
Remote Level Control - Soft Delay Remote Turn-On - RMS Power of Amplifier : 100 Watts.
8'' Slim Marine Woofer RCA Low Level Input High Level Input Green and Red LED Power Status Indicator Remote Level Control Phase Shift Switch : 0 or 180° Low Pass Filter (50-150 Hz) Soft Delay Remote Turn-On Thermal , Short and Overload Protection Circuits 14.5''(D) x 9.5''(W) x 3''(H).

Check Stock

Sound Storm Laboratories US10K Amplified Car Subwoofer - 1000 Watts Max Power Low Profile 10 Inch Subwoofer 8 Gauge Installation Included Great for Vehicles That Need Bass But Have Limited Space

Built-in Amplifier - Pulse Width Modulated design simplifies power supplies. It controls the output voltage and current precisely by removing the....
KIT – 17’/8G red power cable, 40 amp fuse holder, 3’/8G ground cable, 16’/18G blue remote cable, 16’ RCA interconnect, 4" wire ties, plastic....
Variable Low-Pass Filter - A low-pass filter is an electronic circuit that removes all the notes below the filter's frequency setting. You will use....
High Level Inputs - Speaker level inputs are commonly referred to as high-level inputs. It will be used to connect the US10K to your factory radio or....
Low-Level Inputs - Line level inputs, also known as RCA inputs or low-level inputs, use RCA interconnect cables to link the US10K with the source....

Check Stock

Hifonics BG-2500.1D Brutus Gamma Monoblock Super D Class 2500 Watt Car Audio Sound System Subwoofer Speaker Amp Amplifier

1-ohm stable monoblock operation for maximum power.
High/speaker level and low level/RCA input.
Variable 12dB high and low pass crossovers.
12dB bass boost increases low octave harmonics.
1800 phase shift improves low octave dynamics.
4-gage power wire and 8-gage speaker wire outputs.
Military grade PCB w/ PWM MOSFET power supply.
Direct short, thermal, and overload circuit protection.

Check Stock

2) BOSS B65N High Level to Low Level Converter + RCA Input Sensitivity Control

NEW BOSS **B65N** High Level to Low Level Converter (2 Pairs).
RCA Input Sensitivity Adjustment Control.
Converts regular/high level ouptut to preamp level.
Works with most typical fader configurations.

Check Stock

Whirlwind IMP 2 Standard Direct Box

Inexpensive direct box with a fantastic footprint and the sound quality.
The IMP is an in-line transformer that converts a line or instrument level unbalanced signal to a low impedance mic level balanced signal.
Converts a line or instrument level unbalanced signal to a low impedance mic level balanced signal.
An ideal direct box for anyone requiring professional quality and durability in an economical package.
Uses Whirlwind's TRHL transformer that's riveted, not glued, to the chassis.

Check Stock

Planet Audio PL1500.1M Monoblock Car Amplifier - 1500 Watts 2/4 Ohm Stable Class A/B Mosfet Power Supply

Power - 1500 Watts Max x 1 @2-Ohms, 750 Watts Max x 1 @4-Ohms.
Class A/B Topology - Class ‘A’ amplifiers have enormous amount of current flowing through its output transistors with no audio signal. Class....
Low & High Level Inputs - A low level (RCA) input is measured in voltages. A high level (+/- wire) input is measured in wattages. Both essentially....
Variable Low-Pass Crossover - Subwoofers reproduce sound based on a number of different low-range frequencies. You can set exact sound specifications....
Switchable Bass Boost - Bass Boost allows you to adjust the low bass within the boost range to just the way you like it.

Check Stock