ReviewsSeparate Logic Voltage Support

NXP 74HC4052N 74HC4052 - Dual 4-channel analog multiplexer/demultiplexer DIP16 1 Pack

Wide analog input voltage range from -5 V to +5 V.
Logic level translation: to enable 5 V logic to communicate with ±5 V analog signals.
Typical ‘break before make’ built-in.

Logic level translation: to enable 5 V logic to communicate with ± 5 V analog signals.
Typical “break before make” built in.
The products have been strictly screened, with stable performance and reliable data output..

The logic for each channel sampling rate of 24M/s. General applications around 10M, enough to cope with a variety ofoccasions.
Sampling rate up to: 24 MHz , can be 24MHz. 16MHz, 12MHz, 8MHz, 4MHz, 2MHz, 1MHz, 500KHz, 250KHz, 200KHz, 100KHz, 50KHz, 25KHz.
Input Impedance: 1Mohm || 10pF (typical, approximate).

Product name: MOC3061 DIP-6 Optoisolator.
Simplifies Logic Control of 115/240 Vac power. Zero Voltage Crossing.
dv/dt of 1500 V/µs Typical, 600 V/µs Guaranteed.
They are designed for use with a triac in the interface of logic systems to equipment powered from 115/240 Vac lines, such as solid–state relays, industrial controls, motors, solenoids and consumer appliances,etc..
Package Include: 10Pcs/20Pcs/50Pcs/100Pcs.

How to install: please check the product pictures carefully for the wiring diagram steps before using, simple dual-panel design and the input output using the 3 pin single row pin for easy connection, the input voltage is higher than output voltage 1.2V, the module will work normally.
AMS1117-3.3 is a positive voltage regulator step down power supply module, support DC 4.75-12V input and 3.3V fixed voltage and 0.8A current output.
Electronic devices partner: the 3 pins AMS1117-3.3 voltage regulator mini step down power supply module, can be applied to electronic devices which need 3.3V power supply, such as SCM project design, MCU development and more, easy to be connected and provide the power supply.
Where to use: the voltage to 3.3V 800mA DC buck module is applicable for high-efficiency linear regulator published active power regulator battery charger active instrument.
Compatible with: the 3 pins AMS1117-3.3 voltage regulator mini power supply is compatible with Arduino MEGA2560, MSP430 development board, 3.3V low power consumption MCU, FPGA/CPLD PLD programmable logic systems, ARM7 ARM9 ARM11 STM32, etc..
Provide more safety: the AMS1117-3.3 800mA DC buck module features overheat shutdown circuit provides overload and over-temperature protectio....

1. Internal logic level conversion circuit. No need to externally convert 5V level to 3.3V level.
2. The power input port is equipped with anti-reverse circuit. Avoid accidental power plugging, which may cause the module to burn out..

★L298N as main driver chip makes strong driving ability and strong anti-interference,dual-channel h-bridge driver working mode creates higher working efficiency,,drive stepper dc motors to work.to avoid damage the voltage stabilizing chip, please use an external 5v logic supply when using more than 12v.
★Dual-channel H-bridge driver working mode creates higher working efficiency..
★To avoid damage the voltage stabilizing chip, please use an external 5V logic supply when using more than 12V driving voltage..
★Use large-capacity filter capacitors and diode with freewheeling protection function, increasing reliability..
★L298N as main chip. Can drive one 2-phase stepper motor, one 4-phase stepper motor or two DC motors..

Four independent voltage comparators that are designed to operate from a single power supply over a wide range of voltages.
Wide Supply Ranges Single Supply: 2 V to 36 V, Dual Supplies: ±1 V to ±18 V, Differential Input Voltage Range Equal to Maximum-Rated Supply Voltage: ±36 V, Low Input Offset Current: 3 nA (Typical).
Low Supply-Current Drain Independent of Supply Voltage: 0.8 mA (Typical), Low Output Saturation Voltage, Common-Mode Input Voltage Range Includes Ground.
Low Input Bias Current: 25 nA (Typical), Low Input Offset Voltage: 2 mV (Typical), Low Output Saturation Voltage.
Example Applications: Industrial, Automotive: Infotainment and Clusters, Body Control Modules, Power Supervision, Oscillators, Peak Detectors, Logic, Voltage Translation.

Software is open source, firmware source code is provided, and firmware can be compiled by yourself.
The host computer is open source. The current logic analyzers on the market generally use the software to crack the host computer, and there are some legal risks in use. Free and open source, easy to use and more powerful.
Support up to 24Mhz sampling rate, 8 channels can be sampled at the same time, can meet the daily development work use.
Expenditure input voltage [-0.5v, 5.25v], where the low level is [-0.5v, 0.8v], and the high level is [2v, 5.25v].
Support Windows/Linux/Mac/Android platform use.

Four independent voltage comparators that are designed to operate from a single power supply over a wide range of voltages.
Wide Supply Ranges Single Supply: 2 V to 36 V, Dual Supplies: ±1 V to ±18 V, Differential Input Voltage Range Equal to Maximum-Rated Supply Voltage: ±36 V, Low Input Offset Current: 3 nA (Typical).
Low Supply-Current Drain Independent of Supply Voltage: 0.8 mA (Typical), Low Output Saturation Voltage, Common-Mode Input Voltage Range Includes Ground.
Low Input Bias Current: 25 nA (Typical), Low Input Offset Voltage: 2 mV (Typical), Low Output Saturation Voltage.
Example Applications: Industrial, Automotive: Infotainment and Clusters, Body Control Modules, Power Supervision, Oscillators, Peak Detectors, Logic, Voltage Translation.

Product name: MOC3061 DIP-6 Optoisolator.
Simplifies Logic Control of 115/240 Vac power. Zero Voltage Crossing.
dv/dt of 1500 V/µs Typical, 600 V/µs Guaranteed.
They are designed for use with a triac in the interface of logic systems to equipment powered from 115/240 Vac lines, such as solid–state relays, industrial controls, motors, solenoids and consumer appliances,etc..
Package Include: 10Pcs/20Pcs/50Pcs/100Pcs.