ReviewsSpi Equipment

Winegard WF-3000 White ConnecT WF1 WiFi Extender (Secure RV Internet, 3x High Performance Antennas, RV WiFi Booster (White Outdoor Unit))

  • Extended RV Wi-Fi range - powerful amplifier and three high performance external antennas for increased range, multi-user mimo-ready for Faster performance for each device.
  • Secure RV Internet - Advanced Wi-Fi protected access (wpa and wpa2-psk), guest Network access, double firewall protection (spi and nat), denial of service attack prevention.
  • Simple setup - connect all of your devices instantly when you connect to a new Network. Easy step-by-step on screen instructions make setup a breeze.
  • Winegard antenna experts - RV industry pioneers and a leading designer and manufacturer of quality antenna and signal reception equipment since 1954.
Check Stock

Adafruit 4201 Airlift – ESP32 WiFi Co-Processor Breakout Board

  • a breakout board that lets you use the powerful ESP32 as a WiFi co-processor..
  • Having WiFi managed by a separate chip means your code is simpler,.
  • Send basic but powerful socket-based commands over 8MHz SPI for high speed data transfer.
  • We placed an ESP32 module on a PCB with level shifting circuitry, a 3.3V regulator, and a tri-state chip for MOSI so you can share the SPI bus with other devices.
Check Stock

Happymodel Mobula6 1S 65mm Brushless Whoop Drone Mobula 6 BNF AIO 4IN1 Crazybee F4 Lite Flight Controller Built-in 5.8G VTX (Frsky RX,19000KV)

  • Flight controller: CRAZYBEE F4 Lite Firmware target: Frsky SPI RX version is CrazybeeF4FR.
  • Flysky version is Crazybee F4FS. Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready. Built-in Betaflight OSD(SPI Control). Built-in 5.8G VTX. Built-in SPI Frsky/Flysky receiver. Built-in 5V 1A BEC. Built-in voltage detection..
  • Onboard 4in1 ESC: MCU upgraded to EFM8BB21 Power supply: 1S LiPo/LiPo HV Current: 5A continuous peak 6A (3 seconds) Support BLHeliSuite programmable Factory firmware: O_H_5_REV16_7.HEX Default protocol: DSHOT600.
  • Runcam Nano3: Horizontal Resolution: 800TVL Lens : 2.1mm(M8) FOV 160° Signal System: PAL/NTSC Non Switchable Day/Night: Color.
  • Onboard 5.8g 40-CH 25mw VTX: Input voltage: 3.3V 5.5V Current consumption: 300mA(type) Frequency: 5.8GHz 5bands 40 channels Smartaudio ready.
Check Stock

2.9inch E-Ink Display Module 296x128 Pixel White,Black Two-Color 3.3V/5V E-Paper Screen LCD Support Partial Refresh SPI Interface for Raspberry/Jetson Nano/Ard/Nucleo

  • 2.9inch, 296x128 resolution, with embedded controller, communicating via SPI interface, supports partial refresh. Due to the advantages like ultra low power consumption, wide viewing angle, clear display without electricity, it is an ideal choice for applications such as shelf label, industrial instrument, and so on..
  • Display color: black, white. Grey level: 2. Partial refresh time: 0.3s. Full refresh time: 2s. Refresh power: 26.4mW(typ.). Standby power: 170°..
  • Interface: 3-wire SPI, 4-wire SPI. Outline dimension: 89.5mm × 38mm. Display size: 66.89mm × 29.05mm. Dot pitch: 0.138 × 0.138..
  • Onboard voltage translator, compatible with 3.3V/5V MCUs.Operating voltage: 3.3V/5V. Ultra low power consumption, basically power is only required for refreshing.No backlight, keeps displaying last content for a long time even when power down.
Check Stock

Zeroplus Logic Analyzer Lap-C Pro,32-Channels,128Mb per Channel, Compitable with Windows, Portable & Flexible

  • 32-Channels Logic Analyzer, 128Mb per Channel.
  • 6 protocol triggers (hardware): I2C, I2S, SPI, SVID, UART, CAN2.0B.
  • Pattern Generator: I2C, SPI, UART, CAN, more than 120 built-in protocol decoders.
  • Long-time records: Transfer via USB 3.0 to hard drive to sample for hours or days.
  • Compitable with Windows OS 10/ 8.1 / 7 (32 or 64 bit).
Check Stock

Geekworm for Raspberry Pi 4 Model B, 3.5 inch Touch Screen with ABS Case and Pi 4 Heatsinks Kit, Max 50FPS 480x320 Pixel Monitor TFT Touch LCD (Support Raspbian, Ubuntu, Kali, Retropie System)

  • For the document and download information, refer to Geekworm WiKi search (3.5_LCD_B)..
  • Note: 1. The Raspberry Pi 4B mother board and cooling fan is not included in all the packing list. 2. The black ABS case only suitable for this 3.5 inch screen with Raspberry Pi 4 Model B, do not support other Raspberry Pi versions. Not support install cooling fan..
  • Physical resolution 320 x 480, with resistive touch control.
  • it supports up to 125MHz SPI signal input, showing stable and no flicker.
  • Support Raspbian/Ubuntu/Kali/Retropie system, provide driver and image, please refer to WiKi(user manual)..
  • LCD Interface: SPI (up to 125MHz SPI input, Max FPS: 50Mhz).
Check Stock

Winegard WF-3035 Black ConnecT WF1 WiFi Extender (Secure RV Internet, 3x High Performance Antennas, RV WiFi Booster (Black Outdoor Unit))

  • Extended RV Wi-Fi range - powerful amplifier and three high performance external antennas for increased range, multi-user mimo-ready for Faster performance for each device.
  • Secure RV Internet - Advanced Wi-Fi protected access (wpa and wpa2-psk), guest Network access, double firewall protection (spi and nat), denial of service attack prevention.
  • Simple setup - connect all of your devices instantly when you connect to a new Network. Easy step-by-step on screen instructions make setup a breeze.
  • Proven reliability - 2 year parts, 1 year labor warranty. Proven dome design is rigorously tested to meet the demands of the mobile environment.
  • Winegard antenna experts - RV industry pioneers and a leading designer and manufacturer of quality antenna and signal reception equipment since 1954.
Check Stock

DORHEA 10PCS ESP-WROOM-32D ESP32 Bluetooth and WiFi Low Power Module integrates ESP32-D0WD Generic Wi-Fi+BT+BLE MCU Modules for Voice Encoding Music Streaming and MP3 Decoding

  • ESP32-WROOM-32D are powerful, generic Wi-Fi+BT+BLE MCU modules that target a wide variety of applications, ranging from low-power sensor networks to the most demanding tasks, such as voice encoding, music streaming and MP3 decoding..
  • The sleep current of the ESP32 chip is less than 5 µA, making it suitable for battery powered and wearable electronics applications..
  • ESP32-WROOM-32D integrate a 4 MB of external SPI flash. The integrated SPI flash is connected to GPIO6, GPIO7, GPIO8, GPIO9, GPIO10 and GPIO11. These six pins cannot be used as regular GPIOs..
  • Flash integrated on the module and are not recommended for other uses..
Check Stock

Teyleten Robot GY-291 ADXL345 Digital 3-Axis Acceleration of Gravity Tilt Module IIC SPI for Arduino 3pcs

  • Brand new original ADXL345 chip, quality assurance.
  • According to the 16-bit two's complement format, it can be accessed through the digital interface SPI (3-wire or 4-wire) or I2C.
  • ADXL345 is very suitable for mobile device applications. It can be used for tilt sensing applications while measuring static acceleration of gravity,....
  • With high resolution (13 bits) measurement up to ±16g. The digital output data is in 16-bit two-valued complement format, which can be passed through....
  • Communication method: IIC / SPI communication protocol.
Check Stock

Fafeicy 2.8\ ILI9341 SPI TFT LCD Touch Panel, 64k Serial Port Module, with PCB, 5V/3.3V 240x320, Integrated Circuit Ic

  • SPI TFT LCD Touch Panel is designed with one socket for sd card..
  • With PCB plate (including power supply IC, SD), compatible with 5110 interface.
  • 5V compatible, use with 3.3V or 5V logic..
  • This is a new 2.8 inch serial SPI color display module with touch function..
  • We strive to provide a product of the highest quality and the best customer experience, if you are not completely satisfied, do not hesitate to contact us at any time..
Check Stock

HiLetgo 2.2 Inch ILI9341 SPI TFT LCD Display 240x320 ILI9341 LCD Screen with SD Card Slot for Arduino Raspberry Pi 51/AVR/STM32/ARM/PIC

  • Durable hard PCB board and SD card socket, ideal for 5110 interface.
  • 2.4 inch TFT LCD shield without touch panel, fast to operate.
  • Support Serial SPI Mode, Interface 4-Wire SPI, Need 4 IOs from your MCU only.
  • Support a variety of microcontroller IO connection, professional and practical.
  • 5V compatible, use with 3.3V or 5V logic.
Check Stock