ReviewsSoft close

Champagne

5 pairs 22 inch soft close drawer slides, Mounting screws included. Attention: the mounting brackets are not included..
Made from high-grade cold rolled steel that is zinc plated. Surface prevent rust. Three-section drawer slide offer Load-bearing 110LB..
spring damping design, the drawer can be closed silently and smoothly. automatic closing performance! Steel ball-bearing action that offer less noise....
Side mounted Steel ball-bearing action, non handed close design, active stop, Internal rail separation is simple and easy to install and remove....
Before purchasing, please measure the depth of your cabinet and select the correct drawer slides. VESLA HOME soft close drawer slide stay by a....

Check Stock

CabinetRTA Soft-Close DIY Slide Out Cabinet Shelf Pull-Out Wood Drawer Storage (W)33 x (D)21

The minimum cabinet opening width should be 33 inch, and the interior depth of cabinet should be 21.25 inch - 23 inch (Includes an adjustable bracket to drill on the cabinet). This Soft-Close Pullout Drawer Box actual width is 32 inch. The total width of drawer sliders (both sides) is 1 inch.
Not Assembled: Shipped "UNASSEMBLED" but should be very easy to assemble and take just a few minutes. No nail and glue needed. Each order is One Single set. This Soft-Close Pull Out Drawer is good for pantry, vanities, under sink (kitchen or bathroom) (see video).
Natural Wood Finished: This Soft-Close Pull Out Drawer Organizer is dovetail joint drawer box. No paint or stain is applied.
This Soft-Close Pull Out Drawer includes 5/8" thick solid wood, and one thick plywood bottom.
45mm Slider: Rated to hold up to 100 lb. This Roll Out Drawer for Cabinet Includes two 20-inch soft-close full extension drawer slides (Side-mounted). Assembly Instruction Updated (Feb.2021).

Check Stock

CabinetRTA Soft-Close DIY Slide Out Cabinet Shelf Pull-Out Wood Drawer Storage (W)27 x (D)21

The minimum cabinet opening width should be 27 inch, and the interior depth of cabinet should be 21.25 inch - 23 inch (Includes an adjustable bracket to drill on the cabinet). This Soft-Close Pullout Drawer Box actual width is 26 inch. The total width of drawer sliders (both sides) is 1 inch.
Not Assembled: Shipped "UNASSEMBLED" but should be very easy to assemble and take just a few minutes. No nail and glue needed. Each order is One Single set. This Soft-Close Pull Out Drawer is good for pantry, vanities, under sink (kitchen or bathroom) (see video).
Natural Wood Finished: This Soft-Close Pull Out Drawer Organizer is dovetail joint drawer box. No paint or stain is applied.
This Soft-Close Pull Out Drawer includes 5/8" thick solid wood, and one thick plywood bottom.
45mm Slider: Rated to hold up to 100 lb. This Roll Out Drawer for Cabinet Includes two 20-inch soft-close full extension drawer slides (Side-mounted). Assembly Instruction Updated (Feb.2021).

Check Stock

Toy Box Hinges Soft Close - Lid Support Hinges (Pack of 2), Safety Soft Close Hinges for Chest Toy Box, Slow Close Hinges,Lid Support Soft Close 105 Degree Open (APFFSY)

GENTLE SLOW CLOSE HINGES — It's heavy lid hinge and soft close lid support. Expecially excellent slow close and safety solution on chest hinges, toy box hinges. Lids will go down slowly and gently to avoid slams shut and crush the little fingers of children!.
KEEP LID STAY OPEN — The lid support hinge will hold the lid open until you want to close. Never worry about having to support lid by hand anymore. It's widely usage as slow close hinges for toy box hinges, chest hinges, also fit for overhead kitchen cupboard, wardrobe lids too！.
SMALL COMPACT DESIGN — The compact design allows for installation in tight fit areas. The lid stay allows the lid to open at a maximum 105 degree angle. Perfect for any lids or flaps when lid support soft close is required..
EASY TO INSTALL — The safety hinges can be mounted on the left or right side, also used for side-mounting and top-mounting. Keep the soft close hinges installed for 75°-105° adjustable opening angles, depending on actual situation. It can fit for most lids.
REFUND GUARANTEE — If you are not satisfied w....

Check Stock

SmartStandard Barn Door Soft Close Mechanism Hardware Kit- Match 88-132 Pounds Single Door, Upgraded Hole-Free Version, Spring Buffer Damper-Fit Normal Weight Door, Set of 2

USER-FRIENDLY DESIGN: This soft close damper is hidden behind the rail, it slows the doors bringing them to a soft stop in their final position..
FEATURES: Hole-free version barn door hardware stopper, one-way operation. With the latest design of the soft close, there is no need to drill holes on the track..
EASY TO INSTALL: Simply attach the soft close to the back of the track with the hook and fasten it with the supplied hex wrench. The package has detailed installation instructions. Each soft close mechanism fit for door weight 88-132 pounds..
PACKAGE INCLUDES: 2 x Soft Close Mechanism, 4 x S-Shape Hooks, 2 x Actuators, 6 x Screws, 1 x Wrench Accessories, 1x Installation Manual are included. All other necessary hardware is included as you see in the pictures..
SERVICE: If you have any questions, please feel free to contact with us, the professional installation team will solve the problem as soon as possible..

Check Stock

Toy Box Hinges Soft Close - APFFSY Lid Support Hinges, Safety Soft Close Hinges for Chest Toy Box, Slow Close Hinges (Pack of 2) Lid Support Soft Close 105 Degree Open

GENTLE SLOW CLOSE HINGES — Hinges for wooden box and soft close lid support. Especially excellent slow close and safety solution on chest hinges, toy box hinges, locking hinges..
KEEP LID STAY OPEN — The lift and up hinges will hold the lid opened until you want to close. Lids will go down slowly and gently to avoid slams shut and crush the little fingers of kids. Good gift fit for the kids' toy box and chest. It's widely usage as slow close hinges for toy boxes, chest hinges, also fit for overhead kitchen cupboard, cabinet hinges too..
SMALL COMPACT DESIGN — The lid closer compact design allows for installation in tight fit areas, and the lid to open at a maximum 105 degree angle. Weight Capacity: 6-12lb/1pc, 15-25lb/2pcs. Perfect for any lids or flaps when lid support soft close is required..
EASY TO INSTALL 【 IMPORTANT：Refer to our install video ! 】 — The safety hinges can be mounted on the left or right side, also used for side-mounting and top-mounting. Keep the soft close hinges installed for 75°-105° adjustable opening angles, depending on actual situation. It can fit for most lids..

Check Stock

ROTESONNE 60 Pack Soft Close Cabinet Hinges Built-in Soft Close Hinges Damper, 1/2 Inch Partial Overlay Kitchen Cabinet Hinges for Frameless/ Face Frame Cabinet

【1/2" PARTIAL OVERLAY】The hinges are designed for 1/2” overlay and the HOLE DISTANCE is 45 mm(1-4/5"), Suitable for both FRAMELESS and FACE FRAME cabinets..
【SOFT CLOSE DAMPER】Built-in cabinet soft close damper, even if the door is closed with great force, there will be no closing sound..
【EASY INSTALLATION】There are 4 screws on the hinge for 6-way adjustment. Just turn the screw on the soft-close hinge to adjust the door's position for a perfect fit. Allowing for up to 100 degrees of opening..
【PREMIUM MATERIAL】Made from stainless steel with a nickel-plated finish for long-lasting durability..
【60PCS SET OF HINGE】 The package includes 60 cabinet hinges, 240 screws, 60 soft door dumpers for free..

Check Stock

RealPlus 2pcs Barn Door Soft Close Mechanism Spring Buffer Damper, Upgraded Hole-Free Version for Door Weight 70-160 Pounds Adjustable Door Stoppers

This soft close damper is hidden behind the rail, it slows the doors bringing them to a soft stop in their final position.
Hole-free version barn door hardware stopper, one-way operation. With the latest design of the soft close, there is no need to drill holes on the track.
To have the best effect, we suggest the weight of the doors should be around 70-160 LBS.
Simply attach the soft close to the back of the track with the hook and fasten it with the supplied hex wrench.
Package includes: 2 x Soft Close Mechanism, 4 x S-Shape Hooks, 2 x Actuators, 6 x Screws, 2 hex wrench..

Check Stock

Toy Box Hinges Soft Close - Lid Support Hinges Heavy Duty,Soft Close Hinges for Chest Toy Box,Lid Stay Support 50lb/2pcs (APFFSY)

KEEP LID STAY OPEN — The lid support hinge holds the lid open until you want to close. Similar purpose of a gas strut but doesn't self lift, stays and supports lid where you want it. It's widely usage as hinges for wooden box, such as toy box hinges,chest hinges, also fit for overhead kitchen cupboard,wardrobe lids too.Perfect for any lids or flaps when soft close lid support is required..
DURABLE MATERIAL — Heavy lid hinge, max weight support 50lbs/2pcs.The up-grated version has the advantages of strong bearing capacity,metal connector instead of plastic clip.Made of premium quality zinc alloy with maximum corrosion resistance and durability the chest slow close hinges guarantee high performance..
EASY TO INSTALL【 Important：Refer to our install videos ! 】 — The lid closer can be mounted on the left or right side, also used for side-mounting and top-mounting. Upward door open adjustable angle of 75°,90°,110°. It can fit for most lids and allow you to keep your lids stay at any angle. Just mark two drilling holes, and screw each mounting bracket. No need to use the diagram on the package！.
ADJUSTABLE TENSION — Adjust the toy box hinges soft close tension with Allen wrench to fit for lids with different weight. After installing the....

Check Stock

Berta 10 Pieces Full Overlay Frameless Soft Closing European Hinges 110 Degree 3D Adjustable Clip On Concealed Kitchen Cabinet Door Hinges with Screws 10 Pieces

PACKAGE CONTENT: 6 Pieces Soft Close Full Overlay Hinges and Installation Screws.
MAIN SPECIFICATIONS: Overlay: Full, Opening Angle: 110 Degree, Closing Type: Soft Closing, Adjustment: 3-Cam Vertical, Horizontal and Depth adjustment. These are the main specifications of our hinges, please look at the descriptions section at the bottom for a comprehensive view of all specifications..
FULL OVERLAY DESIGN: These hinges will have a straight arm and it allows your cupboard door edge to be completely in line with the edge of your cabinet. One major advantage of a full overlay concealed hinge is that it is fully adjustable due to three little screws that they have. Depth, Side and Height adjustments are made with these three screws. They can be fine-tuned to ensure the door frame is totally concealed and fits together perfectly..
SOFT CLOSING: The soft closing function is one of the best indicators of the quality of the hinges. The soft closing feature prevents all disturbing noises from the kitchen and extends the lifetime of the doors, cabinets, and hinges..
CLIP-ON FUNCTION: The clip-on hinge is the easiest and quickest to fit, without any tools. It is ideal for doors requiring multiple hinges to be fitted this is because you simply line the hinge up with th....

Check Stock

Cambridge-Casual AM-370218T Arie Storage Box, Natural Teak

[WEATHER-RESISTANT] Crafted of superior Indonesian teak wood, made to withstand all-weather and maintenance-free for easy use.
[HUGE CAPACITY] Top load capacity is 200 lbs and storage capacity can hold up to 48 gallons..
[SOFT-CLOSE LID] Equipped with its soft-close lid and ample storage space. The soft-close function makes door closes in gentle movement.
[EASY ASSEMBLY] Assembly required with easy-to-follow instruction (guideline included in the box). It takes no time from unboxing until the product is ready to use..
[CARE] Apply teak oil to maintain the original golden teak color or can be left to weathered into the beautiful silvery-grey patina that is typical of untreated teak..

Check Stock