MEGA2560 Screw Terminal Block Breakout Module with Aluminum Enclosure, for Arduino MEGA 2560 R3
- ...allow the wire to get off-center when inserted.The connector will not melt things when soldered to them.They are not too thick that fit perfectly next to each other on a protoboard.You can jam them in there and they sit parallel..
- Easy to insert into prototype boards and solder the pins.These connectors work well on PCBs.Can be used on a breadboard power rails if plugged in at an angle.The screw connections can open enough to let a wire enter freely,doesn't make it difficult to enter and tighten the wires.Make it easier to swap out things like simple antennas,low voltage power sources,sensors,ect..
- Needn't over-torque the screws and they will hold up fine.When you want to move wires,wires come right out with the slightest movement.Great for mounting on or in buildings to attach wires for lighting,so you don't half to desolder delicate LED lead wires every time when want to move a building.Their use greatly reduced the confusion created by jumper wires going in many different directions..
- Comes in handy when you want to connect wires without having to solder them to the circuit.Good to use a breadboard to set up temporary electrical circuits.Each module can be attached easily to another using slots provided.This allows creation of a screw terminal a....
