ReviewsLow Pass Filter

Rockville RockGhost Active Powered 8 Hidden Car Subwoofer Sub For 15 /16 /17 Full Size Spare Tire

  • Features: Rockville RockGhost Powered Car Subwoofer (Amplifier built in). Sub Fits Inside Spare Tire Seamlessly (Goes on top of spare tire so you can....
  • For Full Size Spare Tire Wheel Sizes of 15"/16"/17". Extremely loud (loud enough to vibrate your mirrors). Super clean sound that is musical and will....
  • PWM MOSFET power supply amplifier built in. Low level RCA inputs. 8” high excursion Subwoofer. Reverse mounting design. Plug and play installation....
  • Wired 20 foot dash remote with adjustable gain, bass boost, low pass crossover filter, and phase control. Deep and clear bass frequency. Auto turn on....
  • Phase Switch: 0° or 180°. Low Pass Filter: 50Hz - 150Hz. Frequency response: 20 Hz – 250 Hz. Bass Boost: 0 - 12dB @ 45Hz. 20 Hz Subsonic Filter.....
Check Stock

BOSS Audio Systems BASS10 Amplified Car Subwoofer - Low Profile, 10 Inch Subwoofer, Remote Subwoofer Control, for Vehicles Needing Bass with Limited Space, Remote Subwoofer Control

  • ...im design, there are a few installation options.
  • Pulse Width Modulated - PWM simplifies power supplies. It controls the output voltage and current precisely by not only removing the output current sensing loss, but also eliminating all secondary feedback circuitry. Efficiency. Increased reliability.
  • Variable Low-Pass Filter - A low-pass filter is an electronic circuit that removes all the notes below the filter's frequency setting. You will use the Low-pass filter to primarily keep high notes out of your subwoofer(s).
  • High Level Inputs - Speaker level inputs are commonly referred to as high-level inputs. It will be used to connect the BASS10 to your factory radio or an aftermarket radio that does not have low-level (RCA) inputs.
  • Low Level Inputs - Line level inputs, also known as RCA inputs or low-level inputs, use RCA interconnect cables to link the BASS10 with the source unit. Most aftermarket radios have multiple pairs of RCA outputs that can connect to multiple amplifiers.
  • Variable Bass Boost - Variable Bass Boost allows you to adjust the low bass within the boost range to just the way you like it.
  • Specs - Dimensions: 14” x 12.3” x 3.3”, Weight: 11.35 lbs. Phase control. LED status indicator. Thermal, Short and Overload Protection Circuits. High ....
Check Stock

Rockville KRYPTON F2 2400w Peak/600w RMS 4 Channel Amplifier Car Stereo Amp

  • Rockville KRYPTON F2 2400w Peak/600w Dyno-Certified RMS 4 Channel Amplifier Car Stereo Amp..
  • Dyno Certified RMS Power Ratings: (Certified Dyno Test / Less than 1 % THD) (Use these ratings when comparing with top brands such as Kicker, Rockford Fosgate, etc). 2 Ohm: 150 Watts x 4 Channels.
  • 4 Ohm Bridged: 300 Watts x 2 Channel. Peak: (Use these ratings when comparing with the top budget brands such as Boss, Power Acoustik, etc). 2 Ohm: 600 Watts x 4 Channels. 4 Ohm: 400 Watts x 4 Channels. 4 Ohm Bridged: 1200 Watts x 2 Channels..
  • All channels on the amp have crossovers so they can each be used for subs or full range speakers or tweeters or midrange speakers. All channels on the amplifier are bridgeable. Digital Voltage Display on Amp..
  • Fully Adjustable 12dB / Octave Crossover with Differential Circuitry. Adjustable Subsonic Filter: 15Hz -40Hz (This filter is on the HPF knob). Adjustable Low Pass Filter: 40Hz – 4KHz. Adjustable Band Pass Filter: 15 Hz - 4 kHz (use both the HPF and LPF filter). Adjustable High Pass (Subsonic) Filter: 15 Hz - 4 kHz.
Check Stock

BOSS Audio Systems BAB8 Amplified Car Subwoofer - 800 Watts Max Power, Low Profile, 8 Inch Subwoofer, Remote Subwoofer Control, Great for Vehicles That Need Bass But Have Limited Space

  • ...lt-in 800 Max watt amplifier powers the subwoofer.
  • Pulse Width Modulated - This design controls the output voltage and current precisely by not only removing the output current sensing loss, but also eliminating all secondary feedback circuitry. It increases efficiency, is lighter, smaller reliable.
  • Variable Low-Pass Filter - A low-pass filter is an electronic circuit that removes all the notes below the filter's frequency setting. You will use the Low-pass filter to primarily keep high notes out of your subwoofer(s).
  • High Level Input - Speaker level inputs are commonly referred to as high-level inputs. It will be used to connect the BAB8 to your factory radio or an aftermarket radio that does not have low-level (RCA) inputs.
  • Low Level Input - Line level inputs, also known as RCA inputs or low-level inputs, use RCA interconnect cables to link the BAB8 with the source unit. Most aftermarket radios have multiple pairs of RCA outputs that can connect to multiple amplifiers.
  • Variable Bass Boost - Variable Bass Boost allows you to adjust the low bass within the boost range to just the way you like it.
  • Specs - 12 inches in Depth, 9. 3 inches in Width and 2. 9 inches in Height.
  • - BOSS Audio Systems provides a Powerful 3 Year Platinum Online Dealer so long as the p....
Check Stock

Rockville Krypton F1 1600w Peak / 400w RMS 4 Channel Amplifier Car Audio Amp

  • Rockville KRYPTON F1 1600w Peak / 400w Dyno-Certified RMS 4 Channel Amplifier Car Audio Amp..
  • Dyno Certified RMS Power Ratings: (Certified Dyno Test / Less than 1 % THD) (Use these ratings when comparing with top brands such as Kicker, Rockford Fosgate, etc). 2 Ohm: 100 Watts x 4 Channels 003c1% THD+N. 4 Ohm: 70 Watts x 4 Channels 003c1% THD+N..
  • 4 Ohm Bridged: 200 Watts x 2 Channel. Peak: (Use these ratings when comparing with the top budget brands such as Boss, Power Acoustik, etc). 2 Ohm: 400 Watts x 4 Channels. 4 Ohm: 280 Watts x 4 Channels. 4 Ohm Bridged: 800 Watts x 2 Channels..
  • All channels on the amp have crossovers so they can each be used for subs or full range speakers or tweeters or midrange speakers. All channels on the amplifier are bridgeable. Digital Voltage Display on Amp. Fully Adjustable 12dB / Octave Crossover with Differential Circuitry..
  • Adjustable Subsonic Filter: 15Hz -40Hz (This filter is on the HPF knob). Adjustable Low Pass Filter: 40Hz – 4KHz. Adjustable Band Pass Filter: 15 Hz - 4 kHz (use both the HPF and LPF filter). Adjustable High Pass (Subsonic) Filter: 15 Hz - 4 kHz. 2CH/4CH Input Mode Switch. 8 Volt Preamp Circuitry.
Check Stock

BOSS Audio Systems BASS8 8 Inch Under Seat Powered Car Subwoofer – 800 High Output, Low Profile, Built in Amplifier, for Truck, Boxes and Enclosures, Remote Subwoofer Control

  • ...im design, there are a few installation options.
  • Pulse Width Modulated - PWM simplifies power supplies. It controls the output voltage and current precisely by not only removing the output current sensing loss, but also eliminating all secondary feedback circuitry. Efficiency. Increased reliability.
  • Variable Low-Pass Filter - A low-pass filter is an electronic circuit that removes all the notes below the filter's frequency setting. You will use the Low-pass filter to primarily keep high notes out of your subwoofer(s).
  • High Level Inputs - Speaker level inputs are commonly referred to as high-level inputs. It will be used to connect the BASS8 to your factory radio or an aftermarket radio that does not have low-level (RCA) inputs.
  • Low Level Inputs - Line level inputs, also known as RCA inputs or low-level inputs, use RCA interconnect cables to link the BASS8 with the source unit. Most aftermarket radios have multiple pairs of RCA outputs that can connect to multiple amplifiers.
  • Variable Bass Boost - Variable Bass Boost allows you to adjust the low bass within the boost range to just the way you like it.
  • Phase Control - Phase control lets you adjust the speaker phase with the amplifier if your speakers or subwoofer are hooked up “out of phase”.
Check Stock

ALPINE X-A90V 900 Watt 5-Channel X-Series Car Audio Amplifier Amp+Bass Knob

  • Package Includes: (1) ALPINE X-A90V 900 Watt 5-Channel X-Series Car Audio Amplifier Class-D Amp. (1) ALPINE RUX-KNOB.2 Remote Control Bass Knob For....
  • Remote Bass (RUX-KNOB or RUX-KNOB.2) Compatible. Specifications: CTA-2006 Power Rating: 100W RMS x 4 + 500W x 1 (2.
  • Dual speaker terminals simplify the hookup of multiple speakers. Heavy duty aluminum alloy heat-sink. Input sensitivity: High level: .5 - 10V Low....
  • Variable high-pass filter: 50 - 400Hz, -24dB/octave. Variable low-pass filter: 50 - 400Hz, -24dB/octave. Subsonic filter: 8 - 40Hz. Variable Bass....
Check Stock

Planet Audio P10AW Amplified Car Subwoofer - 1000 Watts Low Profile 10 Inch Subwoofer Remote Subwoofer Control Great for Vehicles That Need Bass But Have Limited Space

  • Built-in Amplifier - A built-in 1000 Max watt amplifier powers the subwoofer.
  • Mosfet Power Supply - With a MOSFET power supply you get improved switching speeds, better performance with less power from the driver, lower....
  • Variable Low-Pass Filter - A low-pass filter is an electronic circuit that removes all the notes below the filter's frequency setting. You will use....
  • High Level Inputs - Speaker level inputs are commonly referred to as high-level inputs. It will be used to connect the P10AW to your factory radio or....
  • Low Level Inputs - Line level inputs, also known as RCA inputs or low-level inputs, use RCA interconnect cables to link the P10AW with the source....
Check Stock

Alpine Electronics S-A32F 4 Channel Amplifier

  • Rms power bridged 2 x 160 W @ 4 Ohms: 14.4V.
  • Class D (digital) amplifier.Channels: 4/3/2 channel (stereo).Temperature monitoring.Automatic switch-on Function.Crossover: adjustable low pass filter (LPF)/ high pass filter (Hpf).
Check Stock

SFB-1000D - Sundown Audio Monoblock 1750w RMS Amplifier…

  • Features: Monoblock Class D Amplifier. Power Handling: Maximum Output Power at 14.4V DC 1-Ohm: 3000W RMS | Maximum Output Power at 14.4V DC 2-Ohm:....
  • Crossover: High Pass Filter: 15 to 80Hz (-12dB/8) Variable | Low Pass Filter: 80Hz to Full (-12dB/8) Variable. Bass Boost: 0 to 12dB (50Hz), Thermal....
Check Stock

JBL Stage A6004 4-Channel 50W X 4 Full Range Amplifier

  • General specifications Power output90wx4@4ohms frequency response20-20khz±1db thd@rop1%.
  • Input Sensitivity0.2V-5v high Pass filter, variable32-320hz low Pass filter, variable32-320hz bass eq@45hz0-12db protectiondc, OVP, UVP, OCP, OTP.
Check Stock