ReviewsSurface Mount Car Speakers

TAGVO Phone Ring Holder Finger Ring Kickstand and 3M Sticky Adhesive Replacement Set Including Metal Plates - 360°Rotation Metal Grip Holder for Magnetic Car Mount Compatible with Cell Phone

  • 【Metal Plate with Strong Adhesive】Super thin metal plate is designed to use with magnetic mobile phone car mount, magnetic air vent mount and other magnetic cellphone car mount. 1, Advanced surface treatment. 2, Storng adhesive on the back. 3, Scratch-Resistant Protective Films Included, simply stick magnet sticker for phone mount behind films to your case/battery cover, on a rugged case, or directly to your device. Then device will automatically suck as it closes to the car mount..
  • 【3M sticky adhesive replacements compatible with Phone Holder, Metal Plates, Magnetic Car Mount Holder】IMPORTANT NOTE: Here are some problem customer may encountered frequently. 1. Hard to peel off the red backing film, in this situation, please repeat this act: peel-if come up-press red film back-peel again. 2. Adhesive can’t stick well on phone case, please don’t not stick adhesion on rugged, texture surface silicone phone case, it may not stick well. 3. Last but the most important rule, wait.
  • 【Easy to use】You need to remove the used 3M tape of phone car mount and clean up the mounting surface with alcohol pad included until fully dry before installation, then place a new 3M adhesive sticky circles on the back of grip mount or phone case and pres....
Check Stock

2 Kicker 43DSC69304 DSC6930 6x9 Car Speakers+2 43DSC3504 DSC350 3.5' Speakers

  • Package Includes: (1) Pair of Kicker 43DSC69304 6x9 360 Watt 3-Way Car Audio Speakers. (1) Pair of Kicker 43DSC3504 3.5" 80 Watt 2-Way Car Stereo Speakers..
  • Pair Kicker 43DSC69304 DSC6930 6x9 360 Watt 3-Way Car audio Speakers 4-Ohm. Peak: 720 Watts per pair / 360 Watts each. RMS: 180 Watts per pair / 90 Watts each.
  • Recommended Power Range: 6 - 90 watts RMS per channel. Thin-Profile. Zero-to-Minimal Tweeter Protrusion. Polypropylene midwoofer. Acoustic-foam surround. 1/2" Polyethylene-Naphthalate Dome Tweeter.
  • Stamped steel basket. EVC (Extended Voice Coil) technology, for excellent sound - even with a factory radio. Neodymium Tweeter magnet. Grilles included. 4 ohms impedance.
  • Frequency Response: 30-20,000 Hz. Top-mount Depth: 3-1/4". Mounting Diameter: 5-5/8 x 8-7/16". Sensitivity: 92dB. Item Weight: 8.9 lbs.
Check Stock

Pop-Tech 3M Adhesive Sticker Tapes Accessories Pack Replacement Kit for Magnetic Phone Car Mount and Pop Grip Mount Base, Includes Rectangle Metal Plate and Round Magic Plate, Clear Protective Films

  • ...phone without leaving any residue. Remember to apply the protective film on the back of your device before sticking the metal plate.
  • 1 pair of round adhesive sticker replacement for your mount metal plate. Make the car mount plate reusable. 2 piece of alcohol prep pads sent as a GIFT to help you to take care of the surface where you attach your magnetic car mount. You may use the alcohol pad to clean the mounting surface for better result.
  • This set of universal accessories pack is exclusively designed for magnetic car mount and includes everything you need to work with magnet mount. Great replacement car mount accessories pack to extend the service life of your magnetic car mount.
Check Stock

Qubed Compiled by Hans Dunkelkammer

  • VERSATILE MULTI-CHANNEL POWER AMPLIFIER: The S4-100 is a high efficiency multi-channel class D amplifier car audio buffs love for daily driver and....
  • Easy Install, even for Dummies: Set screw terminals connect easily to 4 AWG power/ground wire, and 10 AWGspeaker wire. Surface-mount feet make....
  • NO ELECTRICAL UPGRADES NEEDED: The S4-100 is the perfectmulti channel ampto power a basic “door-swap” upgrade.With a full-range frequency response....
  • Adjustable Crossovers for fine tuning:Sending the wrong frequencies to a speaker can cause poor sound quality and damage speakers. To avoid this,....
  • Our Longevity is Your Advantage: Established in 2002 as Audioque (AQ), we have nearly 20 years of innovation behind our products. We focus on getting....
Check Stock

TORRTOWAY Military Grade Drop Samsung Galaxy Note 9 Case Shockproof with Kickstand Stand Built-in Magnetic Car Mount Armor Protective Case for Galaxy Note 9 Phone Case (Silver)

  • [Compatible Model] Compatible with Samsung Galaxy Note 9. Case for Samsung Galaxy Note 9 [Notice:Not include Magnetic Car Mount Holder].Please Confirm Before Purchasing..
  • [Built-in Foldable Kickstand] Built-In Hide Kickstand:Designed with a built-in kickstand for video calls, watching videos/movies.free your hands.Drop-proof, shockproof and dust-proof,extremely strong protection..
  • [Metal Magnetic Sheet] Built-in metal magnetic sheet, can stably adsorbed to the Magnetic Car Mount holder directly.It is convenient for you to navigate the route when driving..
  • [Precise Cutouts] Precise Cutouts Provide You with Easy Access To All Ports, Speakers, Camera, Buttons and Other Features.Military Grade Drop Test standards,Metal painted surface. Excellent for Outdoor Activities..
  • [Service] We provide premium and 6 months Money Back Guarantee. If you order wrong size or have other question,please feel free to contact us..
Check Stock

MU-CN 12 PCS Replacement Adhesive Stickers for Pop Phone Stand Mount Double Sided Adhesive Pads Circle Sticky Compatible with POP Out Phone Collapsible Grip & Stand/Car Magnetic Phone Mount Holder etc

  • ...esive exclusively designed for grip holder back and various magnetic cell phone car phone mount base. This adhesive replacement kit is a good choice to remount your phone wall mount and magnetic phone mount. With your adhesive cell phone holder, you can position the phone anywhere there’s a flat and hard surface in the car dashboard.
  • Strong 3M Sticky Adhesives: With this car mount replacement parts, you do not worry about purchasing another grip mount. Just remount your expanding stand with this vhb 3m double sided adhesive pads. Best sticker replacement pads for your phone adhesive mount.
  • For best result, please make sure the mounting surface and base of mount adhesive clear cleaned completely before attaching a new 3m adhesive stickers. As for the 3m adhesive tapes, if you find the phone holder adhesive hard to peel, please try to press it back and peel again.
  • Easy to use: You need to remove the used 3m tape of phone car mount and clean up the mounting surface with alcohol pad included until fully dry before installation, then place a new 3m adhesive sticky circles on the back of grip mount and press firmly for 5 to 10 minutes for better connecting to the car mount base. please wait 24 HOURS to use after stuck.
Check Stock

KICKER 46CSS654 CS Series 6.50 Inch 2 Way Component Crossover Speakers with Tweeter Leve Control and Extended Voice Coil for Car Sound System

  • High-quality set of car audio speakers that reach new levels of accuracy with balanced frequency response and a deep sound spectrum.
  • Includes separate titanium tweeter and 2-way crossovers with tweeter level control for a customized sound and unparalleled sonic quality.
  • Mount with flush, angled, or surface mount pods that allow for peak performance and precise installation.
  • Dimensions (L x W x H): 15 x 11 x 4 inches.
  • Features remarkable bass response from Extended Voice Coil technology for a full, undistorted playback.
  • Durable speaker construction and neodymium magnets reveal subtle details and steel mesh grilles protect your drivers.
Check Stock

Pegoo iPhone 11 Pro Case,Silicone Impact Resistant Hybrid Heavy Armor with Bracket Bumper Cover Case for iPhone 11 Pro (5.8) (Navy Blue)

  • A sturdy inner TPU case tightly grips your phone while absorbing shocks and bumps.
  • It can be attracted to a magnetic car mount holder.the metal plate can be well attached to the magnetic phone car mount, giving you safe driving experience. (the magnetic car mount is not included).
  • The Built-in foldable kickstand allows you to watch movies and videos hands free without hassle.
  • easy access to all ports, sensors, speakers, cameras and all Phone Features.
Check Stock

BENTOBEN iPhone 13 Case, Phone Case iPhone 13, Slim Fit 360° Ring Holder Shockproof Kickstand Magnetic Car Mount Supported Non-Slip Protective Women Girls Men Boys Cover for iPhone 13 6.1 Inch, Black

  • ...f the phone case, you can put your smart phone on your magnetic car mount whenever it is necessary and your phone will be safe and secure. Simple and practical when you are driving a car. (Magnetic car mount holder is NOT included.).
  • 【Precise Cutouts】Precise cutouts improve access to all ports, buttons, cameras, speakers and microphones, ensuring quick access and feedback, allow full access to all the functions and buttons without removing your iPhone 13. The edges and bevels above the display screen and the camera avoid the lens and screen from scratches or dusts..
Check Stock

BENTOBEN iPhone 13 Mini Case with 360° Ring Holder, Slim Fit Shockproof Kickstand Magnetic Car Mount Supported Non-Slip Protective Women Men Girls Boys Case Cover for iPhone 13 Mini 5.4\

  • ...f the phone case, you can put your smart phone on your magnetic car mount whenever it is necessary and your phone will be safe and secure. Simple and practical when you are driving a car. (Magnetic car mount holder is NOT included.).
  • 【Precise Cutouts】Precise cutouts improve access to all ports, buttons, cameras, speakers and microphones, ensuring quick access and feedback, allow full access to all the functions and buttons without removing your iPhone 13 Mini case. The edges and bevels above the display screen and the camera avoid the lens and screen from scratches or dusts..
Check Stock

Scosche MPOHM MagicMount Pro Magnetic Phone Holder Mount for Desk or Countertop - Compatible Apple Watch Charging Mount, Universal with All Devices - Home Mount

  • Suction Phone Holder - Safely and quickly secure any mobile device in your car to a dashboard, windshield or any firm & flat surface. With a StickGrip suction cup base, this car mount will also work as a desktop, countertop, or phone holder..
  • Magnetic Phone Holder - Comes with 30% stronger Rare-Earth neodymium phone magnets that provide a secure grip to your iPhone, Android or Tablet. 100% mobile device safe. Simply stick the car mount magnet to the back of your phone case for a secure magnet hold..
  • Optimal Viewing - 360-degree adjustable rotating neck, this magnetic car mount allows viewing from any angle. The car magnetic phone mount connection allows you to rotate seamlessly between portrait and landscape orientation in a snap. Compatible apple watch charging mount that works with your existing lightning charging cable..
  • Convenient Design - Integrated cable clip secures the charging cable to our car cell phone holder for a clean mount. The cradle-free design permits safe, easy one-handed use and access to all controls and ports. Easily customize mount holder with 2 interchangeable trim rings, black and silver..
  • Home Accessories Included - Pro Phone mount, rectangular MagicPlate, round MagicPlate, installation ring for round MagicPlate, surface adapter....
Check Stock