VCT Rear Axle Bearing Remover Puller Slide Hammer Set Remove Semi-Floating
- ...ring and tighten the nut on smaller end of puller, then thread a slide hammer (not included) to the puller and slide hammer back and forth until the bearing comes out.
- The washer captures the bearing firmly to distribute the applied force over the entire bearing and prevent damage.
- Use the VCT Pneumatic SAE Standard Rear Axle Bearing Puller 3-Piece Service Set – Domestic Car Vehicle Bearings Removal Tool Kit to service semi-floating rear axle bearings on your vehicle.
- These tools make the job simple and prevent damage to your bearings when pulling.
- Much easier than claw-type axle bearing pullers that slip off and chew up the old bearings.
- For removal only, not intended for installation.
- FITS YOUR CAR: Standard SAE sizes work for most American domestic makes and models.
- Set includes the following sizes to fit main bearing tube – 1 inch to 1-7/8 inches, 1-5/16 inches to 2-3/8 inches, and 1-3/8 inches to 2-7/8 inches.
- Sizes permanently laser-etched on tool for easy identification.
- Each tool fits a basic slide hammer with a 5/8-inch x 18 thread pitch.
- EASY STORAGE: Heavy-duty plastic blow-molded carrying case for easy transportation, safe storage, and quick organization.
- PACKAGE CONTENTS: Package includes (3) rear axle bearing removers and (1) carrying c....