ReviewsWater Coolant Pump

Thermaltake Pacific C360 Ddc Res/Pump 5V Motherboard Sync Copper Radiator Soft Tube Water Cooling Kit CL-W253-CU12SW-A

  • Analog/digital lighting – Analog lighting allows a selection of 7 lighting effects with the included a RGB Controller. Connect lights to select 5V RGB Capable motherboards TO utilize digital lighting schemes from as US aura Sync, Gigabyte RGB FUSION, MSI Mystic Light Sync, and ASROCK polychrome Sync.
  • All includded – the C360 soft tube Kit contains a CPU water block, pump/reservoir, radiator, fans, fittings, tubing, and coolant, which are components necessary to complete a CPU water cooling loop.
  • Slim copper radiator – the C360 is engineered with 12 copper flat tubes and 17 fins per Inch. This radiator’s 27mm thick design assures fitment compatibility with most form Factor chassis.
  • Exclusive components – W4 a RGB Edition water block, T1000 pure Clear Coolant, and a new pr15-ddc pump/reservoir combo.
Check Stock

Rosewill CPU Liquid Cooler, Closed Loop PC Water Cooling, Quiet Dual 120mm PWM Fans, Intel LGA 2011/2066/1366/1150/1151/1155/1156/775, AMD AM4/AM3+/AM3/AM2+/AM2/AM1/FM2+/FM1 -PB240

  • CPU Water Cooler: Transfer heat away from your CPU and GPU more quickly than air with this water-based coolant method of cooling, featuring low-evaporation tubes to keep coolant from drying up too quickly..
  • CLOSED LOOP COOLER: This self-contained cooling system, closed loop design with pre-filled coolant is virtually immune to leaks with no refill needed, even with rapid liquid circulation from the built-in high power water pump on radiator.
  • PWM FANS SPEED CONTROL: Dual 120mm fans with 4-pin pulse-width modulation allows you to ramp up or lower your fans and pump speed, giving you more control.
  • EASY INSTALLATION: Effortlessly upgrade your stock CPU fan to the efficiency of Intel/AMD compatible liquid CPU cooling in a few easy steps.
  • PERFORMANCE COPPER BASE: Equipped with a microfin, slim copper cold plate cooling block for better thermal conductivity, effective heat transfer and low noise.
Check Stock

Caterpillar Marine 238-8648 ELC Extended Life Coolant EACH

  • Minimum coolant life of 600,000 miles with only one Shell Rotella ELC Extender addition at 300,000 miles.
  • Improved water pump seal life due to low dissolved solid levels.
  • Excellent pitting protection for wet sleeve cylinder liners.
  • Excellent, long-term corrosion protection of all cooling system metals including aluminum, brass, cast iron, steel, solder, and copper.
  • No regular Supplemental Coolant Additives (SCA's) required.
Check Stock

Sherco-Auto K-Seal Multi Purpose One Step Permanent Coolant Leak Repair 8 oz Gasket Radiator

  • Permanent coolant leak repair - Just shake, pour and go. Mixes with all antifreeze. No draining or flushing..
  • Fixes cracks and leaks in radiator, head gasket, freeze plugs, cylinder heads, heater core, water pump casing and engine blocks.
  • The Safe and Easy Way to Fix a Coolant Leak. Works also a Radiator stop leak, head gasket stop leak and engine stop leak..
  • Permanent Coolant Leak Repair with K-Seal.
Check Stock

Corsair Hydro X Series XD5 RGB Pump/Reservoir Combo - D5 PWM Pump - 330ml Reservoir - Ten Individually Addressable RGB LEDs - Temperature Sensor - Black

  • A high-performance Xylem D5 PWM pump controlled via PWM to deliver the perfect flow balance for your loop..
  • Ten individually addressable top-mounted RGB LEDs light up your reservoir with stunning customizable RGB lighting. Add a CORSAIR iCUE Controller (sold separately) and powerful CORSAIR iCUE software to customize and sync RGB lighting across all your iCUE-compatible products including water blocks, fans, keyboard, and more..
  • The integrated 330ml reservoir with an anti-vortex insert puts your custom cooling system’s coolant on display, with stunning angular design and an integrated fillport that makes filling, flushing, and topping-off coolant easy..
  • Included temperature sensor provides real-time coolant temperatures from inside your cooling loop when connected to a CORSAIR iCUE COMMANDER PRO or COMMANDER CORE (sold separately)..
  • Rubberized mounting system reduces pump vibrations and noise, so your custom cooling loop is seen, not heard..
Check Stock

WJB WU4124 Engine Water Pump Replace Airtex AW4124 USMW US4124 ASC WP-9354 Gates 43503 GMB 125-6030

  • Features corrosion resistant cast iron or aluminum body construction to provide extra strength and long lasting durability.
  • Engineered with precision to meet or exceed OE specifications, and pre-tested to ensure proper fitment and function.
  • Features uniform wall sections, smooth coolant flow cavities and passage ways which allow for efficient pump operation, optimum coolant circulation, and maximum cooling.
  • Simplified design that contains lubricated, permanently-sealed bearings along with unitized seals that never require maintenance, allowing for an extended service life.
  • All contact areas and mounting surfaces on the water pump housing are precisely machined to exact specifications to ensure a matched fit, proper sealing, and leak-free operation.
Check Stock

Diesel Water Parking Heater Hydronic Heater 5KW 12V Boat Caravan Motorhome Truck Camper Trailer Remote Control Diesel Water Heater Kit

  • PROTECT YOUR ENGINE ➤ The water heating type parking heater uses automobile coolant to exchange heat, preheats the engine and the cab, solves the problem of difficult engine startup at low temperature, greatly reduces air-cooled wear caused by low temperature startup, and extends engine life by more than 30%..
  • LESS FUEL PREHEATING ➤ Compared with cold-start engine preheating, the water heating parking heater preheating consumes less fuel. In the cold winter, you can warm up the engine and cab before getting on the car to drive away the severe cold. Improve the driving environment and no longer need a warm store..
  • FULL INSTALLATION SET ➤ 1 x Water Parking Heater, 1 x Auto Switch And Remote Control (Batteries Not Included), 1 x Water Pump, 1 x Wiring Harness, 1 x Tube, 1 x Oil Pump, 1 x Pump Holder, 1 x Fuel Filter, 1 x Oil Tube, 1 x Big Elbow, 1 x Small Elbow, 1 x Air Inlet Hose, 1 x Exhaust Pipe, 1 x Exhaust Silencer, 1 x Hose Holder, 1 x Cross, 1 x Air Filter, 6 x Short Pipe, 1 x Oil Extractor, 12 x Hose Clamps, 12 x Small Hose Clamp, 5 x Screwiv, 4 x Screw, 1 x Iron Stent..
  • TECHNICAL PARAMETERS ➤ Material: Metal &....
Check Stock

Thermaltake Pacific C360 Ddc Res/Pump 5V Motherboard Sync Copper Radiator PETG Hard Tube Water Cooling Kit CL-W243-CU12SW-A

  • Analog/digital lighting Analog lighting allows a selection of 7 lighting effects with the included a RGB Controller. Connect lights to select 5V RGB Capable motherboards TO utilize digital lighting schemes from as US aura Sync, Gigabyte RGB FUSION, MSI Mystic Light Sync, and ASROCK polychrome Sync.
  • All included the C360 hard tube Kit contains a CPU water block, pump/reservoir, radiator, fans, fittings, tubing, and coolant, which are components necessary to complete a CPU water cooling loop.
  • Slim copper radiator the C360 is engineered with 12 copper flat tubes and 17 fins per Inch. This radiator’s 27mm thick design assures fitment compatibility with most form Factor chassis.
  • C pro fittings build like a Pro with a new take on compression fittings. Engineered with four Built in O rings to provide maximum leak prevention and a secured compression seal.
  • Exclusive components W4 a RGB Edition water block, T1000 pure Clear Coolant, and a new pr15 ddc pump/reservoir combo.
Check Stock

Thermaltake Pacific C240 Ddc Res/Pump 5V Motherboard Sync Copper Radiator PETG Hard Tube Water Cooling Kit CL-W242-CU12SW-A

  • Analog/digital lighting – Analog lighting allows a selection of 7 lighting effects with the included a RGB Controller. Connect lights to select 5V RGB Capable motherboards TO utilize digital lighting schemes from as US aura Sync, Gigabyte RGB FUSION, MSI Mystic Light Sync, and ASROCK polychrome Sync.
  • All included – the C240 hard tube Kit contains a CPU water block, pump/reservoir, radiator, fans, fittings, tubing, and coolant, which are components necessary to complete a CPU water cooling loop.
  • Slim copper radiator – the C240 is engineered with 12 copper flat tubes and 17 fins per Inch. This radiator’s 27mm thick design assures fitment compatibility with most form Factor chassis.
  • C-pro fittings – build like a Pro with a new take on compression fittings. Engineered with four Built in O-rings to provide maximum leak prevention and a secured compression seal.
  • Exclusive components – W4 a RGB Edition water block, T1000 pure Clear Coolant, and a new pr15-ddc pump/reservoir combo.
Check Stock

Three Bond High Viscosity Fast-Set Liquid Gasket Maker TB1217H

  • Sets to form an elastic body which is not affected by vibration or impact.
  • Maintains a stable rubber body over an operating temperature range of -76°F to 482°F.
  • Highly resistant to engine oil, various chemicals and coolant.
  • Use on the water pump, oil pan, valve cover, engine head, fuel pump, thermostat housing, oil pump and intake manifold.
Check Stock

Coolant Vacuum Refill Tool Kit Engine Cooling System Vacuum Purge & Refill Kit New Coolant Bleeder Kit with 4 Rubber Sleeves & 1 Universal Adapter Cone Plug (with Carrying Case) (4 Connectors)

  • VACUUM TYPE COOLANT FILLING FUNCTION: Pneumatic vacuum coolant filler first sucks and forms a vacuum on the cooling system by using shop air, then draws coolant into the cooling system.(Need vacuum pump and not included in the kit) Add coolant in vacuum, there is no large air pocket and avoid warping or other damage in engine. Normally, it takes 5-10mins to refill the coolant, the exact time depends on the size of the tank. Easy to operate and save time.
  • WIDELY USAGE RADIATOR PURGE AND ANTIFREEZE REFILL TOOL: JIFETOR antifreeze filler kit includes a universal tapered rubber adapter, with MIN. diameter 1.5CM and MAX. diameter 5CM, fits for almost all types of vehicles. The adapter can replace the radiator cap to seal the cooling system, and connect with the quick coupler on coolant refiller to help to fill antifreeze..
  • WATER TANK COOLANT VACUUM REFILL: Plastic covered premium brass manifold body, equipped with brass fittings, anti-corrosion and durable. The index range of gauge is -30~0inHg (-76~0cmHg), and normally -25~-20inHg is right time to add coolant. 18" rubber resin material weave reinforced hose, featured with anti-corrosion, low fluid resistance, high bearing pressure, ensure durability and good air sealing. Also there is a 21" metal chain hoo....
Check Stock