ReviewsOccupancy Sensor Light Switch

TOPGREENER Motion Detector Light Switch, in Wall Sensor Switch, Occupancy Sensor Switch 500W LED CFL 1/4HP, Wall Plates Included, Neutral Wire Required, TDOS5, White, 2 Pack

  • MOTION SENSOR GARAGE LIGHT Automatically detects motion from passive infrared sensors to turn lights on and off based on room occupancy and vacancy.
  • PIR SENSOR SWITCH Passive Infrared Detection (PIR): Detects infrared to reduce false triggers from unwanted movements..
  • MOTION SENSOR WALL SWITCH Universal wiring design allows compatibility with any home. Easy install. Two Black Wires, any one connects with hot, and another with load.
  • MOTION SENSOR CLOSET LIGHT Auto ON/OFF, Manual ON/Auto OFF.
  • After install and turning on circuit breaker, allows about 2 minutes to warm up before operating the device..
  • NEUTRAL WIRE REQUIRED, 314 square feet coverage, High range motion detector with 180 Degree View.
  • 500W Incandescent, Halogen, Fluorescent, LED, CFL. Operating temperature (32 – 131°F). Works with all bulb types. Single-pole only. 2 wall plates included.
Check Stock

Infrared Motion Sensor, 12v Wired Indoor Ceiling Mounted 360° Infrared Detector, Low Noise, High Sensitivity, Anti White Light Interference Alarm

  • Complete kit for automatic switching control of light fixtures, power outlets, or fan motors.
  • Contains motion/daylight sensor, 20A 120-277V power pack, and momentary wall switch.
  • Automatic/Occupancy or Manual/Vacancy modes.
Check Stock

ENERLITES PIR Motion Occupancy Vacancy Motion Sensor Light Switch, 500W, 5A, Motion Sensor Night Light, Single-Pole, Smart LED Backlight, Neutral Not Required, Ground Required, HMOS-J-W, White

  • Motion detector light switch replaces standard switch, automatically turns connected load ON / OFF based on motion detected.
  • Smart LED backlight will turn on when motion is detected for easy location in the dark in vacancy mode.
  • Occupancy switch mode (Auto ON, Auto OFF) and vacancy switch mode (Manual ON, Auto OFF) allow you to customize the sensor according to your needs.
  • Time delay options: 15 sec (Test), 15 min, 30 min. Motion sensor will turn off after the delay time is up. Single pole use only. Not for three-way wiring.
  • Neutral wire not required, ground wire required for installation. 120-277VAC, CFL/LED: 150W, incandescent/halogen: 500W, motor: 1/8HP. Motion sensor wall switch ranges 180 Degree, 700 sq. ft. coverage. Operating temperature (32 – 131°F). UL listed.
Check Stock

Eaton OS310U-GY-K Motion-Activated Occupancy Sensor Wall Switch, Gray

  • Single Pole or 3-Way (control one light from two locations).
  • Works with all popular load types: Incandescent, Magnetic Low-Voltage, Electronic Low-Voltage, Fluorescent, Compact Fluorescent (CFL) and LED.
  • Occupancy Sensor provides a selectable ambient light override preventing lights from switching ON when there is acceptable natural light.
  • seven step green LED display on push pad indicates selected light level - and reduces brightness when OFF (night light feature).
  • replaces standard switch for light control.
Check Stock

GE UltraPro in-Wall Motion Sensing Switch with Occupancy and Vacancy Options, Single Pole, Automatic/Manual Controls, 150 Degree 30ft. Detection Zone, Custom Timer, Indoor, 11927, White

  • Turn an ordinary switch into motion-sensing hands-free switch. Ideal for laundry rooms, kitchens, entryways, mudrooms, hallways and more. Single-pole controls lights from one location..
  • Detects motion up to 30 feet away in a 150 degree detection range. Motion sensor will cover up to 650 sq. feet..
  • 2 Lighting Options: Occupancy sensor turns light on when you enter the room and off automatically after you leave the room. Vacancy feature - turn the light on manually and the lights will auto-turn off after you leave the room..
  • Built-in timer lets you set length of time light stays pm after motion ceases - from 15 to 30 seconds. Sensor can also be adjusted to ignore motion when room is naturally lit..
  • NEUTRAL WIRE REQUIRED. 120/125VAC 60Hz, 12A Resistive, 800W Tungsten, 800VA Ballast, 1/4HP Motor. Wallplate NOT included. UL Listed. 1-year limited warranty.
Check Stock

Pack of 50 White Motion Sensor Light Switch – NEUTRAL Wire Required – Single Pole Only Not 3-Way – For Indoor Use – Vacancy & Occupancy Modes – Title 24 UL Certified – Adjustable Timer

  • Neutral Wire Required: This motion sensor requires connecting all 4 wires (including the NEUTRAL wire) in order to function properly. Lights will....
  • Save On Electricity Bills: This dual purpose vacancy and occupancy wall switch sensor provides optimal management of lighting and a choice of either....
  • Adjustable Sensitivity With Wide Field of View: The motion sensor covers 180°, so all motion is detected. There’s no need to wave your hands at the....
  • 100% Money Back Guarantee: We stand behind the quality and utility of this light switch. If you aren’t completely satisfied with it, for any reason....
  • Fully Certified And Compliant: UL Certified, FCC Listed, and California Title 24 Compliant..
Check Stock

Leviton ODS10-IDW Decora 120/277-Volt Wall Switch Occupancy Sensor, White

  • Leviton 1-Pole Commercial Grade Occupancy Sensor Wall Switch, Passive Infrared, 120 / 277 Volts.
  • Convenient push-button provides manual on/off light switching at any time.
  • 180-degree field of view provides approximately 2,100 square feet of coverage.
  • Segmented Fresnel lens provides optimum sensitivity and performance.
  • Horizontal field of view may be adjusted between 180 degrees and 32 degrees of arc.
  • Ambient light override can be set to prevent activation if sufficient ambient light is available.
  • Leviton offers a wide selection of motion sensors that use passive infrared, ultrasonic or a combined multi-sensing technology.
Check Stock

ecobee3 lite Smart Thermostat, 2nd Gen and Switch+ Smart Light Switch Bundle

  • SAVE MONEY: Homeowners save up to 23% annually on heating or cooling costs, plus ecobee pays for itself in under 2 years (compared to a hold of 72 degrees).
  • WORKS AS A ROOM SENSOR: Built-in occupancy and temperature sensors let you pair your Switch+ with your Eco bee Smart Thermostat to work as a wireless Room Sensor for smarter, more efficient whole home comfort..
  • CONTROL FROM ANYWHERe: Easily adjust your thermostat from wherever you are using your iOS (iPhone, iPad, Apple Watch) or Android device. The ecobee mobile app is available in the App Store or on Google Play.
  • BUILT-IN AMAZON ALEXA: Switch the lights on and off, control other parts of your smart home, or ask Alexa to play music, hear the news, set a timer, adjust the temperature, and so much more..
  • BEYOND SMART LIGHTING: With built-in motion detection, ambient light sensors, and built-in Amazon Alexa you can control your home's lighting like never before..
Check Stock

Enerlites MWOS-W Motion Sensor Switch Ultrasonic and PIR Dual Technology Occupancy Sensor Motion Sensor Light Switch NEUTRAL WIRE REQUIRED Wall Plate Included White

  • Dual technology motion light switch combines passive infrared (PIR) and ultrasonic sensors in one sensor switch for enhanced accuracy and to detect....
  • Combination of PIR and ultrasonic sensors eliminates false positives by preventing lights from shutting off when the room is still occupied.
  • Ideal for private or executive offices, meeting rooms, restrooms, libraries, classrooms, and other spaces where limited movement is likely to occur to....
  • Customizable settings, such as adjustable time delay, detection range, light level. Change between occupancy/vacancy modes and set different....
  • Neutral wire required for installation. Single-pole use only. 120/277VAC. Incandescent: 800W. Major movement coverage: 1200sq ft., Minor movement....
Check Stock

Lutron MS-VPS2-WH Maestro 250 Watt Single Pole Vacancy Sensor Switch, White

  • Automatically turns lights off when room is unoccupied.
  • Meets California Title 24 and other sensor code requirements.
  • Up to 250 W incandescent, halogen, electronic low voltage.
  • To automatically turn lights on AND off, please see Lutron’s occupancy sensor switch, MS-OPS2-XX.
  • The vacancy sensor will only turns off with lack of motion, not on with motion.
Check Stock

GE Enbrighten Z-Wave Plus Smart Motion Light Switch, Compatible with Alexa, Google Assistant, SmartThings, Wink, Zwave Hub Required, Repeater/Range Extender, 3-Way Compatible, Black, 35547

  • ...uires a Z-Wave certified hub). Works with the following Z-Wave certified hubs: SmartThings, Ring Alarm, Wink, ADT Pulse, ADT Command, Trane, Vivint, Nexia, Honeywell, HomeSeer, Harmony Home Hub Extender, Vera and more..
  • SELECtABLE MOTION CONTROL – Personalize the switch with three motion-detection options – occupancy, vacancy and manual. Occupancy mode turns lights ON/OFF automatically, while lights are turned on manually and off automatically in the vacancy setting. To deactivate the motion sensor, select manual operation. With five time-out duration options ranging from five seconds to 30 minutes and up to 180-degree detection coverage, the switch accommodates any room with varying amounts of activity. Additionally, enjoy custom scenes, versatile scheduling and convenient alerts with remote operation and voice control when connected to a compatible hub..
  • 3-WAY READY – The smart device operates perfectly on its own or seamlessly integrates into multi-switch setups with required add-on switches – models 12723, 12728, 46199 or 46200. Up to four add-on switches can be connected to the same device..
  • FULL-HOME COVERAGE – Z-Wave Plus works with all previous Z-Wave generations to allow continued expansion of your home-automation network. The sw....
Check Stock