ReviewsRated Channel Car Amplifiers

Car Stereo High to Low Line Speaker Level Converter Cable/Converter Stereo Speaker Level Adapter

  • Allows the addition of 2 or 4 channel amplifiers to most stereos without RCA outputs.
  • Allows the addition of amplifier and subwoofer to existing factory systems.
  • Adjustable level matching from 0 to 2 volts.
Check Stock

Scosche LOC2SL Line Output Converter Adjustable Amplifier Add On Module for Car Stereo 2-Channel Signal Sensing Speaker Wire to RCA Adapter with Remote Control Knob Black

  • Speaker to RCA Converter - Converts car stereo output speaker wire to RCA connectors. This speaker wire line out converter is compatible with high....
  • Easy Installation - Add an amplifier to nearly any stock stereo with this line out converter. Simply tap into the car audio speaker wire with snap....
  • Subwoofer - This DIY speaker kit is a convenient speaker wire to subwoofer adapter. The RCA line output converter for subwoofer makes it easy to hook....
  • RCA Converter - Speaker level to line level converter allows the addition of 2-channel or mono amplifiers. Independent left and right channel level....
  • External Controller - Includes mountable remote control knob for adjusting subwoofer bass audio level from the dash. This remote bass knob lets you....
Check Stock

PIONEER 5CH AMP/100X4+600W/BASSBOOST REM

  • Rockville RXD-M0 1200 Watt / 600 Watt RMS Mono Class D 1 Ohm Car Stereo Amplifier with Optical Coupler Technology. CEA Compliant Power Ratings : (Rated at less than 1 % distortion).
  • 1 Ohm : 1200 Watts x 1 Channel . 2 Ohm : 800 Watts x 1 Channel. 4 Ohm : 600 Watts x 1 Channel. High-Speed MOSFET Power Supply. Optical Coupler Class “D” Technology. Studio-Grade Bipolar Output Stage Transistors ..
  • Fully Adjustable 12dB / Octave Crossover with Differential Circuitry. Low Pass Filter : 50Hz - 250Hz. Subsonic Filter : 15Hz - 55Hz. Phase Control Switch. Full IC-Controlled Protection Circuitry. Remote Dashboard Subwoofer Control..
  • 8 Volt Preamp Circuitry. Status Mode LED Indicator. Minimum THD at Rated Power : < 0.05%. S / N Ratio : >100dB. Frequency Response : 10Hz - 500KHz. Damping Factor : > 200 @ 100Hz. 50 Amp Maxi Fuse. Dimensions : (W x H x L) 8.5" x 1.8" x 12.5"..
Check Stock

Bose F1 Model 812 Flexible Array Loudspeaker

  • Strong, low-frequency output from a 12-inch high-performance woofer.
  • F1 Model 812 (45 lbs.) – 26.1″ H x 13.1″ W x 14.6″ D | F1 System Stack (85 lbs.) – 73.5” H x 16.1” W x 17.6” D | Max SPL – @ 1m, 132 dB (peak) | Rated power – 1,000 W | Frequency response (-3 dB) – 52 Hz – 16 kHz | Range (-10 dB) – 43 Hz – 20kHz.
  • Bi-amplified design with 2 high-output, Class-D amplifiers to separately power the FLEX array and 12-inch LF driver.
  • Exclusive flexible array can be configured into four unique shapes (“Straight,” “C,” “J” or “Reverse J”), allowing the customer to choose the best possible coverage pattern for the application.
  • 2 input channels with independent volume controls and Line Level/Mic switch on Channel 1 | Wide, consistent coverage from an 8-driver mid/high line array, with each driver mounted on a custom 100° waveguide.
Check Stock

Rockville dB55 4000 Watt Peak/980w RMS 5 Channel Car Amplifier + Amp Kit

  • Package Includes: (1) RockvilIe dB55 4000 Watt/2000w RMS 5 Channel Amplifier Car Stereo Amp, Loud!!, (1) RockvilIe RWK42 4 Gauge 4 Chan Car Amp Wiring....
  • Features of dB55: RockvilIe dB55 4000 Watt/2000 Watt RMS 5 Channel Amplifier, CEA Compliant Power Ratings (Rated at less than 1 % distortion) (Use....
  • - 2 Ohm 240 Watts x 4 + 1000 Watts x 1, - 4 Ohm: 160 Watts x 4 + 600 Watts x 1, Peak: (The amount of power the amplifier can produce for a split....
  • Features of RWK42: RockvilIe RWK42 4 Gauge 4 Channel Car Amplifier Wiring Installation Kit, (2) 17 High Grade Twisted Pair of 100% Copper RCA Cable,....
  • 3 4 Gauge Clear SuperFlex Ground Wire, Gold Plated AGU Heat Resistant Fuse Holder, 80 Amp AGU Gold Plated Fuse, 7 Split Tube Loom, Accessories....
Check Stock

Ground Loop Isolator RCA,ZDMYY Noise Filter for Car Audio Systems,Car Stereo Noise Suppressor for Eliminate Buzzing Noise

  • 【Ground Loop Isolator】It is designed to help with a humming noise and or engine noise for radio's with no to connect to an amplifier that requires.
  • 【Product Dimensions】Compact sized: cm/ inch.Working Voltage : AC 115/250V, 50/60Hz.
  • 【Easy to install】The ground loop noise isolator is easy to install, plug and play when the wiring is correct, and isolate current noise..
  • 【Scope of Application】Professional power filter for most of DC 12V devices. Effectively resolve the noise problem of audio. Widely used in car amplifiers, active subwoofers,computers, players,recording studios, conference room amplifiers,and other equipment..
  • 【Package Contents】G07 audio noise filter,User Manual, 12-Month Product Replacement Warranty and 24 hour Customers Service..
Check Stock

Garmin Fusion Signature Series 6 Channel 1500-Watt Marine Amplifier, a Brand

  • Class-D amplifier design delivers higher efficiency and greater output..
  • Connect up to two speakers per channel at 2 ohms, or bridge two channels at 4 ohms for increased power..
  • Conformal coated PCBs provide extra protection from the marine elements..
  • Rigid aluminum alloy heat sink is molded for greater dissipation of heat..
  • The amplifiers are available in monoblock, 4-channel, 5-channel, 6-channel and 8-channel configurations..
Check Stock

Garmin Fusion Signature Series 8 Channel 2000-Watt Marine Amplifier, a Brand

  • Class-D amplifier design delivers higher efficiency and greater output..
  • Connect up to two speakers per channel at 2 ohms, or bridge two channels at 4 ohms for increased power..
  • Conformal coated PCBs provide extra protection from the marine elements..
  • Rigid aluminum alloy heat sink is molded for greater dissipation of heat..
  • The amplifiers are available in monoblock, 4-channel, 5-channel, 6-channel and 8-channel configurations..
Check Stock

Martin Logan - ElectroMotion ESL - Hybrid Electrostatic - Each - Black

  • High frequency transducer: XStat CLS electrostatic transducer.
  • Low frequency driver : 8" high excursion, high-rigidity doped fiber cone with extended throw drive assembly, non-resonance asymmetrical chamber format.
  • MicroPerf panel is housed within a radical aluminum and composite AirFrame.
  • Proprietary Vojtko topology filter utilizing custom air core coil and low DCR steel laminate inductors, polyester film capacitors in series, and low DF electrolytic capacitors in parallel.
  • Recommended amplifier power: 20-300 watts per channel, Crossover frequency: 500 Hz.
  • Convenient push-style speaker terminals for bare wires, pins, or bananas, Sturdy, 1/4-20 ETC spikes.
  • Frequency response: 42 - 22,000 Hz ±3 dB, Dispersion: 30-degrees x 34" line source, Sensitivity: 91 dB/2.83 volts/meter.
  • Nominal Impedance: 6 Ohms, 1.6 @ 20 kHz, compatible with 4, 6, or 8 ohm rated amplifiers.
  • Weight: 35.5 lbs. each, Dimensions: 52.1" high, 9" wide, 16.3" deep.
Check Stock

4 Alpine SPE-6090 6x9 600 Watt Car Audio Speakers+4 Channel Amplifier+Amp Kit

  • (2) Alpine SPE-6090 6" x 9" 2 Way Pair Of Car Stereo Speakers Totaling 600 Watts. (1) Alpine BBX-F1200 600 Watt 4/3/2 Channel Amplifier Car Stereo Amp Class-A/B 2-ohm. (1)RockvilIe RWK42 4 Gauge 4 Chan Car Amp Wiring Installation Wire Kit (2) RCA's. 6" x 9" Type-E Coaxial 2-way Car Speakers. Polypropylene cone pearl mica injection. 3/4" Silk soft dome tweeter. Tweeter Magnet: Neodymium. Woofer Magnet: Ferrite. 4 ohms impedance. Square voice coil. Injection molded frame.
  • Peak Power Handling Per Pair: 600 watts. Peak Power Handling Each: 300 watts. RMS Power Handling Per Pair: 150 watts. RMS Power Handling Each: 75 watts. Frequency Response: 65-18,000 Hz. Sensitivity: 91 dB. Top-Mount Depth: 3". Mounting Diameter: 5-15/16" x 8-3/4". Features: Alpine BBX-F1200 600 Watt 4/3/2 Channel Amplifier Car Stereo Amp Class-A/B 2-ohm. Terminal Layout: Two-Sided. Screw Mount / Wire Cover: Integrated Wire and Mounting Screw Terminals.
  • Alpine BBX-F1200 600 Watt 4/3/2 Channel Amplifier Car Stereo Amp Class-A/B 2-ohm. Amplifier Type: Class-A/B. Channel Design: 4/3/2 Channel. Thermal Control: Thermal Management Control. Power Supply: DC-DC PWM Power Supply. Power Supply Design: MOSFET Power. Current Protection: Over-Current, Over-Voltage and Thermal Protection. Crossover:....
Check Stock

MartinLogan Motion SLM Hi-Performance Flat Panel LCR Speaker – Gloss Black – Each

  • On-wall, off-wall LCR speaker with Folded Motion tweeter technology, Wall-mountable with included brackets.
  • High Frequency Transducer: 1″ × 1.4″ Folded Motion Transducer with 5.25″ × 1.75″ diaphragm.
  • Two 4″ high-excursion fiber cone woofers, Two passive bass radiators.
  • Logo on the grille is magnetic and can move and rotate, Includes curved black-glass base and ‘kick-stand’ brackets.
  • Frequency Response: 110–22,000 Hz ±3dB.
  • Horizontal Dispersion: 80 degrees, Vertical Dispersion: 80 degrees, Sensitivity: 90 dB/2.83 volts/meter.
  • Compatible with 4, 6 or 8 ohm rated amplifiers.
  • Recommended Amplifier Power: 20-140 watts per channel.
  • Weight: 6.5 lbs. each, Overall Dimensions (with wall bracket): 25.3″ high, 6.4″ wide, 1.83″ deep.
Check Stock