BIGTREETECH TFT35 V3.0 Graphic Smart Display Controller Board for 3D Printer Ramps 1.4 RepRap 3D Printer Can Select Two Work Modes
- 1.Upgrade the firmware by SD card. It is easy and convenient to operate.This display board has higher compatibility. Users can select two work....
- 2.Serial port screen mode supports two printing modes: SD card and U disk..
- 3.Reserve WIFI port, and WIFI function is realized by external WIFI module.
- 4.Reserve the extension port of filament breaking detection (FIL-DET).
- Reserve the extension port of automatic shutdown after printing (PS-ON).
- 5.2 sets of UART serial port extension ports are reserved for DIY use..